equivalent inductance
Q: opic : Work, Power Energy Final answer should be in 2 decemal places thank you
A: Given circuit
Q: A 12-volt battery is connected to a series circuit in which the inductance is 1-henry and the…
A:
Q: A device which stores the electricity in the shape of electrostatic is Your answer
A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: Given the Figure No.3 above, solve for total current. 8.5 A O 10.4 A O 13.9 A 17.4 A
A: To find total current.
Q: If neither switch is closed, how can you tell whether there is a potential difference across any of…
A: In the question 2 switches are consist in the circuit. If neither switch is closed, how can you…
Q: 14. The resistance of the field coils of a dynamo is 173 Q at 16 deg C. After working for 6 hours on…
A: The solution is given below
Q: A,
A: Usually wire connected between bulb and battery to flow the current and make bulb on. the wire must…
Q: √==G Circuit 1 00 Circuit 2 In the circuits shown in the diagrams above, an uncharged capacitor is…
A:
Q: Question 3 (a) Describe the working principle of generating voltmeter technique for measuring high…
A: Voltmeters are used to measure the voltage and the ammeters are used to measure the current in an…
Q: WHEN CURRENT FLOWS THROUGH A RESISTOR, THE CURRENT WILL FLOW FROM NEGATIVE TO POSITIVE TERMINALS…
A: FALSE. When a current flows through a resistor, voltage will drop across it. That means voltage…
Q: 45. Find the value of RL in the figure shown necessary to obtain maximum power in RL. * 300 2 25 2…
A: by maximum power transfer theorem , maximum power to load occurs when load resistance is equal to…
Q: Hydroelectric Power Plants can only be put up in places with waterfalls. Select one: True False
A: Hydroelectric power plants,
Q: Question No.11. Which of the following best describe the arrow A shown in welding diagram below…
A: In the shown in the figure Best describe the arrow in welding diagram?
Q: Please show the
A:
Q: 1. Do the load voltages for the original and Thévenized circuits match for both loads? Is it logical…
A: “Since you have asked multiple question, we will solve the first question for you. If you want any…
Q: Q21 Fill in the following blanks (Answer 5 only) 1.Switches in terms of number of contacts and…
A: Power system transfers power from the source end to the load end. Protection of the power system is…
Q: The diagram below shows currents in a segment of an electric circuit. |7A 5A ЗА
A: In this question we will find ameeter reading...
Q: Which of the following circuits would yield the same measurements as the circuit shown in the video?
A: A voltage source(or voltmeter) is always a open circuit and a current source(or ammeter) is always…
Q: Please show 7 detailed Solution on this Part, and how it become That answer.
A:
Q: Write a story that reflects the graph. Break up the graph into 5 sections. Be as descriptive and…
A:
Q: For the circuit shown in Figure B2, when the switch opened at t=0 sec, 100 v = 3.3KN 10 mH Figure B2…
A: Given circuit,
Q: Protection
A: Answer Differentiate Phase Reversal Protection between Phase Failure Protection based on your own…
Q: Depending on voltmeter/ammeter terminal connection to the components, you might find different…
A: If we measure power by using voltmeter and ammeter across load we can easily say it absorbs power…
Q: Question 4 Consider the following sequential circuit. Determine its state table and state diagram. A…
A: The solution is given below
Q: Draw a schematic diagram for closed circuit
A: In this question , we will draw a schematic diagram for closed circuit....
Q: Given the series-parallel circuit below, calculate for the current and potential difference across…
A: Given :
Q: Which of the following answers most appropriately represents the voltage source current (i1 (t) i1…
A: The best method to figure out the appropriate option is to use the steady state condition . Because…
Q: Do
A: Circuit is given as,
Q: Answer the follwing. Modified true or false. Write True if the statement is true. If not, write…
A:
Q: Draw a series-parallel connection in DC using three lamps and two switches in the Schematic Diagram,…
A: Schematic Diagram: A schematic, is also known as schematic diagram. It is a depiction of the…
Q: Why it is preferable to connect bulbs in parallel rather than series? Explain your answer.
A: here they are asked about why the bulbs are connected in parallel rather than series ? first we have…
Q: 18/ Conventional Energy Sources are those Energy Sources that cannot be recovered anymore after…
A: Given Conventional Energy Sources are those Energy Sources that cannot be recovered anymore after…
Q: Which of the following statements regarding circuits are true? To find resistance in a parallel…
A: False, To find the resistance in a parallel circuit, you must sum the inverse of the individual…
Q: teach me all about electricity chapter with full explanation and concept
A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…
Q: The current through a short circuit is infinity (ideally). (TRUE OR FALSE)
A: From ohm's law:- V=IR I=V/R For short circuit condition, R=
Q: t?
A: From the figure the battery voltage can't be identified but evidently from the voltage reading of…
Q: What are the reasons for hotspot and cracks in solar panel. please solve step by step
A: In the face of expensive and rapidly diminishing energy sources, solar panels and their components…
Q: Determine vah in the circuit below.
A:
Q: What are the expected voltages at points C and D of this circuit?
A: In This 12 volt is passes through the fuse, switch, and 2 loads (which are 10ohm(each) bulb)
Q: Considered as emergency sources of power in airplanes. Choose all the correct answers.
A: The explanation is as follows.
Q: what can you conclude when we sum up the voltages across a loop/branch? What value is it equal to?
A: Given: Brief description: From the above circuit diagram we can easily say that , in the circuit we…
Q: Chapter-18: Superposition and Standing Waves
A: Given info: The two waves are travelling with the wavelength is 3.00 m in the same direction at…
Q: 2- How to make the duty cycle approach to 50%? 3. Dacian
A: “Since you have asked multiple question, we will solve the first question for you. If you want any…
Q: Write Kirchhoff's law for current according to the following diagram? 13
A: For the above given circuit it can be solved using either of the circuit theory rules mentioned…
Q: Make a figure/schematic symbol/drawing of this 2 problem given below (Parallel method: includes…
A: Bulb 1, 2 and 3 controlled by switch 1 in a parallel connection, Bulb 4 controlled by switch 2 in…
Q: What will be the sign convention of the voltage if the current passes through the negative terminal…
A: Sign convention of the voltage source:
Q: For the circuit shown in figure 4 Calculate the value of ITotal & IC1
A: In this question, We need determine the total current and current in the capacitor C1. We are…
Find equivalent inductance at the terminals a and b of the circuit below.
*Round off the final answer to the nearest 4 decimal places with unit. Rounding off should only be done on final answer.
Step by step
Solved in 2 steps with 2 images
- A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
- An R-L series circuit contains two resistors and two inductors. The resistors dissipate powers of 96 watts and 125 watts. The inductors have reactive powers of 100 VARs and 78 VARs. What is the power factor?Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.Find IA, IB, IC, V1kohms, V5.1kohms, and V2kohms
- Given the following Resistances and Capacitors in Series and Voltage Source: R1 = 6.946 ohms R2 = 9 485 ohms C1 - 0.731 Farad C2 - 0.925 Farad Vs - 15 Volts Frequency = 168 Hz What is the Capacitive Reactance of C1?Given the following Resistances and Capacitors in Series and Voltage Source: R1 - 7 ohms R2 = 4 ohms C1 = 0.157 Farad C2 = 0.01 Farad Vs = 10,382 Volts Frequency = 86 Hz What is the Amplitude of the voltage across C1?Find the voltage Ra=15kΩ Rb=68kΩVo= 87mV V1 in mV. Find V1 in mV
- Three capacitors are connected in parallel and have the following voltage ratings: C1 = 32 uF with 80 V, C2 = 65 uF with 220 V, and C3= 105 uF with 120V. Determine the total charge that C2 can hold. 14.3 C 78 C 14300 uC 7800 uCCircuits 1 HW 4 Q836 - Since a =5i ̂-2j ̂+3k ̂ and b =2i ̂-j ̂-3k ̂, what is the result of (a +b )? A) 4 B) -1 C) 4i ̂+3j ̂+2k ̂ D) 7i ̂-3j ̂ E) 3i ̂ + 2j ̂-3k ̂