Evaporator in absorption cooling system changes into vapors at low pressure? O i. Refrigerant O ii. High Pressure liquid iii. Hot Water O iv. Cold Water

Q: Explain any four dynamic characteristics of   measurement system

A: Every instrument is sensitive towards some factors like heat, pressure, resistance etc. due to these…

Q: Explain the operation of thermochemical energy storage system.

A: Thermochemical energy storage systems are basically the energy stored from the sun in the form of…

Q: * Problems of using standard ICs are amount of circuit board space, a great deal of time and cost in…

A: Given: problems of using standard ICs

Q: 4 Explain the operation of thermochemical energy storage system.

A: Thermochemical energy storage systems are basically the energy stored from the sun in the form of…

Q: Among the main causes of electrical failure involves Electro-Static-Discharge (ESD). Please…

A: Since there are 4 different questions (a), (b), (c) and (d), as per the guidelines, in the following…

Q: Explain briefly how will you give Combined Leakage and Overload Protection

A: Normally for leakage protection earth fault relay is used and for overload protection overload relay…

Q: Check the correct statements.

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: Answer the following briefly. 1- Describe control objectives for a process control.

A: Since you have asked multiple question ,we will slove the first question for you .If you want any…

Q: Control Systems

A: According to question: The phase cross over frequency is calculated as

Q: ckt diagram of refrigerator

A: In refrigerator, split single phase induction motor is used to run the compressor unit. Compressor…

Q: Write an Arduino based code to take input from two switches, if switch one is pressed than glow full…

A: The input is taken from two switches  On pressing switch one, the full spectrum on RGB Led.  On…

Q: Which of the following is not a type of energy requiring lockout or tagout procedures

A: Which of the following is not a type of energy requiring lockout or tagout procedure?

Q: Explain any four dynamic characteristics of measurement system.

A: The explanation is as follows.

Q: Draw the block diagram of a Pressure measurement system .Also identify the names of the  functional…

A: The block diagram of a Pressure measurement system is as follows:

Q: .Describe the working of a hydraulic circuit which is used for absorption of sudden pressure rise…

A: Hydraulic systems use the pump to push hydraulic fluid through the system to create fluid power. The…

Q: Write a brief report from your personal expression for this scheme: - COMPARATOR RELAY TO CONTROL…

A: Given

Q: Explain with a neat block diagram the measurement of temperature using RTD (measuring system).

A: Resistance Thermometers (RTD) Also known as resistance temperature detector And used for…

Q: are the main region 3 what enside System verilog simulation in time step?

A: Verilog is Hardware Description language . The memory and array declaration in Verilog is static in…

Q: OPEN Vpeak

A: We have to type the image in computer.

Q: Explain with a neat block diagram the measurement of displacement using RTD (measuring system).

A: Thermistor is a special type of Resistor whose resistance changes with the change in temperature.…

Q: 3) a good measurement technician can substantially reduce errors at the output of a measurement…

A: 1) Environment affects the quality of measurement and users always have to take precautionary…

Q: Define noise in communication systems and mention the different types Note: Please do not…

A: Noise is an unwanted signal which interferes with the original message signal and corrupts the…

Q: Make a diagram , and explain the construction, working principle and the applications of Magnetic…

A: to make a diagram , and explain the construction, working principle and the applications of Magnetic…

Q: Draw the block diagram of a Displacement measurement system .Also identify the names of the…

A:

Q: A process yields 10% defective items. For testing purposes, 100 items are randomly selected from the…

A: Solution: Let X denotes the number of defectives. The size of the selected sample is n = 100. The…

Q: Explain the principle of working and operation of Ultrasonic Inspection with neat diagram.

A:

Q: Draw the block diagram of a Temperature measurement system .Also identify the names of the…

A: Temperature Measurement System - The temperature measurement system is a device that is used to…

Q: Explain the working of Capacitive Level sensor with a neat diagram.

A: A capacitive fluid level sensor is an instrument for estimating the stature of a fluid and changing…

Q: please write about Small water pump on smart plant irrigation system.

A:

Q: Which 1 below is NOT PLC's configuration types Modular Unitary O Rack mounted Automation O

A: Asked that which one below is NOT PLCs configuration types

Q: Explain why the risk of electric shock is greater with a.c. portable appliances than with fixed…

A: Electricity hazard is the most dangerous one as it do not provide advance warning od danger. Dealing…

Q: Non contact type temperature sensors are operating under the principle of conduction. Select one: O…

A: Conduction is the principle of heat transfer which can be used for temperature measurement.…

Q: Mention the steps in treating an Unconscious Person who received LV Electric shock. (Please write by…

A: LV Electric shock  It means if a person comes into touch with a source of low voltage power supply…

Q: List the name of some Initiator & Emulsifier

A: Initiators are used in reactions in order to trigger the chain reaction.  Emulsifier is usually…

Q: Music can be sampled without permission of the licensor in cases of hip-hop songs True or False?

A: No, we can't sample music without permission, no matter how short or long or which type of cases of…

Q: In a second-order linear process control system the pressure value changes from 0 to 50 PSI values…

A: Given %Mp =10 % ts =4 sec to find Pmax Final value of pressure =50 PSI

Q: What should be the k interval for the system to be stable

A:

Q: incubator working principle

A: Incubator :  It's an electronic device which grow and maintain cell culture .

Q: 4. Explain the operation of thermochemical energy storage system.

A: Thermal energy storage (TES) is an advanced method to store thermal energy and facilitate more…

Q: IDPS Terminology Discuss the following IDPS terminology: Alarm clustering and compaction Alarm…

A: Alarm clustering and compaction : The intention of alarm clustering is to address the basic alarms…

Q: When compliance. you are required to complete an assessment of safety and environmenta Hiring…

A: Safety: The condition of being protected from unfamiliar and unlikely danger, risk and injury.…

Q: If no other measurements detect a problem during service-interrupting maintenance, what step should…

A: BER(Bit Error Rate) Test:  The number of received bits in a data stream through a communication…

Q: control systems

A:

Q: 1. Determine the state table and state flow diagram for the following ckt. JA В KA Ka B' clock

A: "According to the company's policies, we will solve only the first part of the question since the…

Q: Following error

A:

Q: Q3. A manufacturing plant producing pressurised oxygen canisters uses 3 ultrasonic detectors to…

A:

Q: What is the most important load in a refrigeration system

A: Motors are one of the main loads in a refrigeration system. So, the power drawn by the refrigeration…

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.