Ex (3):- A signal that has the highest frequency component of 4.2MHZ and a peak to peak value of 4 volts is transmitted using a binary PCM. The number of quantization levels is 512 and P=0.04W calculate: 1. Code word length. 2. Bite rate.

Q: Find V in Fig. 10.55 if the box contains (a) 3 2 in series with 2 mH; (b) 3 2 in series with 125 µF;...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: Part A Consider the circuit shown in the figure. A Q-point value for Ic between a minimum of 4 mA an...

A: The solution is given below

Q: 1. Determine the output voltage for the circuit for each input voltage in (b). (c), and (d). The cir...

A:

Q: The result of e = O a. -1 O b j O c. j Od 1

A:

Q: A full-wave rectifier uses two diodes. The transformer r.m.s. secondary voltage from the center tap ...

A: The solution is given below 

Q: 43. Calculate the equivalent impedance seen at the open terminals of the network shown in Fig. 10.56...

A: The solution is given below 

Q: From the following figure, find the voltages at each of the nodes, A, B, C, D, E and F. Assume,  Vdd...

A:

Q: Q12: Determine the current Vo of the figure below using the approximate equivalent model for the dio...

A:

Q: find I cpawer n 1A

A: Given circuit:

Q: Electrical Engineering For some 4-point input sequence, the result after the first FFT butterfly sta...

A:

Q: Consider tne following :2( 312 32 -ww ww ww 6 12 6 V What is the value of the current I in the above...

A:

Q: What is the equation of half adder with inputs X, Y, Z (carry in) and outputs C carry out using a NA...

A: We meed to find out carry for adder .

Q: Determine the meter readings in Figure Vcc +8 V R 33 kN Rc 2.2 kN BDC 200 R2 10 kN RE 1.0 kN Section...

A:

Q: Q. Find the Fourier Series od (x) =x -くx<受

A:

Q: 2. A full wave rectifier is using a center tapped step down transformer. The input to the primary of...

A:

Q: Show explicitly that the surface charge density is given by = o0 [(s/d)2 + 1]3/2 where o0 = – q 2nd2...

A: According to electromagnetism, charge density is defined as a measure of electrical charge per unit ...

Q: What is the DC Gain in dB measured from the cursor below? What is cutoff frequency measured from the...

A:

Q: An armature has a resistance of 0.2 ohm at 15 degrees Celsius and the armature copper loss is to be ...

A:

Q: 27 for fC ), 13 Obtain Fourier series of period where $lx): -下Y(6 ニ oく*く下

A:

Q: Vc R1 RC Q1 NPN +88 8 R2 RE Volts VC

A:

Q: -- Design half subtractor circuit using NOR gates only.

A: The solution is given below

Q: Find I, in the network in the figure. 7 mA 2 mA +1

A: Given circuit:  

Q: The below signal is: 2. 1.5 0.5 -0.5 -5 -4 -3 -2 -10 1 2 34 5 6 7 89 10 11 12 13 14 15 16 17 18 19 2...

A:

Q: 1 kS2 t=0 1 kN 2 kN + 20 V ( 10 μF 2 k2 '1 k2

A:

Q: Find the currents and voltages in the circuit iz -ww- 30 V 3Ω ww-

A:

Q: An IGBT switch has a 10 ohms resistive load a

A:

Q: VCC R1

A:

Q: Design a highpass filter with a high-frequency gain of 5 and a corner frequency of 2 kHz. Use a 0.1 ...

A: The solution is given below 

Q: The total flux per pole in the air-gap of a 50-Hz alternator is 0.06 Wb. The flux-density distributi...

A:

Q: Consider an LTI system with impulse response sin(2(t – 1)) h(t) t – 1 Determine the output for each ...

A:

Q: Define the Signum function.

A:

Q: Q4/ For the figure below, all dimensions in inch. A/The total Area : y 3 1.5 2.5 2.5 2.5 2.5 13.68 1...

A: We need to find out area for given geometry

Q: E(S) Y(S) H(S) Gp(s) M(S) where the switch represents a sampler with a T period and H(s) is a latch ...

A:

Q: 1. For a common base amplifier circuit (NPN), Given the following parameters: Re=1.5kohm, Rc=1kohm a...

A:

Q: Three unequal single-phase loads are connected across the lines of a balanced, 3-phase, 230 volts (l...

A:

Q: 4. Derive the logic function for the following circuit diagram у —

A: Given: Logic circuit  

Q: ii) Assume a three phase induction motor is connected to a three phase system and the shaft is coupl...

A:

Q: A certain battery with potential difference of 2 Volts can deliver 10 Joules of energy, determine th...

A:

Q: H.W Write the equation for ØAM (t), Øfm(t) and ØPM (t), if the modulating signal is; 1-f(t) : = 2cos...

A:

Q: Given the Parallel RLC circuit below, Find the transfer function H(s) = Vo(s) / I(s)

A:

Q: * In causal systems: O a. There is no input till the output is applied to the system. b. Non of the ...

A:

Q: 41. Exchange the capacitor and inductor in the network shown in Fig. 10.54, and calculate the equiva...

A:

Q: Example: Determine the amplitude, frequency and phase difference between the two waveforms illustrat...

A: The required parameters from the CRO waveform display can be calculated by considering the number of...

Q: The below signal is: 2.5 0.5 -0.5 -1 5 4 -3 -2 -1 0 1 2 3 45 6 78 9 10 11 12 13 14 15 16 17 18 19 20...

A: Option C  Is correct  Since the signal has amplitude of 2 at n=6 So n delayed by 6 units  So (n-6) A...

Q: Q1) A full-wave rectifier uses two diodes. The transformer r.m.s. secondary voltage from the center ...

A: In this question,  Full wave rectifier uses two diodes.  The rms value of secondary voltage from the...

Q: 5 Find the inverse Laplace transform of the given function: F (s) %3D 5s-46 f (t) = %3D

A: In this answer we will find the inverse Laplace transform as explained below using the standard form...

Q: Design process is non cyclical. Select one: O True O False

A: The solution is given below 

Q: A given ad hoc network consists of 100 nodes, and the nodes' mobility is such that two current radio...

A: It is given that: Nodes=100 Two links are broken and Two new links are established every second, 

Q: Which of the following relay is also called directional restrained over current relay: (a) Mho Relay...

A: The types of directional relays are, MHO or admittance relay Impedance relay Reactance relay

Q: 01) A full-wave rectifier uses two diodes. The transformer r.m.s. secondary voltage from the center ...

A: As per guidelines given, we can provide the solution of first three subpart in multi part question. ...