Examine the output of the 8 bit DAC converter whose output range is 0 to first two digits of VTU number Volts and whose input binary numbers is (i) 10111100 (ii) 10111101 (iii) 10111111(iv) 11111100 and calculate its LSB,MSB and full scale output.

Q: Consider a 12-bit ADC with a reference voltage of 3.3 V operating in single-ended mode. If it…

A:

Q: 1.With a neat diagram ,explain about the working of 3 bit binary weighted type DAC.

A: we need to explain the working of 3 bit binary weighted type DAC.

Q: (II) Consider a rather coarse 4-bit analog-to-digital conversion where the maximum voltage is 5.0 V.…

A: Given: Voltage= 5.0 V.

Q: Examine the output of the 8 bit DAC converter whose output range is 0 to 12 Volts and whose input…

A: A digital-to-analog converter (DAC, D/A, D2A, or D-to-A) is a system that converts a digital signal…

Q: 5. Pass Transistors: Pass transistors are used as a switch to pass logic levels between nodes of a…

A: Given figure is shown below. Given transistor is PMOS pass transistors. Given Vss=0V. Thus all PMOS…

Q: Digital Electronics and Design Question a) Find the output of the gate circuit shown in the figure…

A: For the following question we have to implement the cmos circuit of function F amd also minimize it

Q: 5. What is the function of the digital circuit shown below? Describe its operation briefly and find…

A:

Q: Define BPSK.  How do we represent binary signals in BPSK?

A:

Q: (d) Draw the folowing Boolean expression using CMOS transistors. (i) Y = AD + AE + BC. (ii) Y = ACD…

A:

Q: After execution the instruction: CMP AL, AH; the status flags will be: AF=1, CF=0, OF=1, PF=1, SF=O…

A:

Q: carry_out B. VDD C sum B C.

A: We need to find out expression of sum and c out .

Q: 1. Provide a block diagram and a function table for the NOR-Gate Latch. 2. Describe, with the aid of…

A:

Q: What is the 8288 bus controller's primary purpose in 8086/8088 maximum mode?

A: The maximum mode is used connect more than one processer when required.

Q: Give the value of the 8088 reset vector

A: The RESET input of the 8088 microprocessors provides a hardware means for initializing the…

Q: Implement the following functions using dynamic CMOS logic. Further, comment on the number of…

A:

Q: Q. How the serial communication is performed in 8086 and draw and explain each block of internal…

A: In serial communication one bit is transferred at a time. Serial communication of 8086 is…

Q: Q2) B) Use the SAR ADC to convert the analog voltage of (7.28 V) to 8-bit binary. If (VREF = 10V),…

A: Given, Analog input voltage Vin=7.28 V Reference voltage Vref=10 V

Q: In the FPGA design flow, Timing based simulation occurs before synthesis Select one: O True O False

A: Given   A true or false question based on FPGA design flow. Please find the answer below with…

Q: Explain: Description of GPIB instrument interface

A: Solution: The GPIB or IEEE 488 transport is a truly adaptable framework, permitting information to…

Q: Draw the circuit schematic for a three-input CML XOR gate.

A: Given: The three-input CML XOR gate circuit diagram is shown as:

Q: Write an HDL gate-level description of the circuit shown in

A: Logic gate:- Logic gates are the device of the digital system. AND gate, OR gate, and NOT gate are…

Q: exponent and, 7-bit mantissa is placed in 1 pit register as shown below. E (4) Which of the…

A:

Q: Determine the binary code output of the 3-bit flash ADC for the input signal in Figure below and the…

A: Given Vref =8V n=3 bits Number of levels L=2n =23 =8 So we assign a quantization level in between…

Q: a) Find the logic function ‘F’ realized by the CMOS circuit below. b) Complete the missing logic…

A:

Q: Design an interfacing circuit for ADC 0804 and 8051 microcontroller with self-clocking. Also explain…

A:

Q: (b) Briefly explain the key principle behind the Successive Approximation Convertor in how it goes…

A: Principle and working of SAR type ADC 1) SAR is one of the most widely used types of ADC. Here bits…

Q: VDD M5 MB to othe trarsist M3 M4 M1 M2 RBit ther com Figure 11.4 a CMOS current reference circuit.

A: Cascade current mirror In cascode pair, common emitter stage feeds into the common base Current…

Q: -Discuss 5 differences between standard microprocessors and microcontrollers -Describe the RISC…

A: There is a total of three questions related to microcontrollers and microprocessors. The first…

Q: A certain NMOS transistor has the characteristics shown in Figure P11.42. Graphically determine the…

A: From the given graph, The value of the current iD for vGS=3 V is, iD=6.4 mA The value of the current…

Q: Given a 5-bit ADC with the following reference values Vref= -2V and 12V, what is the voltage…

A: The solution is given below.

Q: If Vin exceeded Vref in a real ADC IC, would it actually damage the IC? If not, what would the…

A:

Q: Q2) Derive the NOT gate and then sketch the MUX equivalen?

A:

Q: 5: Draw the V-A output characteristics of nMOS tra

A:

Q: Approximae resolution of 6-bit DAC?

A: Given: For DAC (Digital to Analog Converter) number of bits n=6

Q: Determine the High-level and Low-level noise margins for both type of CMOS by using the information…

A: low level noise margin , NML  = VIL-VOL low level noise margin , NMH  =VOH-VIH

Q: Q7//Design 4-bit binary to gray conversion using read only memory.

A:

Q: How can I implement 4035 ic as a parallel input and serial output?

A: For implementation of 4035 IC as a parallel inputs we have to use pin number 9, 10, 11, 12 or Pin…

Q: b) How are the two levels of the clock defined in clocked CMOS ckt? Draw the circuit of Clocked CMOS…

A: According to the question, we need to discuss the two levels of the clock defined in the clocked…

Q: Electrical Engineering some applications that benefit greatly from CMOS based amplification

A: BJT Based technology power consumption is more as compared to CMOS based technology  BJT based…

Q: 1. Explain the A/D & D/A converter with necessary diagram.

A: NOTE :- We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: Design a system called a parallel binary comparator, that compares the 4 – bit binary string A to…

A: Design a system called a parallel binary comparator, that compares the 4 – bit binary string A to…

Q: How could a binary-weighted DAC operate with BCD input? Explain.

A:

Q: Examine the output of the 8 bit DAC converter whose output range is 0 to 12 Volts and whose input…

A: What is a Digital-to-Analog Converter? A Digital to Analog Converter commonly referred as DAC, D/A…

Q: Draw the circuit schematic for a two-input NMOS CML XOR gate.

A: Below is the figure that shows schematic circuit of 2-input NMOS CML XOR gate:

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.