Answered: Example 12.36. A capacitor of…

Example 12.36. A capacitor of capacitance 10 µF has a loss angle of 10° at 50 Hz. Find (i) power factor angle (ii) power factor.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.27P: An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8...

See similar textbooks

Related questions

Q: The reverse recovery time of diode is trr = 3 s and the rate off all of the diode current is di/dt =…

A: Given, Reverse recovery time of diode, trr=3 s. The rate off all of the diode current, didt=30 As.

Q: If V = x - y + xy + 2z V, find E at (1, 2, 3) and the electrostatic energy stored in a cube of side…

A: The electric field intensity is the gradient of V so the required parameters can be calculated by…

Q: A coil takes a current of 2A from a 12V d.c. supply. When connected to a 240V, 50 Hz supply the…

A: Given,Current, IDC=2 AVoltage, VDC=12 VandVoltage, VAC=240 VFrequency, f=50 HzCurrent, IAC=20 A

Q: Q/ Design a Triangular wave generator of amplitude 4V, and frequency 25KHz. (Take R3=2.5Kohm) ?

A: Solution: The basic idea behind designing of Triangular wave generator is to connect an Integrator…

Q: Calculate the noise current for a diode W/a bias current of 5mA observed over 75Khz bandwidth. also…

A: According to the question, we need to calculate the noise current for a diode with a bias current of…

Q: A pulse waveform with a frequency of 20 kHz is applied to the input of a counter. During 40 m how…

A: Given a pulse waveform with, Frequency, f = 20 kHz. It is applied to the input of a counter during…

Q: Find the power factor and apparent power v(t)=160 cos (377 t+10 grados) Onios Cuando se aplica un…

Q: Q3: An overhead transmission line conductor having two un sage level towers, the height of taller…

Q: What is an integrated circuit defined as?

Q: Six equal resistorseach of 10 ohms are connected to form a wye inside a delta. What is the…

Q: 15.How do we derive a T-FF on a JK-FF?

Q: Example 12.36. A capacitor of capacitance 10 µF has a loss angle of 10° at 50 Hz. Find (i) power…

A: Given: C= 10μfδ = 10∘f = 50 Hz Find: Power Factor Angle(φc)Power Factor cosφc

Q: Given the following nodes from A to G as shown in the diagram, determine the minimum spanning tree…

A: The minimum spanning tree is a subgraph that contains all the given vertices and there should not be…

Q: What is the impedance of the circuit? + V₂ 317V 1.5 kHz R₁10 kn ₁0.01 μF -00000² 3 H

A: Solution !! The impedance z=""R^2+(Xl-Xc)^2.R=10000ohms,Xl=2πfl=2*3.142*1500*3=28278ohms.

Q: If the no load secondary voltage of a 1-phase transformer is 235 V and full load secondary voltage…

A: Given: A single phase transformer has, The no load secondary voltage, V2nl=235 V. The full load…

Q: inverse Laplace

A: It is given that: F=L-162s-8-3-2s9s2-16+8+6s4s2+9

Q: Given the following nodes from A to G as shown in the diagram, determine the shortest path network…

Q: Circle the right answer(s) The most important advantages of renewable energy sources compared to…

A: In this question, We need to choose rhe correct options In this question, we are discussing about…

Q: Which of the below statements is NOT True regarding Tidal Power? The primary source for Tidal Power…

A: Given: Tidal Energy

Q: Find the power factor and apparent power unla cun v(t)=160 cos (377 t+10 grados) nos cuando se le…

Q: When anode is negative as compared to cathode, diode is biased.

A: A diode can be biased into two ways Forward biased Reverse biased

Q: 2. Refer to the electric circuit on the right. a) Find a matrix equation Ai= b, where i = (1, 12,…

Q: The potential at the terminals of the battery falls from 9 V on open circuit to 6 volts when a…

A: Use voltage division rule to find internal resistance of the battery. If two resistors R1 and R2…

Q: A star-connected, 3-phase, 10-MVA, 6.6 kV alternator has a per phase reactance of 15%. It is…

A: Given: Star connected, 3 phase, 10MVA, 6.6kV alternator, per phase reactance=15%

Q: Q3/B/By using Laplace Transform, determine off)on the capacitor in the circuit that is shown in…

Q: Calculate the p.d. developed across a 7500 resistor when the current flowing through it is (a) 3 A,…

A: It is given that: R=750 Ω

Q: A DC generator feeds a load of current 20 A and voltage 220 V. Calculate the electrical motive force…

A: Load current IL= 20 A Load Voltage VL = 220 V Resistance of armature Ra= 0.02 Resistance of field…

Q: Problem: Anso Point charge free space. at PC-213,-1), if you given (a) V=O at (61514) (b) v=o at…

Q: 3. Determine V, and I. 40V(+ 82 M Io M 202 50 W + Vo -+ 18V M 652 400

Q: Electrical Parameter (Complex Number) T = 10 [cos (2¹) + j sin (2¹)]A Rectangular Polar Form Form…

Q: 2. Determine I, and I, using current division. 80V (+ 1252 M 82 M Ix W 105 452 W 18225 If fy 200

A: Given circuit,

Q: Question 1 a. Derive the following speed equations: i. ii. ω V. Kφ @ = V. Kφ ΚΦ Ria Ta Kφ Κφ R₁ Kφ…

Q: In a 3-phase power measurement using two wattmeter method, if one wattmeter reads 2.5 times the…

A: Given: In a 3-phase power measurement using two wattmeter method, One wattmeter reads 2.5 times the…

Q: Question- Find the maximum power delivered by 1500 kW, 3-phase, star-connected, 4 kV, 48 pole, 50 Hz…

A: Given- Power- PL=1500 kW=1500×103 W,V=4 kV=4×103 V, Power factor- cosϕ=1, Synchronous reactance-…

Q: 6. If the total resistance is 4.950, find R. 252 M 100v + 3422 R N M 52 W 6.2 W 762

Q: The BJTs in the two circuits have ß-100 and [VBE| = 0.7 V. Determine the following (i) type of BJT,…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Determine the transfer function of the system shown G₁ H₁ GA H₂ G3 G₂

A: Given,

Q: At 50Hz operation, a single phase transformer has hysterestic loss of 200 W, and Eddy current loss…

A: Given- Frequency f=50 Hz, Hysteretic loss ph= 200 W, Eddy current loss Pe= 100 W. To Find- The core…

Q: it is a logic circuit that is known for being time

A: In this question we will write about logic circuit which are time independent.... Note :-as per…

Q: 1. Draw the equivalent circuit and the model in AC mode. 2. Specify the type of transistor and the…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive…

Q: 6. Vin C₁ HE 0.0022 μF 4 mH 4 -00000- R₁ 150 22 Vout What is the bandwidth in the given circuit. If…

A: In this question, We need to determine the bandwidth of the Given circuit. We know bandwidth of…

Q: V dc A F R1 1K I Total 12V B R3 4K 11 R4 2K E 12 R2 6K R.5 -3K- C D

A: We need to find out voltage for given circuit across different node .

Q: (coso) (47) find the Power factor of the following ckf.

A: It is given that:

Q: Find the power factor and apparent power

A: It is given that: vt=160cos377t+100 V V=160∠100 V Z=60+j40 Ω

Q: DC series motor has an armature resistance of 0.060 and a series field resistance of 0.080. The…

Q: An 8085 assembly language program is given below. Line 1: MVI A, B5H 2: MVI B, OEH 3: XRI 69H 4: ADD…

A: Solution !!

Q: 9 A small business operates three pieces of equipment for nine hours continuously per day for six…

Q: In a semiconductor crystal, the atoms are held together by O a. covalent bonding b. interaction of…

Q: Consider the circuit shown in fig.1 and determine whether or not the bridge is in complete balance.…

Concept explainers

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.

Question

Example 12.36. A capacitor of capacitance 10 µF has a loss angle of 10° at 50 Hz. Find (i)
power factor angle (ii) power factor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Compensation Techniques in Transmission Line

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A cable has inductance of 0.22 mH per km and capacitance of 0.202 microF per km. The surge impedance of the cable is ?
The resistance and inductance of a coil can be obtained by connecting the coil in series with a known resistance R and measuring the coil voltage Vcoil, the resistor voltage VR and the total voltage V. The frequency must also be known, but the phase angles of the voltages are not known. Given that f = 60Hz , R = 10 ohm Vcoil = 22.4 V. VR = 20 V and v = 36v , find the resistance and inductance of the coil.
A series circuit of RLC with following parameters, R=15 ohm, L=20 m H & C=100 micro Farad. VT=169.7 sin (337t-30) Volt. Find the following: Zt, , It, Voltage across each element, Power factor, apparent power, real or average power and reactive power and the total phasor diagram and power phasor diagram
The total impedance Z, of a circuit containung an inductor with inductance L and resistance R in series is given by Z  R  j2fL where f  frequency . If Z  (50  j200)ohm and f = 50Hz. Find R and L
Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of the load impedance Z=ZZ, find expressions for P and Q, from complex power considerations. (b) Express p(t) in terms of P and Q, by choosing i(t)=2Icost. (c) For the case of Z=R+jL+1/jC, interpret the result of part (b) in terms of P,QL, and Qc. In particular, if 2LC=1, when the inductive and capacitive reactances cancel, comment on what happens.
An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8 lagging from a 220-V,60-Hz, single-phase source. By placing a bank of capacitors in parallel with the load, the resultant power factor is to be raised to 0.95 lagging. Find the net capacitance of the capacitor bank in F that is required.
A certain industrial load has an impedance of 0.6 angle 30 ohms at a frequency of 60 Hz. What capacitorconnected in parallel with this load causes the angle of the total impedance to decrease to 15º ? Also if the load voltage is 120 V, what is the decrease in line current produced by adding the capacitor ?
Obtain the overall impedance for the following cases a. P = 1500 W, Q = 2000 VAR (inductive), ???? = 12 ? b. ? = 4500∠60° ??,? = 120∠45° ?
If the normalized admittance visible at a distance d from the load impedance is 1 - j5, how many mho should the input admittance of the parallel side line that must be connected to the 50 ohm transmission line at position d be? (mho = 1/ohm)
Evaluate the following twiddle factor: W48
The resistance and inductance of a coil can be obtained by connecting the coil in series with a known resistance R and measuring the coil voltage Vcoil, the resistor voltage Vr and the total voltage V. The frequency must also be known, but the phase angles of the voltages are not known. Given that f = 60 Hz, R = 10 ohms, Vcoil = 22.4 V, Vr = 20 V and V = 36V. Calculate Xl and Xc
The line with symmetrical spacing then the equilateral spacing (Deq) for the three-phase inductance calculation is D12=D23=D31=D. Select one: True False