Example 15.6: Page 687 A transformer on a utility pole steps the rms voltage down from 12 kV to 240 V. (a) What is the ratio of the number of secondary turns to the number of primary turns? (b) If the input current to the transformer is 2.0 A, what is the output current? (c) Determine the power loss in the transmission line if the total resistance of the transmission line is 200 Q.

Example 15.6: Page 687 A transformer on a utility pole steps the rms voltage down from 12 kV to 240 V. (a) What is the ratio of the number of secondary turns to the number of primary turns? (b) If the input current to the transformer is 2.0 A, what is the output current? (c) Determine the power loss in the transmission line if the total resistance of the transmission line is 200 Q.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 71PE: A large superconducting magnet, used for magnetic resonance imaging, has a 50.0 H inductance. It you...

See similar textbooks

Similar questions

To receive AM radio, you want an RLC circuit that can be made to resonate at any frequency between 500 and 1650 kHz. This is accomplished with a fixed 1.00 (H inductor connected to a variable capacitor. What range of capacitance is needed?
How would you place two identical flat coils in contact so that they had the greatest mutual inductance? The least?
What inductance do you need to produce a resonant frequency of 60.0 Hz, when using a 2.00 F capacitor?
What capacitance do you need to produce a resonant frequency of 1.00 GHz, when using an 8.00 nH inductor?
Suppose you have a supply of inductors ranging from 1.00 nH to 10.0 H, and registers ranging from 0.100 (to 1.00 M What is the range of characteristic RL time constants you can produce by connecting a single resistor to a single inductor?
A large superconducting magnet, used for magnetic resonance imaging, has a 50.0 H inductance. It you want current through it to be adjustable with a 1.00 s characteristic time constant, what is the minimum resistance of system?
What is the resonant frequency of a 0.500 mH inductor connected to a 40.0 (F capacitor?
Construct Your Own Problem Consider a double transformer to be used to create very large voltages. The device consists of two stages. The first is a transformer that produces a much larger output voltage than its input. The Output of the first transformer is used as input to a second transformer that further increases the voltage. Construct a problem in which you calculate the output voltage of the final stage based on the input voltage of the first Stage and the number of turns or loops in bath parts of both transformers (four coils in all). Also calculate the maximum output current of the final stage based on the input current. Discuss the possibility of power losses in the devices and the effect on the output current and power.
Show that if a coil rotates at an angular velocity (, the period of its AC output is 2(/(.
What is the peak power consumption of a 12G-V AC microwave over that draws 10.0A?
A 10.0- resistor, 10.0-mH inductor, and 100-F capacitor are connected in series to a 50.0-V (rms) source having variable frequency. If the operating frequency is twice the resonance frequency, find the energy delivered to the circuit during one period.
An LC circuit consists of a 3.00 mH inductor and a 5.00 (F capacitor. (a) Find its impedance at 60.00 Hz and 10.0 kHz. (b) Compare these values of Z with those found in Example 23.12 in which there was also a resistor.