Example A can having a mass 0.5 kg is pushed a lot a slot by a rotating arm. A portion of the slot is in the form of a spiral defined by the equation r = (0.10) m where is measured in radians. The arm rotates at a rate 0 = 4 rad/s . Determine the force of the arm on the can. Neglect friction and the size of the can. r = 0.10 6 = 4 rad/s

Example A can having a mass 0.5 kg is pushed a lot a slot by a rotating arm. A portion of the slot is in the form of a spiral defined by the equation r = (0.10) m where is measured in radians. The arm rotates at a rate 0 = 4 rad/s . Determine the force of the arm on the can. Neglect friction and the size of the can. r = 0.10 6 = 4 rad/s

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.78P: The figure shows a steel bar being processed by a rolling mill. Given that P=80kN and r =0.016,...

See similar textbooks

Similar questions

Repeat Prob. 4.152 assuming that the 400-kN force is applied at O instead of L.
A speedboat with a mass of 529 kg (including the driver) is tethered to a fixed buoy by a strong 28.3 m cable. The boat's owner loves high speed, but does not really want to go anywhere. So the owner revs up the boat's engine, makes a lot of noise, and runs the boat in circles around the buoy with the cable supplying all the necessary centripetal force. When the tension of the cable is steady at 12300 N, with what force is the boat's engine pushing the boat? Different physics textbooks treat drag force somewhat differently and use different formulas. For the present purpose, take the water's drag force on the boat to be (450 kg/m)×v2, where v denotes the boat's speed. Ignore any drag force on the cable. What is the force of the engine?
After being released from the top of a frictionless 30˚ ramp, abox of mass 20 kg slides 5.0 meters along the ramp until it hits a (massless) spring of constant k= 80N/m. Find the maximum compression of the spring.
A 40.0-N crate starting at rest slides down a rough 6.00-m-long ramp, inclined at 30.0 degrees with the horizontal. The magnitude of the force of friction between the crate and the ramp is 6.0 N. What is the speed of the crate at the bottom of the incline?
A 0.5 lbm apple is thrown from the edge of a tall building with an initial speed of 20 m/s. What is the change in kinetic energy of the apple in lbf-ft if it strikes the ground at 9840 ft/min? complete solution.
..Consider a leather belt with the following given: width of 100 mm, thickness of 6.4 mm, velocity of 18.3 m/s. Which of the following is the centrifugal force across the belt? Note that the density of belt is approximately 974 kg/m3Group of answer choices 205 N 309 N 209 N 305 N
If the maximum length of the spring is 40 cm, what average friction force opposes the motion of the mass?
In the following figure, the horizontal surface onwhich this block slides is frictionless. If the two forcesacting on it each have magnitude F = 30.0 N andM = 10.0 kg , what is the magnitude of the resultingacceleration of the block?
The super-container vessel in the figure has a total mass displacement of (4000) long tons. This vessel towed by a tugboat with α=20⁰ angle with horizontal. If a constant tension is applied as F= 400 kN by the tugboat, please calculate the time to bring the vessel to a speed of 2 knot from the rest. At these low speeds, please neglect the hull resistance that created by the motion. Note: (1 long tons = 1016.05 kg, 1 knot=1.151 mi/hr= 0.5144 m/s)
Find the displacement’ and velocity ‘u with which a 95 kg container placed at height of 543 m falls when pushed from top and reaches the ground in 4574
The container in Figure below is (W= 1.2 m) wide and is filled with crude oil ( ρ oil= 796 Kg/m3)to a height of (x= 3 m) and base length L= 2.15 m), and a crane begins to hoist the container upwards with an acceleration of av= 7 m/s^2 The magnitude of the exerted force on the lateral side of the tank is equal to -----------KN ? 2- The magnitude of the exerted force on the bottom side of the tank is equal to -----------KN ?
Consider a disc of mass M with a radius of 0.5 m that is lying on a slope at a 45-degree angle to the horizontal. It grips the hill well and does not slide. The disc is designed in such a way that its mass per unit area, (r), equals r1/2 kg m2, where r is the disc's radial distance in metres from its axis. Calculate the disk's mass.