i need the answer quickly Example23/Two transformers (4)are designed to match a line having a Zo =%3D3002, ZR = 750 find Stable impedance at thesection.

Answered: Image /qna-images/answer/742d74ae-43f5-4b24-90cc-006b85655c2a.jpg

Answered: Example23/ Two transformers are…

Example23/ Two transformers are designed to match a line having a Z, = %3D 3002, ZR = 75.2 find Stable impedance at the (4) section.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Related questions

Q: Solve the power triangle at Z2 using the following network law below. 1.) Kirchoff's Law Given: V1…

Q: What is i, in the following circuit? 4.9 A 3Ω 3 32(4 )1 A

A: For the calculation of unknown current We use nodal analysis Assume branch current leaving the…

Q: Two transformers () are designed to match a line having a Z, = %3D 3002, ZR = 752 find Stable…

Q: A single phase, 50-Hz transformer has 80 turns on the primary winding and 400 turns on the secondary…

Q: 2 The magnetic vector potential of two parallel infinite straight current filaments in free space…

A: Magnetic Flux Density: Magnetic Flux Density is the quantity of magnetic flux per unit area measured…

Q: The multiplexer has the input states of Do=1, D1=1, D2=1, D3=0 So=1, S1=0 Determine the output of…

A: The solution is given below

Q: Example24/ A transformer is designed to match a line having Z, = 4002 ,ZR 1002 , A 3m If the…

Q: 4. A certain coil is equivalent to a resistance and an inductance in series. The coil takes 20 A…

Q: d=o 48 need to convert the drawing from a handwritten drawing to a typeface on the computer, please

A: Given, The drawing is,

Q: Let εR = 3, μR = 6, and σ = 0. If Jd = 38sin(2.07 x 105t - 8x) az μA/m2, find E(t=2.1, x = 4.2).

A: The solution is given below

Q: Design an active high pass filter, Av = 10 and fon = 10Khz. Assume the values of the capacitors.

A: We need to find design active High pass filter .

Q: In a series RLC circuit supplied by a source of 125 V at a resonant frequency of 220 Hz, the…

A: 1

Q: Analyze the circuit to determine the voltage aM + 5V all nodes and the curents deough all tranches.…

A: IE=IB+IC

Q: 1.Given the waveform below for the Gated S-R latch, determine the Q output. (Active-HIGH enable…

A: A latch is a device that changes its output during the level trigger input. Based on the given input…

Q: T-L with Zo=600 0,ZR = 100 O. Find the length and location of the single stub terminated by short…

A: Given,Zo = 600 ΩZR = 100 Ωf=100 MHz

Q: Open write T-L with L=30 m , ZR = Z, = 50 N , f=50 MHZ Find Z, and Za d = 10 m

A: Here their is no need of frequency and length to calculate impedance at a any distance because here…

Q: Which of the following truth tables describes the circuit shown below? X y Dz

A: The outputs of every gate will be evaluated as per the inputs and then we can construct truth table…

Q: A 40Hp, 230V, 10pole, 50Hz three-phase induction motor is running at 585 rpm at rated load. If the…

Q: The stator resistance of a 1-phase induction motor is 2.5 ohms and its leakage reactance is 2.0…

A: In this question, We need to determine the equivalent circuit parameters?

Q: Determine I, in the circuit shown by mesh analysis jen -jir le I,

Q: 4. Sketch the drain characteristics of the JFET from the obtained data.

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: In a pole zero plot, there are only two poles in the origin. Hence the Type & Order number is O a. 2…

Q: 26 Itj9 24 5tjsr 8tj425 7+j 8 V> Sonz Vi 22010° V Sotz Sodte

Q: What frequency will be developed if the speed is 900 rpm

Q: Explain how the pulsating mmf of a single-phase induction motor may be considered equivalent to two…

A: Given, Output power, Pout=125 WNumber of pole. P=4Supply voltage, Vs=110 VFrequency, f=50 HzNo load…

Q: QUESTION 25 marka In the circuit shown, eurement indicates Vato be IV and Vto he 1.7V. What are a…

Q: 21 Vi: 12ov Lo° Vt= 1 (ov Lo VsE 90 V Lo° 73: 3-J 8A 24= 8t jizn 25: 9t J4A

Q: Refer to the Figure 3, find i, for t>0 if R1 = R2 = 2 k2, R3 =4 kN and C = 2 mF 1 = 0 R2 ww 30 mA R1…

A: We need to find current for given circuit

Q: Example23/ Two transformers (4) are designed to match a line having a Z. 3002, ZR 750 find Stable…

Q: A three phase, 60 hz, 3300 V motor develops 120 HP at a power factor of 0.84 lagging. A bank of…

A: A Delta connection is a connection of three-phase windings which are set at an angle of 120 degrees…

Q: A 480 Volts, 60HZ, 50Hp, three-phase induction motor is drawing 50 Amperes at 0.85 power factor…

Q: Example23/ Two transformers (4) are designed to match a line having a Z, = 3002, Zr = 75N find…

Q: DRAW THE STATE DIAGRAM OF THE FOLLOWING BINARY SEQUENCE DETECTORS: 1. 11OO1 2. 11 AND/OR 00 3. OOIO1

A: 1. State machine diagram of 11001 is shown in below figure,

Q: = 600 and , Q1: The currents of 3-phase system are Ia = 3500, 11 250 Compute the un-symmetrical…

Q: seatwork/assigmment: VLCs) %3D GOLUE 3 TH is Kint Tes) +56 +e

Q: The figure represents the equivalent circuit of a single-phase transformer, if after doing the…

Q: n the circuit shown, 3Ω b + Determine the following: 2 v+ A. Magnitude and direction of the current…

Q: 3.16 An electric flux density is given by D = Do ap, where Do is a given constant. (a) What charge…

A: We need to find out charge density and charge for given .

Q: What is the condition of a unipolar stepper motor if the resistance reading is always low?

A: An electrical motor is called stepper motor when the motor can be controlled on each step division…

Q: R Xc un. R- 55 N Xc = 55 5 XL= 555L 2 TfL SOLUE: ☺ Ċ in farads use Xc E 2TFC OL in finrye 4re XL…

Q: Example23/ Two transformers (4) are designed to match a line having a Z, = 3002, Zr 750 find Stable…

Q: Derive the output Voltage of 2-but D/A converter using the R/2R op-amp circuit

Q: Compute for Av (in dB): Vcc = 12V. %3D oVcc 4.7 kN 1 ΜΩ V, 0H B = 90 To = 00 2 O 45.38 dB O 12.54 dB…

A: We need to find out gain for given circuit

Q: loofa 50 ku 20 ku Out To. ぶ Viz 40m (9 kn non- in verting ampl.

Q: 1. Determine the current in the 4 ohms inductor of the circuit shown using superposition theorem.

Q: What is the energy stored in the 1 H inductor? 5Ω 10 Ω 1 H 15 V 10 Ω 2 F 10Ω ll 5 H 5Ω

Q: 3.13 i Spherical surfaces at r = 2, 4, and 6 m carry uniform surface charge densities of 20 nC/m²,…

A: We need to find out electric flux density at given point

Q: The settling time of an underdamped system is 4 seconds, the time constant is, O a. 16 sec b. 1 sec…

A: The solution is given below

Q: A charge of 1 x 10° C is located at the origin, and another charge of -2 x 10° C is located at…

Q: Q2: A string of 4 insulators has pin-to-earth equal to 0.2 of self-capacitance. Calculate (i) the…

Question

i need the answer quickly

Example23/
Two transformers (4)
are designed to match a line having a Zo =
%3D
3002, ZR = 750 find Stable impedance at the
section.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

With generator conyention, where the current leaves the positive terminal of the circuit element, if P is positive then positive real power is delivered. (a) False (b) True
Which termination would result to a phase change of 180 degrees at the load if Zo = 100 ohm? a. 50 ohm b. short circuit c. 75 ohm d. all of these What is the purpose of impedance matching? a. maximum return loss b. maximum SWR c. maximum load power d. maximum reflection A short piece of transmission line that may be open or shorted and used for impedance matching purposes. a. converter b. decoder c. stub d. transformer
SUBJECT: Elements of Electrical Machines DesignINSTRUCTIONS: - Please write clearly and understandable way. - Write all the corresponding Given with their corresponding symbols and units. - Draw/Illustrate the diagram/circuit or drawings that is related to the problem, IF POSSIBLE, which is HIGHLY REQUIRED. - Solve in step-by-step, no shortcut - Underline twice the Final Answer.PROBLEM: In connecting ideal single-phase transformers in parallel, how will the load be shared if the two transformers have different VA rating?
What do the connection angles and groups show in transformers? For example, where are the Yy0 , Dy5 ,Yd5, Yz5 group transformers used?
Discuss the role of FACTS (Flexible Alternating Current Transmission Systems) devices in power system control and optimization.
⦁ Does transformers work on DC? Justify your answer.
he node (busbar) and branch (line) data of a power system are provided in Table Q1.1 and Table Q1.2 respectively. All values in the tables are stated in per unit (p.u.). Using node 1 (busbar 1) as the reference (slack bus), calculate the line flows using the DC power flow method.
For the single-phase power system below, find the transmission losses in Watts (assume that the transformers are ideal). Hint: Remember that loads can be represented by complex numbers in either rectangular or polar form.
Two transformers of the same type, using the same grade of iron and conductor materials, are designed to work at the same flux and current densities; but the linear dimensions of one are two times those of the other in all respects. The ratio of KVA of the two transformers closely equals
If the values of real power and reactive power is specified for a bus, then it is called as PQ bus. Select one: True False
a short three phase transmission line connected to 33kv 50 hertz generating station at starting and is required to supply a load of 10 MW at pointed start lagging power factor at 30 KV addresses in that is the minimum transmission efficiency is to be determined96% estimate the per face value of resistance and inductance of a line
What is the nominal transformation ratio of a three-phase Dyn7 transformer consisting of a bank of 110/220 V single-phase transformers? Justify your answer. In addition, sketch how the windings of these transformers can be connected.