Answered: Exercise 1-6: An operational amplifier…

Exercise 1-6: An operational amplifier has open-loop gain = 10 Compare its closed-loop gain with that of an ideal amplifier when (a) B-0.1, and (B = 0.001. [Answers: (a) 9.99. (b) 909.09]

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 13PP: In an R-L parallel circuit, IT=1.25 amps, R=1.2k, and XL=1k. Find IR

See similar textbooks

Related questions

Q: (а) There are three voltage inputs of V1= lv, V2= 3v and V3 = 4v, and three resistors with %3D the…

A: An OPAMP(operational amplifier) is an integrated electronic circuit that is used to amplify weak…

Q: Consider the ideal shunt-series feedback amplifier in Figure below. Assume that the source…

Q: 1) a. A is a special case of the non-inverting amplifier in which the feedback resistance is 0 and…

Q: Show the connection of an LM124 quad op-amp as a three-stage amplifier with gains of +15, -22, and…

A: Given: A three-stage amplifier with gains of +15, -22, and -30. Use a 420 kΩ feedback resistor for…

Q: An amplifier has voltage gain with the feedback of 100. If the gain without feedback changes by 40%…

Q: A If an op-amp has a slew-rate of 5 V/µs, find the Maximum bandwidth for a peak output voltage of:…

A: A.

Q: Given the circuit below for a FET feedback amplifier, if V =1 mV, R1= 10 k2, the open-loop gain A =…

A: Given data: A0=-1000β=Avf=-10Vi=1 mV

Q: If an inverting amplifier takes input supply voltage of 20V, input resistance and feedback…

Q: Rc 2.2 kn RB For the series-series feedback amplifier in right figure, find the value of Rg, The…

A: For the given series -series feedback amplifier RE is calculated as shown below

Q: The inverting amplifier in the circuit shown has an input resistance of 500 kn, an output resistance…

Q: Write the characteristics of operational amplifier. Don't write in the paper and take picture

A: In this question, We are going to define the characteristics of operational amplifier.

Q: Find the closed-loop transconductance, input resistance, and output resistance for the series-series…

Q: c) Design two operational amplifier circuit having a gain of -10 and -18 each using a feedback…

Q: Q6/ For the voltage feedback network of Figure below, determine: (a) Ic 9 30 V (b) Vc 8.2 k2 (c) VE…

Q: B The gain of an amplifier without feedback is 50 V/V whereas with negative voltage feedback, it…

Q: Q) An amplifier has voltage gain with the feedback of 100. If the gain without feedback changes by…

Q: QI An amplifier employing negative feedback is shown in Figure Q1, for this circuit: (ii) Derive the…

A: Voltage shunt negative feedback amplifier:

Q: Design an amplifier with an overall gain Av = -15 where the input voltage vi has a source impedance…

A: Given: Consider the amplifier circuit: Av=-15Ri=2 kΩRin=4 kΩRL=6 kΩVBEon=0.7 Vβ=200 To find: Design…

Q: An inverting ampliﬁer is built with R2 =47kΩ and R1 = 2.4kΩ using an op amp with an open-loop gain…

A: Given a) Open loop-gain A=100 dB R1=2.4 kΩR2=47 kΩRid=300 kΩRod=200 kΩ convert the gain from the…

Q: PASSAGE If an opamp is perfroming by keeping two input voltages as 40 mV and 80 ml at inverting…

A: The circuit diagram can be drawn as

Q: An amplifier with negative feedback has voltage gains of 100. It is found that without feedback an…

A: It is given that, Vi=40mv(without feedback) Vi=0.9V(with feedback) Gain=100

Q: The common mode rejection ratio, CMRR of an operational amplifier is a metric used to quantify the…

Q: A noninverting ampliﬁer is built with R2 = 75 kΩ and R1 = 5.6kΩ using an op amp with an open -loop…

A: Given: R1=5.6 kΩR2=75 kΩA=100 dB Input Resistance= 500 kΩ Output Resistance= 300 Ω

Q: A noninverting ampliﬁer is designed to have a gain of 200 (46 dB) and is built using an operational…

A: Given data, The value of gain 1β = 200. The value of open loop gain is A= 80 dB. Converting open…

Q: Q-1: Consider a three stage Operational Amplifier with individual closed loop gains of A1, A2 & A3.…

Q: |Operational Amplifier Specifications and Circuits Should be no surprise here. Provide numerical…

A: According to the question

Q: Non-inverting amplifier is designed to provide an amplified signal which is in phase with the signal…

Q: A noninverting ampliﬁer is designed with R1 = 1kΩ, R2 = 39 kΩ, and an op amp with an open-loop gain…

A: Given R1=1 kΩR2=39 kΩA=80 dB The feedback factor for the non-inverting amplifier is given by…

Q: n ideal operational amplifier circuit in the closed-loop negative-feedback configuration is shown in…

Q: Design and draw a three-stage amplifier connected in series with gains of +15, -21, and -30 by using…

A: Op-Amp is used as a Constant-gain Multiplier-Multiple stage gains. When a number of stages are…

Q: 1. Design an inverting amplifier with a gain of 4. Use an ideal op amp, a 30 kΩ resistor in the…

A: Given A=4Rf=30 kΩ The expression for the gain of an inverting amplifier is given by…

Q: Q-1: Consider a three stage Operational Amplifier with individual closed loop gains of A1, A2 & A3.…

Q: Please help with A,B and C. Also, please make it legible sometimes it's too small so it's blurry.

A: As referenced, Gain should be in term of input and output resistance also.In this way, drawing an…

Q: An inverting ampliﬁer is built with R1 =11kΩand R2 = 220 kΩ using an op amp with an open-loop gain…

A: Given : R1 =11kΩand R2 = 220 kΩ , open-loop gain of 86 dB. Closed loop gain of amplifier is…

Q: A differential amplifier is characterised by a common-mode gain, A, which may be derived from figure…

A: Given, The graph for common-mode gain is shown below, The graph for differential gain is shown…

Q: opamp is working as inverting amplifier with input voltage of 40mV, input resistance of 120 ohm and…

Q: A noninverting ampliﬁer is built with R2 = 47 kΩ and R1 = 6.2k Ω using an op amp with an open-loop…

A: According to question: Closed loop gain of non inverting amplifier is…

Q: Some of the exercises show op-amps with a positive supply voltage but no information about negative…

A: The given circuit is shown below, after marking nodes

Q: The gain of an amplifier without feedback is 50 whereas with negative voltage feedback, it falls to…

Q: A non-inverting amplifier has following value, Value of feedback resistance (R₁) is 85 KQ with an…

Q: Design and drawa three-stage amplifier connected in series with gains of +15, –21, and -30 by using…

A: Given values, A1=+15A2=-21A3=-30RF=420kΩ

Q: An amplifier has a loop gain of -200 and a feedback of 0.10 is added. If the loop gain change to…

Q: f an opamp is perfroming by keeping two input voltages as 40 mV and 80 ml at inverting and non…

A: The circuit diagram can be drawn

Q: Find out the gain of inverting amplifier if it is performing on 12 V supply, it has input resistance…

A: Given data, Feedback resistance, Rf = 50 Ω. Input resistance, Ri = 20 Ω Since it is a inverting…

Q: The gain of an amplifier without feedback is 50 V/V whereas with negative voltage feedback, it falls…

A: Let's consider an amplifier with negative feedback with feedback factor as β, and gain without…

Q: 1. Given the operational amplifier below. a. Solve for the input voltage, if the feedback resistors…

Concept explainers

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.

Question

Exercise 1-6:
An operational amplifier has open-loop gain = 10 Compare its closed-loop gain with
that of an ideal amplifier when fa) B-0.1, and (B = 0.001.
%3D
[Answers: (a) 9.99. (b) 909.09]

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Design an inverting amplifier to provide a closed-loop voltage gain of Ay = -22 V/V. The maximum input voltage signal is 30 mV with a source resistance in the range of 1 kls R, < 3 kN. The variable source resistance should introduce a difference in the gain no more than a 2% of the gain factor. What is the range in output voltage?
(a) Define bandwidth of an amplifier and provide explanation using a diagram. (b) A circuit has no lower cut-off frequency but has an upper cut-off frequency of 100 MHz. What is its bandwidth?
Design an inverting amplifier with an input resistanceof 15 kohm and a gain of 28 dB. Choose valuesfrom the 1-percent resistor table .
Question 7 For an op-amp amplifier circuit has a closed-loop voltagegain of 5. If the op-amp used has a gain-bandwidth productof 1.5 MHz, and we can only tolerate 10% drop in gain, whatwill be the maximum usable frequency? (help me do this question with explanation)
1. For n-stage analog amplifier circuit, if the voltage gain of each stage is Adi and the op amp common-mode rejection ratio is CMRRi (I =1~N): a) derive the mathematical expressions for the CMRR for the whole circuit b) analyze which stage’s CMRR has the most influence on the overall CMRR.
Design a noninverting amplifier with an input resistanceof 100 k ohm and a gain of 6 dB. Choose valuesfrom the 1-percent resistor table,and use values that are no smaller than 2 k .
An inverting amplifier with a voltage gain of 5 is built with an operational amplifier with finite slew rate. When the frequency of an input sinusoid signal with 1V amplitude is larger than 20 kHz, the distortion of the output voltage occurs. According to this experimental result, calculate the slew rate of the operational amplifier.
The open-loop gain of an ampliﬁer is described by A(s) = 4×1013π2 (s+2π ×103)(s+2π ×104) (a) Will this ampliﬁer be stable for a closed-loop gain of 4? (b) What is the phase margin?
An operational amplifier has a very high gain. Do you think having a very high gain is good or not? Explain your answer.
An inverting ampliﬁer is built with R1 =11kΩand R2 = 220 kΩ using an op amp with an open-loop gain of 86 dB. What are the closed-loop gain, the gain error, and fractional gain error for this ampliﬁer? (b) Repeat if R1 is changed to 1.1 kΩ.
FACTS:An amplifier, electronic amplifier or amp is an electronic device that can increase the power of a signal. Classification of the amplifier can be done in 3 different ways. Voltage amplifiers. Current amplifiers. Power amplifiers. QUESTION: You've learned in Module 1 that an Amplifier's Output can be positive or negative which is just natural since we're already dealing with AC signals. But, why do we use negative feedback in Amplifiers?
Convert the inverting amplifier shown to thetransresistance amplifier as shown(66) using a Nortontransformation of vi and R1. What are the expressionsfor iTH and RTH? Write a expression forthe gain vo/vi.