Answered: Explain the elastic properties of a…

Name: Explain the elastic properties of a matter on the basis of interatomic
Uploaded: 2024-03-20T06:56:46.000Z
Channel: Bartleby
Description: Explain the elastic properties of a matter on the basis of interatomic forces.

Science

Physics

Explain the elastic properties of a matter on the basis of interatomic forces.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 36CQ: Explain why the viscosity of a liquid decreases with temperature, that is, how might an increase in...

See similar textbooks

Related questions

Q: A block of iron is sliding across a horizontal floor. The friction force between the block and the…

A: The friction force on the block as it slides along the surface is parallel to then lower surface and…

Q: A bridge, which made of carbon-steel, is expected to subject to 100 tons. Explain how you could…

A: SOlution: To determine the deformation type of bridge on loading.

Q: The ratio of the lateral expansion to the longitudinal shortening of a concrete cylinder when…

A: We need to comment on what we call the ratio of lateral expansion to longitudinal shortening of a…

Q: () A metallic bar of 100 mm long has a square cross section 20 mm on an edge and is pulled in…

Q: Graphite consists of planes of carbon atoms. Between atoms in the planes there are only weak forces.…

A: Graphite does not have a 3 dimensional structure. It has a hexagonal type structure that is in a…

Q: Viscosity in liquids, decrease by increasing the temperature. Ture or False

Q: 4. A 5.0 inches cube chiffon cake on a table was exposed to a shearing force of 0.20 The upper…

A: Given-The shear modulus of the cake is G=0.05 lb/in2Slide of chiffon l=5 inchesShearing force…

Q: State Hooke’s Law of Elasticity a. as it is applied to an elongated body like a metal rod b. as it…

Q: Calculate the force a piano tuner applies to stretch a steel piano wire by 8.00 mm, if the wire is…

A: The cross-sectional area of the wire can be obtained as

Q: Calculate the force a piano tuner applies to stretch a steel piano wire 10.00 mm, if the wire is…

Q: What happens when the stretching force on an elastic material is released? O The material breaks. O…

A: When we apply stretching force on elastic material then its length increases. On removing the…

Q: and on an edge is pulled in tension with a load of 89,000 and experiences an elongation .Assuming…

A: By Hook's law we know that, stress ∝ strainstress = K × strainstressstrain…

Q: 0 of 10 > O Attempt 2 A 2.9-carat diamond is grown under a high pressure of 58 x 10' N/m2. One carat…

A: K = - v dp/dv d= 3.52g/cm3= 3520kg/m3

Q: 3. A steel bar and an aluminium bar are each under a load of 5000 N. If the cross-sectional area of…

A: The Young's modulus of elasticity gives the mechanical strength of a material. It gives the ability…

Q: 3. A cubical box has been constructed from uniform metal plate of negligible thickness. The box is…

Q: Artificial diamonds can be made using high-pressure, high-temperature presses. Suppose an artificial…

A: It is given that

Q: A rubber band 20 cm long has a cross-sectional area of 4mm^2. What load will stretch the rubber band…

A: ΔL=Elongation of rubber band=1 mm=1×10−3 mF=LoadA=Cross-sectional area=4 mm2=4×10−6 mE=Modulus of…

Q: The demand function for specialty steel products is given, where p is in dollars and q is the number…

Q: A material is 250 cm long, 8 cm wide and 10 cm deep. The material is subjected to an axial force of…

A: Given: Length of material, L = 250 cm = 2.5 m width of material, b = 8 cm = 0.08 m depth of…

Q: A certain spring stretches 6 cm when a load of 30 N is suspended from it. How much will the spring…

A: Initial stretch in spring = 6 cm Initial load applied to spring = 30 N Finally, load applied to…

Q: A cast iron rod of diameter 18 mm and length of 240 mm is subjected to a tensile load of 100 kN, and…

A: Given. T = 100KN = 100,000 N D = 18mm = 0.018 m L = 240mm = 0.24m ∆L = 0.0006 m

Q: Determine the maximum shear of the beam loaded as shown. 400kN 10kN/m 10m 10m 20m R1 R2

Q: 444 N A uniform bar AB is resting in a horizontal position on smooth inclines as shown below.…

Q: dv, y) Momentum is transfered from areas of high velocity those of lower velocity The difference in…

Q: 3. A steel beam is placed vertically in the basement of a building to keep the floor above from…

Q: A steel bar 100 mm long and having a square cross section 20 mm on an edge is pulled in tension with…

Q: A steel beam is placed vertically in the basement of a building to keep the floor above from…

Q: Suspension cables are used to carry gondolas at ski resorts. Consider a suspension cable that…

Q: Explain how the Marina Bay Sands Hotel in Singapore satisfies the principle for stability.

Q: An elastic string of natural length 0.4m and modulus of elasticity 16N is stretched until the…

A: The relationship between the modulus of elasticity and tension is T=λxl Here T is tension, λ is the…

Q: Find the resultant of the following system and state the force needed to maintain equilibrium. 12N…

A: in x directionfx=-12 sin40o - 6 cos65o + 10 cos25ofx=-1.18 N in y directionfy=12 cos40o+10…

Q: A wire is stretched 3mm by a force of 150 N. Assuming the elastic limit is not * :exceeded, the…

A: Given, Stretched wire l = 3mm Force F1 = 150 N

Q: A rubber band 20 cm long has a cross-sectional area of 4 mm . What load will stretch the rubber band…

A: The cross sectional area of the rubber band is, A=4 mm20.01 cm21 mm2=0.04 cm2 The stretched distance…

Q: An incident involving unexpected collapse of a deck on a cruise linerhas been reportedto a…

A: Fiber and matrix have Young's modulus of elasticity values changing at every direction and specific…

Q: A rubber band 20 cm long has a cross-sectional area of 4 mm2 . What load will stretch the rubber…

A: The Young's modulus is given by Y =F LA l where, F is the load, l is the extension, A is the area, L…

Q: What type of elasticity is involved in the following cases? (a) A gas (b) A wire pulled at its ends…

Q: P is the stress experience when an object is compressed from all sides, usually experienced by…

A: Here, it is given that P is the stress experience when an object is compressed from all sides,…

Q: A tensile force is applied on a rod axially of 18 mm in diameter that is deformed elastically.…

Q: Artificial diamonds can be made using high- pressure, high-temperature presses. Suppose an -6'…

A: Given data : pressure under which diamond is kept, P = 4.70 Gpa = 4.7 × 109 Pa Bulk modulus of…

Q: A test was intended to decide the stretch of human cortical bone when it is put under a steady…

Q: hanging wire made of an alloy of aluminum with diameter 0.05 cm is initially 3.0 m long. When a 7 kg…

A: Given :- The diameter d = 0.05 cm initial length L = 3.0 m The hanging wire mass m = 7 kg The…

Q: 2. A glass dropped on the floor is more likely to break if the floor is concrete than if it is wood?…

A: The concrete surface stops the glass almost immediately , the deceleration is much faster in the…

Q: Artificial diamonds can be made using high-pressure, high-temperature presses. Suppose an artificial…

A: Explanation From the defintion of Bulk modulus we get, B=-∆P∆VV .......................(1) where is…

Concept explainers

Newton's First Law of Motion

If a very smooth ball is rolled down an inclined surface with zero friction, the ball will continue to roll indefinitely for an infinite time, in an attempt to reach to the same height on the opposite hill!

Topic Video

Question

Explain the elastic properties of a matter on the basis of interatomic forces.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Bone has a Youngs modulus of 18 109 Pa. Under compression, it can will island a stress or about 160 106 Pa before breaking. Assume that a femur (thigh bone) is 0.50 m long, and calculate the amount of compression this bone can withstand before breaking.
Artificial diamonds can be made using high-pressure, high-temperature presses. Suppose an artificial diamond of volume 1.00 106 m3 is formed under a pressure of 5.00 GPa. Find the change in its volume when it is released from the press and brought to atmospheric pressure. Take the diamonds bulk modulus to be B = 194 GPa.
How would you test the notion that a steel ball is elastic?
The elasticity of the uncooked steak answer is incorrect.
Underwater, you can just barely lift a 75.0 kg rock (density 3.20 g/cm3 ). How massive a rock could you lift on dry land?
A rubber band 20 cm long has a cross-sectional area of 4mm^2. What load will stretch the rubber band 1 mm if the modulus of elasticity of rubber band is 4 x 10^-15 dynes/cm2 ?
A bridge, which made of carbon-steel, is expected to subject to 100 tons. Explain how you could decide that the bridge will either deform elasticity, just deform plasticity, or or it will fracture.
You hang a heavy ball with a mass of 14 kg from a gold wire 2.5 m long that is 2 mm in diameter. You measure the stretch of the wire, and find that the wire stretched 0.00139 m. (a) Calculate young's modulus for the wire. (b) The atomic mass of gold is 197 g/ mole, and the density of gold is 19.3 g/cm^3. Calculate the interatomic spring stiffness for gold.
A string on a tennis racket is under the tension of 25 N. If its diameter is 3.3 mm, by how much is it stretched (in mm) from its original length of 67 cm. The Young Modulus of the string is 22 x 109 Pa.
Compute the modulus of elasticity of a copper alloy wire thatstretches 14 mm when subjected to a load of 320 N. The wire is 4 mlong and has a diameter of 1 mm.
A rubber band 20 cm long has a cross-sectional area of 4 mm . What load will stretchthe rubber band 1 mm if the modulus of elasticity of rubber band is 4 x 10-15dynes/cm2?
A circular metal column is to support load of 500 Tonne and it must not compress more than 0.1 mm. The modulus of elasticity is 210 GPa. The column is 2 m long. Determine cross sectional area and the diameter.