Explain the essential features of Indicating Instruments Explain the significance of Fluid friction damping in an indicating Instrument. Explain about controlling torque using Spring control method.

Q: 8Ω A2 A 4Ω 10Ω 12 VA

A: Given Super position theorm:The response produced at an element when all the sources are present is...

Q: use diagram to answer question 3 please

A: The voltage to which the capacitor charges is 'E". Therefore, this is the initial voltage across the...

Q: A common source amplifier is given in Figure 12. The JFET has the following parameters: Ipss = 15 mA...

A:

Q: Test A voltage e(t) = 50 sin 314 t is applied to series circuit consisting of 10 ohm resistance and ...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: 2. Find the inverse z transform of the following а. x(2) %3D z-1 z2-2z+1 1+2z-1+z-2 b. X(z) = %3D 1-...

A: In this question,  Find the inverse Z transform.  We know  u(n) ---ZT--> 1/(1-Z-1 )   

Q: Determine all the currents and voltages for the circuit in Fig.6.8. R, R2 60 R,40 R30 E -16.8 V R.60...

A: Brief description : In the above given question they have mentioned an electrical circuit which cons...

Q: 3. (LO4) The rate of change in resistance of a conductive wire (R(0)) with respect to its temperatur...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts f...

Q: Question 2 Use mesh analysis to find the mesh currents in the circuit given in Figure 2 Hint: Apply ...

A: Here we have given a circuit, which consists of no. of resistors, voltage source and current source....

Q: (iii) The ultrasonic device requires a suitable op-amp circuit that can provide a gain of +100. Deve...

A:

Q: The laplace transform of a current through an element is  s/(s+1)^2+1. The signal in time domain d...

A:

Q: 1. An optical system with multiple lenses is placed in the air. Experiment results find that (1) whe...

A:            

Q: I need help sloving for I2 1100I2 - (3300)(10 + 3300I2)/4500 = - 10

A: To solve for I2 from the given equation 

Q: (i) Construct the Wheatstone bridge circuit to measure the change in resistance of the gage(s) and s...

A:

Q: Evaluate the following and write it in rectangular form a.) (3-j)/(2+j7) b.) (3)/(9-j) c.) (j8)/(...

A: a.) (3-j)/(2+j7)

Q: Two equal valued resistors dissipate a power of 100W. The resistors are connected in? choices seri...

A: Given: Two equal valued resistors dissipate a power of 100W. Then The resistors are connected in?

Q: no. 000 AWG wire is 100 meters long. For no. 000 wire, it has a wire resistance of 0.0618 ohms per 1...

A: In this question AWG wire is given...We have to find out power loss due to current and due to this p...

Q: R7 XMM4 5600 R6 7800 R9 V2 R8 R10 12002 12V 7802 1ka

A:

Q: A band stop filter is designed to stop or eliminate all frequencies within a band of frequencies, 01...

A: The circuit is given as At resonance, these parallel RC circuits will offer a very large impedance ...

Q: 2.26. Using only the Fourier transform of the unit im- pulse function and appropriate transform theo...

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions...

Q: 3.31 12 V 241 Rs 3 A R34.7 N V a. Using the superposition theorem, determine the voltage across the ...

A: Note : We are authorized to answer three subparts at a time, since you have not mentioned which part...

Q: Derive the general equation of polarization E E E E 2E E -cos 8 = sin? 8 E, E,

A: To derive the general equation of polarization   

Q: Problem 4: (~. 1 radius of 0.25 m. What is the electrostatic potential a distance of 0.10 m above th...

A:

Q: 3. A series circuit consists of a ( 4.7k , 5.6k2, 9k2 and 10k2 ) resistor. Which resistor has the mo...

A: In this question we need to find a which resistance has the most voltage across it 

Q: soln: Redrow the given circuit R7 S6on R6 Iq 7802 R9 RIO V3 R8 V2 312002 7802 12V R6 and R7 in paral...

A: The solution is provided by simplifying the network using series and parallel combination of the res...

Q: 11.The F.L. Cu loss and iron loss of a transformer are 920 W and 430 W respectively. Calculate the l...

A:

Q: Rc R, C, |Z. R2 RE z, Figure Q2

A:

Q: s(t) = 2 cos (2πf0t +θ), find the fourier transform S(f). vout(t) = s(t) cosθ + s(t) sinθ, find the...

A: Given s(t)=2 cos(2πf0t +θ), vout(t) = s(t) cosθ + s(t) sinθ

Q: A amplifier with a linear voltage gain of 1000 has a gain of 60dB. True False

A: Given: Linear voltage gain of the amplifier is G=V0Vin=1000 Gian in dB, GdB=60  

Q: Figure 2 illustrates the example use of FET using common-gate configuration. For the given circuit c...

A:

Q: In a balanced Y-A connected system the source voltage is given as V = 200/10° V (rms). Each phase of...

A: Line current- In delta connected system line current is equal to the root three times of the phase c...

Q: 3. In a series RL circuit, find R and L, when the current response for a voltage source of 150cos(20...

A:

Q: Ei Ip AGe Si -o Vo - Ez

A:

Q: three-phase, dry-type transformer has a voltage rating of 600-208Y/120 V. The voltage applied to the...

A:

Q: For the given circuit, the Thevenin voltag at the terminals a-b is: 1Ω 1 H ww o a rell 5 cos t V (+ ...

A: Given circuit shown 

Q: In an Alternating Current Electricity with a voltage source rated 230 volts, 3 electrical appliances...

A: DC is not the only "type" of electricity in use, despite how convenient and simple it is. Certain en...

Q: What is the Thevenin Equivalent voltage and Thevenin Equivalent resistance of the circuit shown belo...

A: Given circuit:

Q: 2. Determine the average power absorbed by cach resistor, the total average power absorbed and the a...

A: Given figure as- I1=12∠45°4I1=3∠45°I2=12∠45°2-j1Ω=12∠45°2.236∠-26.56°I2=5.366∠71.56° A

Q: Given that A = 2ax – az, B = 3ax + ay and C = - 2ax + 6ay – 4a

A: It is given that: A=2ax-azB=3ax+ayC=-2ax+6ay-4az    

Q: 1.Draw the DC equivalent circuit. 2.Draw the fixed bias base emitter circuit. Derive IB. 3.Draw fixe...

A: 1.Draw the DC equivalent circuit. 2.Draw the fixed bias base emitter circuit. Derive IB. 3.Draw fixe...

Q: 36. A proton is confined in a uranium nucleus of radius 7.2 X 10-15 m. Determine the proton's minimu...

A: Strategy: Let’s assume the minimum proton momentum is equal to that determined by the uncertainty pr...

Q: o.) Find Curmnt Iy and Voltage Vx short -Circuited, b.) if the terminal a-b is Find the hew Current ...

A:

Q: 3. Solve for the total resistance of the network below.

A:

Q: A 1000 kVA, 6600 / 400 volts 60 cycle single phase core type transformer has the following average d...

A: The solution can be achieved as follows.

Q: 1. Calcule los voltajes Vg, Vg, Vc, Vce,Vout , la corriente Ic y la ganancia A, del siguiente circui...

A: The given circuit is a common collector amplifier the required parameters can be calculated by using...

Q: What value of capacitance is required to produce 50 2 of reactance at 450 MHz?

A: To solve above problem, one should know how to find equivalent capacitance for series and parallel c...

Q: 3. Find the transfer function 0(s)/T(s) of the circuit. I N-m'rad I kg-m IN-m-s'rad

A:

Q: For an AM envelope with a maximum peak voltage of 52V and minimum peak-to-peak voltage of 24V, what ...

A: This question belongs to electronics . It is about calculation of modulation factor in amplitude mod...

Q: Find the Laplace impedance of a series parallel circuit where 2henry inductor is in series with the ...

A: LAPLACE TRANSFORM   Laplace transform converts the time variable function to the complex s form. Lap...

Q: UBe Fourier transforms to Find G(x.E such hat d2G.G-S(xーE) dx? - 00 < X < ∞ with DO IGI dx < 00

A:

Q: Three Inductive loads each of resistance R = 28 ohms and %3D inductance L = 0.03 H are connected in ...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Motor Load, Torque, and Power Quality Requirement

An electric motor is a gadget that changes electrical energy into mechanical energy over to follow up on a mechanical burden. The weight set on the motor because of this mechanical movement is known as motor load. Appropriately matching the motor burden to the engine is vital to forestall harm to the engine or wasteful and unnecessary expensive activity. Engines perform such undertakings as moving a thing starting with one spot then onto the next, cutting it, changing its shape, etc. The motors might be evaluated as far as a few variables including power yield, voltage, current, and temperature. Harm to an engine might happen when it is worked under over the top engine load contrasted with its appraised limit.