Explain the following a. How does a  circuit behave when it is in resonance? b. What fundamental properties of Inductive reactance and capacitive reactance make resonance possible?  c.What is EMF

Q: If a car on a circular racetrack (eg, vertical circle of radius R, loop to loop), moving in circular...

A:

Q: 5.26 How many moles of an ideal gas are there if the volume of the gas is 158 L at 14°C and a pressu...

A: Given value--- Volume = 158 L. Temperature = 14 degree C. pressure = 89 kPa. We have to find--- N...

Q: Problem 5: Suppose the ski patrol lowers a rescue sled carrying an injured skiier, with a ombined ma...

A:

Q: The figure below shows two wires carrying currents of I = 4.65 A in opposite directions, separated b...

A:

Q: What is the work done, in joules, by the horizontal force?

A: We know that formula of the work done is given as  W = Fds where F is the force  ds is the displacem...

Q: A wire 2 m long and 2 mm in diameter, when stretched by weight of 8 kg has its length increased by 0...

A:

Q: Suppose a 57-turn coil lies in the plane of the page in a uniform magnetic field that is directed in...

A:

Q: 2. A see-saw consists of a uniform beam of length L and mass M pivoted in the center. Two children (...

A: Moment of inertia = mr2  Moment of inertia of uniform rod about center of mass = (1/12) ML2 

Q: Calculate the kinetic energy in joules of a 84 kg traveling at 4.26 m/s ?

A: Given data :                          Velocity  =  v                            Mass    =  m        ...

Q: Part (b) Write an expression for the magnitude of the change in the car's height, h, along the y-dir...

A: Solution:-

Q: A brick of mass m = 0.48 kg is set against a spring with a spring constant of k1 = 619 N/m which has...

A: Given: m =0.48 kgk1=619 N/md1=0.1mk2=244 N/mμk=0.5x=1md2=?

Q: 3. A solid conducting sphere of radius a, has a net charge Q as shown in the figure below. Using Gau...

A: Given data: The charge on the conducting sphere is +Q.

Q: 10. Use the formulas a = v2/r and v = 2πr/T to derive the following formulas: (a) centripetal accele...

A: Givna=v2r andv=2πrT

Q: A 444 N was applied to a 121 kg block, find the normal force if the angle theta is 25 degrees. F Sel...

A:

Q: An equipotential surface must be perpendicular to the electric field at certain points. TRUE or FALS...

A: Electric field is the area where the electrical force can be felt.

Q: [15] Two negatives charges will --- each other. * repel attract [16] The fewer the number of free el...

A: Solution 15 :- We know that charges of same nature repel each other and charges of different nature ...

Q: Part A Two vertical metal rods that are 13 cm apart are connected at the top by a 1.0 N resistor. A ...

A: Given data: The distance between the rods is d=13 cm. The length of horizontal metal rod is l=13 cm...

Q: certain region of space the electric potential increases uniformly from west to east and does not va...

A: Electric field is the negative gradient of electric potential. E = -dV/dx

Q: A batter hit a 0.145kg baseball straight upward with an initial speed of 25.0m/s. How much work has ...

A: concept

Q: a rope applies a hortizontal force of 180 N to pull a crate a distance of 2 m across a floor. A fric...

A:

Q: 5. Given voltage equals to 12.0 V,C1= C 2= 13 µu F and C 3 = C 4 = 2µ F. What is the charge on capac...

A: When capacitors are connected in parallel, the total capacitance is the sum of the individual capaci...

Q: Problem 5: Suppose the ski patrol lowers a rescue sled carrying an injured skiier, with a combined m...

A: Work done by the gravitational force on the slide all right so the gravitational force so it is in t...

Q: roblem 2: A horizontal force keeps a 3.71 kg box traveling at a constant speed up a frictionless inc...

A:

Q: You have now learned two interpretations of electrical interactions 1) a charge in an electric field...

A:

Q: Calculate the work, in joules, that the man performs to cause the crate and himself to move up the r...

A:

Q: Before: mI = 25.0 g mT = 25.0 g vI = 12.0 m/s East vT = 0 m/s After: mI = 25.0 g vI ' = 5.26 m/s @ 6...

A:

Q: If a box of 90kg is put into the trunk of a car and as a result height of the car's bumper decreases...

A: Given: The mass of the box is 90 kg. The compression in the spring is 12 cm.

Q: . A bullet of mass 10 g moving with speed of 210 m/s in stopped suddenly. If all its kinetic energy ...

A:

Q: 16. Stan does 176 J of work lifting himself 0.300 m. What is Stan's mass?

A:

Q: Two point charges, Q1=25 pC and Q2=-75 pC, are separated by a distance of 3.0 cm. Find the magnitude...

A: GivenQ1=25 pCQ2=-75pCDistance of sepeartion between them,d=3.0 cm

Q: 2. In figure below, find the equivalent capacitance of the combination. (C 1 = 23 u F,C2 = 45 μF and...

A:

Q: Part (b) After the block comes to rest, the spring pushes the block back up the ramp. How fast, in m...

A:

Q: A 140 kg uniform beam is attached to a vertical wall at one end and is supported by a cable at the o...

A:

Q: 1)This is an electric current driven magnet A. Permananet magnet B. Ferromagnet C. Natural Magnet...

A:

Q: q2 q4 + q1 $4 q3 + s3 s2 s1

A: Given value--- q1=q2=q3=q4=q5=150nC . We have to find--- What is the electric flux of s1?

Q: 2. A small ball of mass m is suspended from a string of length l. The ball revolves with constant sp...

A: When a body moves in circular motion it requires centripetal force which is provided by already exis...

Q: Find the Young’s modulus of the wire. (g= 9.81 m/s/s)

A:

Q: A device consists of an object with a weight of 20.0 N hanging vertically from a spring with a sprin...

A: We know that a device consists of an object with the weight of W = 20 N and it hang vertically from ...

Q: Problem 5 - Projectile Motion A football is kicked at ground level with a speed of 18 m/s at an angl...

A:

Q: Make a research about Rotational Equilibrium. Principles and Terminologies 1 problem with solution

A:

Q: A uniform ladder of mass (m = 14.0 kg) and length (L) leans against a frictionless wall, see figure....

A:

Q: Which of the following is true about displacement current? (Select all that apply.) It creates an in...

A: It was created to bring the Ampere circuit law into line with logic. Displacement current is introdu...

Q: A driver decreases the speed of a car from 45 m /s to 15 m/s in 6 seconds. Find the acceleration of ...

A:

Q: Question 1 A particle starts moving from the origin at t-0with a velocity of V=1477-18/)ms and const...

A:

Q: 5. Two blocks of masses mand 3m QIC are placed on a frictionless, hor- V izontal surface. A light sp...

A: As per our policies, we can answer only upto maximum of 3 sub-parts in one question. Please post oth...

Q: Make a research about Rotational Equilibrium. Principles and Terminologies 1 problem with solution

A:

Q: A. Francis suspends a 250g mass vertically from a spring that stretches 8.5cm. Determines the stretc...

A: A) First we need to find spring constant/force constant of spring.  Then , using this find spring st...

Q: Suppose a spring (with a spring constant of 600 N/m) is compressed 0.4 m. If a projectile of mass 0....

A: GivenSpring constant, K=600 N/mSpring compressed to distance, d=0.4 mMass of projectile, m=0.05 kg 

Q: q2 q4 +. q1 $4 q3 s3 s2 s1 +

A: Gauss Law states that the net electric flux out of a closed surface is equal to the net charge enclo...

Q: 4. Sue whirls a yo-yo above her head in a horizontal circle. The yo-yo has a mass of 0.20 kg and is ...

A: For circular motion object required centripetal force which provided by tension in the string.

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.