Explain the operation of frequency demodulation by using the PLL method.

Q: What is the graph of the FM and PM magnitude spectrum with sine modulation?

A: GRAPH OF FM MAGNITUDE SPECTRUM WITH SINE MODULATION: Modulation is the technique of encoding data…

Q: What are different step in typical ASIC design flow.

A: To verify a design we write verification module and  test bench to check that it meet…

Q: 6. Does PPM contain derivative of modulating signal compared to PWM?

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Please show a two-terminal general modulation channel model. And for the random  parameter channel,…

A: Modulation: Conversion of analog signal by sampling into 0 and 1 bits through carrier wave…

Q: Describe the USES OF THE MODIFIED COLLECTOR EQUATIONS ?

A:

Q: How to use the PLL circuit and the logic circuit to comprise a doubler frequency circuit?

A: PLL circuit : PLL circuit is known as phase locked loop circuit it is an electronic circuit which is…

Q: An application involves signal pulses with constant shape and only a small variation in amplitude.…

A: ANS = Leading edge timing EXPLANATION WITH DETAIL ANALYSIS :- If rise time and amplitude walk (time…

Q: 8) How much the highest power efficiency (useful power) can we obtain when using DSB- AM?

A: DSB AM stands for double side band amplitude modulation. In this type of AM they are having 2 side…

Q: Explain why Ray theory is not sufficient to describe wave propagation in OFS What are the advantages…

A: This question has multi-parts. I have solve only two parts. In analyzing the transmission of sound…

Q: The maximum peak frequency deviation divided by the maximum frequency gives the worst-case…

A: Frequency deviation is the worst case modulation index is equal to maximum peak frequency deviation…

Q: 6. What is the main advantage of using a phase modulator rather than a direct frequency modulator?

A: NOTE: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: Why input impedance of a MOSFET is very high?

A: In a typical MOAFET, the Gate terminal is seperated from the Source and the Drain terminal by a…

Q: What exactly do bandwidth and DTR mean?

A: Bandwidth : Bandwidth of signal is the range of the frequency in which a specific signal or data is…

Q: What is the difference between Q-point and Q-point stability?

A:

Q: (a) Explain how the Nyquist stability criterion can be used to determine the

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: what are the advantages and disadvantagesof large carrier and suppressed carrier modulation?

A: Advantage of large carrier modulation: The advantage of large carrier signal modulation is that it…

Q: Draw the equivalent circuit model and switching characteristics of the device which is used for low…

A: MOSFET devices are used for low state loss and high switching frequency operation. MOSFET full form…

Q: about nyquist stability criterion in deatials

A: Need to find about nyquist stability criteria

Q: Differentiate AM DSBFC, DSBSC, and SSBSC in terms of the power distribution and bandwidth. What are…

A:

Q: When does maximum frequency deviation occur in a PM signal? -It occurs at the minimum amplitude…

A: ∆f = kp dm(t)/dt |max Kp is sensitivity of phase modulator m(t) is modulating signal

Q: What is the difference between the modulation index and the deviation ratio?

A: In FM modulation, modulation index is  the ratio of the frequency deviation to the modulating…

Q: of frequency discriminator in FM demodulation. Mention the uses Write the advantages of hand-off…

A:

Q: What is the importance of phase inversion in transistor?

A: The explanation is as follows.

Q: what was the net outcome, explain the harmonics available before and after the filtering techniques…

A: Harmonics are a disruption in the regular electrical current waveform caused by nonlinear loads.…

Q: (b) Derive the power calculation of AM signal.

A: Given:  Brief description: Here in the above questions they want to know that derivation of the…

Q: what's advantages and disadvantages of FM

A: The explanation is as follows.

Q: 1- Explain the principle of direct method generation of FM signal.

A: The explanation is as follows.

Q: Explain what is meant by the term, modulation, and produce a diagram of an Amplitude Modulated…

A:

Q: Write short notes on EEG signal classification in terms of frequency.

A: Electroencephalogram(EEG):                  The electroencephalogram (EEG) is a scalp recording of…

Q: Describe the effect of the signal amplitude on the slope overload phenomena?

A:

Q: The dc load line on a family of collector characteristic curves of a transistor shows the

A: In this we will write about dc load line of collector characterestics  curves...

Q: What is the purpose of balanced ring modulator in single-sideband transmission? Describe its…

A: Balanced ring modulator: Ring modulation is a signal processing function, and execution of frequency…

Q: Describe how a Gilbert cell multiplier can be used to demodulate a phase modulated signal? What is…

A: Gilbert cell is a modified version of emitter coupled cell. It is used as a mixer.

Q: What is a theory Single-sideband modulation

A: A Sideband is a band of frequencies, containing power, which are the lower and higher frequencies of…

Q: Define Small signal Stability. Why is it important to study in a power system network? How Ts and Td…

A: Small signal rotor angle stability is concerned with the ability of the power system to maintain…

Q: What is transient analysis used for?

A:

Q: Describe the effect of the signal amplitude on the slope overload phenomena?

A: We need to find out the amplitude of message signal .

Q: In your own words, explain the pinch-off region of a MOSFET and Sketch related graph[ a.

A:

Q: Why there is no  miller effect in the common base circuit?

A: Reason behind the absence of the Miller effect in the common base circuit: It is only applicable…

Q: Explain the difference between AC small signal amplifiers. from power amplifiers.

A: to explain the difference between AC small signal amplifiers from power amplifiers.

Q: 4. What are the advantages of MOSFET over JFET?

A: Dear student please find the attachment.

Q: Advantage of using Dynamic channel assignment is

A: The solution is provided in the following section.

Q: a) In a Bipolar Transistor define the quantity B or hFE- How is the device structure of the npn…

A: Transistor:- It is a semiconductor device that have three terminals. Its main function is switching…

Q: q)what the advantages of using correlation measurements to improve signal detection?

A:

Q: Explain the difference between low-frequency numerical methods and high frequency methods. Give…

A: Low Frequency Numerical Method: A mathematical calculation of low-frequency electromagnetic field…

Q: 7: Explain constructional features of a MOSFET.

A:

Q: What is the objectives of generate discrete signal by using sampling frequency?

A:

Q: What are the advantages of MOSFET over JFET?

A: MOSFET are used in various applications due to its simple working phenomena and advantages over…