F. A 2 MVA, 3-phase, 8-pole alternator runs at 750 r.p.m. and operates in parallel with other machines on 6000 V bus-bars. Find the synchronising power on full-load at p.f. 0-8 lagging per mechanical degree of displacement and the corresponding synchronising torque. The synchronous reactance of the machine is 6 n/phase. (505 kW; 6400 N-m) IN

F. A 2 MVA, 3-phase, 8-pole alternator runs at 750 r.p.m. and operates in parallel with other machines on 6000 V bus-bars. Find the synchronising power on full-load at p.f. 0-8 lagging per mechanical degree of displacement and the corresponding synchronising torque. The synchronous reactance of the machine is 6 n/phase. (505 kW; 6400 N-m) IN

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter11: Transient Stability

Section: Chapter Questions

Problem 11.3P

See similar textbooks

Similar questions

A 2-pole, single-phase alternator driven at 3000rpm require a mechanical input to its rotor of 30kW when it is delivering its full-load output of 30kW. Under this condition the fixed and variable losses are1100W and 2.8kW respectively, and the rotor field winding is supplied from a 110V dc source. Given that the full-load efficiency is 87%, determine. the frequency generated, the input driving torque on full-load and the rotor field current
An 11 kV, three-phase, turbo alternator has a synchronous impedance per phase of(0,4 + j0,8) Ω and it supplies 2 kA at unity power factor to an infinite bus. Theexcitation is increased so that the emf is increased by 20%. Sketch a general loaddiagram and determine the following from this diagram: the armature current for maximum power output, the actual maximum power output
a) With the aid of a diagram and phasor diagram, explain the double-reactance concept for salient-pole alternators. b) 3-phase star-connected synchronous generator supplies a current of 10A having phase angle of 20° lagging 400V (phase voltage). Given the direct and quadrature axis reactances as 10ohms and 6.5ohms respectively and neglecting armature resistance, Find: 1. The load angle 2 The direct and quadrature components of armature currents 3. Voltage regulation
A 11 kV, 50 Hz, four-pole, star-connected alternator is being synchronised on an infinitebus. On the moment of synchronising, the excitation is such that the induced emf is 10%too low and the synchronising angle is 8° electrical leading. If the synchronous reactanceis 6 Ω/phase, determine the torque at synchronising. Mention the necessary assumptions.
Find the synchronous impedance and reactance of an alternator in which a given field current produces an armature current of 300A on short-circuit and generated emf of 40V on an open-circuit. The armature resistance is 0.1 ohm. To what induced voltage must the alternator be excited if it is to deliver a load of 100A at pf of lagging, with a terminal voltage of 300V.
Two identical 2000 kw alternator operates in parallel. The governor of the first machine is such that the frequency drops uniformly from 50 Hz at no-load to 48 Hz at full-load. The corresponding uniform speed drop of the second machine is 50 Hz to 47.5 Hz, What is the system frequency such that maximum load that can be delivered without overloading either machine?
A 3,000-kw 750-volt d-c 60-cycle six-phase synchronous converter is fed from a three-phase 23,000-volt high-voltage line through &bank of three transformers that are connected in Δ on the high side and diametrical on the low side. (A) Make a winding diagram showing all connections for the problem. Assuming an efficiency and power factor of 96percent and 0.95, respectively, calculate: (B) the direct-current output; (C) the a-c voltage between adjacent slip rings.
A 3-Phase 10Kva, 400 V, 50Hz star connected alternator supplies a rated load at 0.8 power factor lagging. If the armature resistance per phase is 0.5Ჲ and the synchronous reactance is 10Ჲ, using the e.m.f method, estimate the alternator’s voltage regulation
If, in a 3-φ alternator, a field current of 50Aproduces a full-load armature current of 200 Aon short-circuit and 1730 V on open circuit, then its synchronous impedance is ....... ohm.
Two alternators rated 400 MW and 600 MW are operating in parallel. The droop characteristics of their governors are 3% and 4% respectively from no load to full load. Assuming that the alternators are operating at 50 Hz at no load, how would a load of 1000 MW be shared between them? What will be the system frequency at this load? [Ans. G1 = 468.132 MW, G2 = 531.669 MW, f= 48.296 Hz]
QUESTION 1:- (a) A 4-pole, 3-phase, star-connected, 50 Hz synchronous generator, with a synchronous impedance of j24.5 Ω/phase and negligible resistance, delivers 5 MW of power to a 13.8 kV busbar. At this operating point, the excitation is equal to 1.8 p.u. Calculate the phase value of the generated emf (E) and hence calculate the electrical load angle, δ, at which the machine is operating. (b) Sketch a typical operating chart for a salient pole synchronous generator and on the chart identify the following; The Apparent Power limit, The field (excitation) limit, The Real Power limit, A line which represents a constant lagging power factor, The rotor angle for operation at any given point of operation, e.g. rated power and 0.9 power factor lag. (c) A Stamford HCI534F framesize generator has been selected for a stand-alone diesel-generation application. The generator is to operate at 400 V, 50 Hz, with the self-excited (SX) excitation scheme. Datasheet information can be…
Kindly solve the problem with step by step complete solution. Also, show the given and formula used. Thanks! Find the synchronous impedance and reactance in alternator in which a given field current produces an armature current of 250A on short-circuit and the generated emf of 1500V on open circuit. The armature resistance is 2 ohms.