Faraday. A square loop of wire with a side length of 1.35 [m] is in a uniform magnetic field that has an initial value of 3.50 [T]. The magnetic field is directed perpendicular to the plane of the loop, and is decreasing at a constant rate of 0.45 [T/s]. If the loop has a resistance of 7.50 [2], what is the current induced in the loop?

Faraday. A square loop of wire with a side length of 1.35 [m] is in a uniform magnetic field that has an initial value of 3.50 [T]. The magnetic field is directed perpendicular to the plane of the loop, and is decreasing at a constant rate of 0.45 [T/s]. If the loop has a resistance of 7.50 [2], what is the current induced in the loop?

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter20: Induced Voltages And Inductance

Section: Chapter Questions

Problem 56AP

See similar textbooks

Similar questions

A rectangular conducting loop is placed near a long wire carrying a current I as shown in Figure OQS1.3. If I decreases in time, what can be said of the current induced in the loop? (a) The direction of the current depends on the size of the loop. (b) The current is clockwise. (c) The current is counterclockwise. (d) The current is zero. (e) Nothing can he said about the current in the loop without more information.
(a) An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.00 T field with his fingers pointing in the direction of the field. Find the average emf induced in his wedding ling, given its diameter is 2.20 cm and assuming it takes 0.250 s to move it into the field. (b) Discuss whether this current would significantly change the temperature of the ring.
The current I through a long solenoid with n trims per meter and radius R is changing with time as given by dI/dt. Calculate the induced electric field as a function of distance r from the central axis of the solenoid.
A thin conducting bar (60.0 cm long) aligned in the positive y direction is moving with velocity v=(1.25m/s)i in a region with a spatially uniform 0.400-T magnetic field directed at an angle of 36.0 above the xy plane. a. What is the magnitude of the emf induced along the length of the moving bar? b. Which end of the bar is positively charged?
When a magnetic field is first turned on, t1 flux through a 20-turn loop varies with time according to m=5.0t22.0t ,where m is in milliwebers, tis in seconds, and the loop is in the plane of the page with the unit normal pointing outward. (a) What is the emf induced in the loop as a function of time? What is the direction of the induced current at (b) t= 0, (c) 0.10, (d) 1.0, and (e) 2.0 s?
A square, flat loop of wire is pulled at constant velocity through a region of uniform magnetic field directed perpendicular to the plane of the loop as shown in Figure OQ31.5. Which of the following statements are correct? More than one statement may be correct. (a) Current is induced in the loop in the clockwise direction. (b) Current is induced in the loop in the counterclockwise direction. (c) No current is induced in the loop. (d) Charge separation occurs in the loop, with the top edge positive. (e) Charge separation occurs in the loop, with the top edge negative. Figure OQ31.5
A truck is carrying a steel beam of length 15.0 in on a freeway. An accident causes the beam to be dumped off the truck and slide horizontally along the ground at a speed of 25.0 m/s. The velocity of the center of mass of the beam is northward while the length of the beam maintains an east-west orientation. The vertical component of the Earths magnetic field at this location has a magnitude of 35.0 T. What is the magnitude of the induced emf between the ends of the beam?
A uniform magnetic field is directed along the x axis. For what orientation of a flat, rectangular coil is the flux through the rectangle a maximum? (a) It is a maximum in the xy plane. (b) It is a maximum in the xz plane. (c) It is a maximum in the yz plane. (d) The flux has the same nonzero value for all these orientations. (e) The flux is zero in all cases.
(a) A nonferrous screwdriver is being used in a 2.00 T magnetic field. What maximum emf can be induced along its 12.0 cm length when it moves at 6.00 m/s? (b) Is it likely that this emf will have any consequences or even be noticed?
A truck is carrying a steel beam of length 15.0 m on a free-way. An accident causes the beam to be dumped off the truck and slide horizontally along the ground at a speed of 25.0 m/s. The velocity of the center of mass of the beam is north-ward while the length of the beam maintains an east-west orientation. The vertical component of the Earths magnetic field at this location has a magnitude of 35.0 T. What is the magnitude of the induced emf between the ends of the beam?
The bar in Figure OQ31.6 moves on rails to the right with a velocity v,. and a uniform, constant magnetic field is directed out of the page. Which of the following statements are correct? More than one statement may be correct. (a) The induced current in the loop is zero. (b) The induced current in the loop is clockwise. (c) The induced current in the loop is counterclockwise. (d) An external force is required to keep the bar moving at constant speed. (e) No force is required to keep the bar moving at constant speed.
A 2.00-m length of wire is held in an eastwest direction and moves horizontally to the north with a speed of 0.500 m/s. The Earths magnetic field in this region is of magnitude 50.0 T and is directed northward and 53.0 below the horizontal. (a) Calculate the magnitude of the induced emf between the ends of the wire and (b) determine which end is positive.