FAR/AMT Part 65 Perform 100 hour inspection Main rotor?

Q: The screens are fixed: * O At angle 45° to 60° to the direction of flow O None of these…

A: Given data in question  Screens To be discussed  Angle of inclination of screens   The screens are…

Q: Same elevation - Water T-10°C Machine A

A:

Q: 4 kN/m 9m 6 m B

A:

Q: Discuss about Pressuremeter Test (PMT)

A: The Pressure meter test consists of a pressure meter probe placed in the tested soil and gradually…

Q: Pipe Water Ah SG = 2.6 D = 30 mm Figure Q2 (a)

A:

Q: GIVEN D9N Dozer (Fig. 7.14) Move 2000 LCY Distance- 400 ft. (Fig. 7.14) Grade - 1% uphill (Table…

A: efficiency : The capacity to avoid wasting materials, energy, efforts, money, and time when…

Q: 1- Comment on your results. 2- Compare between the practical and theoretical results. 3- When is…

A: No circuit is given in the question, Do i just illustrated the following example. This circuit is…

Q: For the beam shown find the deflection at point B ft and D ft if El=2200kip.ft2 by using the…

A: Given:- A beam is given with point load acting on it  The magnitude of the point load = 12 kip  The…

Q: ble 12.2: r turbulent flow in pipes (sr

A: solution of above problem is below:

Q: What are Vaneaxial axial fans?

A:

Q: Find qu Via Terzaghi's equeatioms: JE ア-132 m C =15 ka/m A=20° %3D D=3 m CirCular Shape

A: Foundation is the last supporting part of the structure known as substructure. Footing/foundation is…

Q: A technician needs to drill a hole through a wall for a 1⁄2-inch fuel line. Thereshould be a…

A: Given- l=12inchlc=132inch

Q: aday.cwith following test data ohtained A= 45.4cm, L=20cm (hı= 160.2 Cm, hz-43 an) per min. find the…

A:

Q: Profile Level Notes: The elevation of BM A = 343.43' BS (plus sight) on BM A = 9.43' IFS (minus…

A: Given The elevation of BM A = 343.43' BS (plus sight) on BM A = 9.43' IFS (minus sight) on STA 0+00…

Q: Write down design procedure of unstiffened seat connection.

A:

Q: A pump is pumping water at a rate of 35O GPM with a TDH = 100 feet. The suction piping is 10inch…

A:

Q: A pump is pumping water at a rate of 350 GPM with a TDH = 100 feet. The suction piping is 10inch…

A:

Q: 200 ib 40olb 100 1b 3 ft 4 ft 1 ft 8 FT IFT

A: The above beam is supported on a point support. There are three concentrated load acting upon the…

Q: Describe about the vibrodisplacement procedure.

A: Vibro displacement is the ground improving method that is designed for compacting solid ground…

Q: AP (xx) 1 (x - q) 9. = A 4 de 1 a 2 a on sixes i ag

A:

Q: Akuminum rod E= 70 GPa G 26 GPa A 100 mm? a 23,6 x10c 20 N 0.5 m By Bearm ABC El-150 MNm Sm

A: Given:- E=7GPa G=28GPa A=100mm2 alpha=23.6 x 10 -5/oC To find:- deflection and rotation at point C

Q: The following are recording gauges except for: A Natural Siphon Type B symon's Gauge Weighing bucket…

A: Ans (1) Option (D) is correct Normal rainfall data is the average data of last 30 years which gets…

Q: gative f'c = 21.73 MPa. Use NSCP 2010. 150 mm 150 mm 200 mm 200 mm

A: As given fc=21.73 MPa fr=0.68fc=3.17 MPa   Calculating the section modulus:…

Q: No.3 No.10 bars -13 in. Minimum cover thickness per ACI 318-19 is 1.5 in. Flexural steel: four No.…

A: Minimum cover thickness: It is defined as the minimum thickness of concrete between the surface of…

Q: Sand IDft 810 pef 菁 Sand 8sat= 120 pcf f= 35°

A:

Q: Define Vibrocompaction.

A: Vibrocompaction is a method in which the density of granular soils is increased to the appropriate…

Q: FAP FBC, FeD | im Jam C \ookg 200kg 3m Im

A:

Q: Find intermal forcs atigon sudn Ca-a) V 6.17.3N looN/m M-boun.20m

A:

Q: s inciudes primary, secondary and worKing control on the jobsite. Referencing Control Vertical…

A: Referencing controls the primary secondary and working control on jobsite

Q: A 162-foot roll of #10 wire is used when installing a residential airconditioningunit. Lengths of 17…

A:

Q: ater is ejected from the water nozzle with a speed vo = 45.8 ft/sec. For what value of the angle 0…

A: Vo=45.8ft/sec

Q: == 200 GPa, w = 16kN/m,

A: solution of above problem is below:

Q: If the degree of saturated of a partially saturated soil is 60% then air content of the soil is a.…

A:

Q: GIVEN D9N Dozer (Fig. 7.14) Move 2000 LCY Distance - 400 ft. (Fig. 7.14) Grade – 1% uphill (Table…

A:

Q: Pipe the Compu

A: Given data Re=105 Given equation 1Cf=-0.4+1.74lnReCf

Q: من الله 유 | 3klf 20 ft Mmax=

A:

Q: ML² dmax 2EI

A: To find maximum deflection of cantilever beam loaded with moment at free end

Q: 5. Draw profile for AA'. 1500m A' A 2000m B' Øm 5000m

A: A contour is given, we need to draw the profile A-A Topographic Profile:- A topographic profile,…

Q: Interconnection of sewer service pipe into a sewer main is made by punching the sewer main a hole to…

A: answer:- On the top of sewer main Explanation :-  Interconnection of sewer service pipe into a…

Q: 3) In= 24-0" SIMPLY 8'-0" TYP SUPPORTED Kー 5000 psi %3D 29.5" ィ= 6o Ksi WOL= 1.25 KLF 3-#9 CHECK Et…

A: Answer We are given  Beam span = 24 ft f'c =5000 psi fy = 60 ksi Dead Load WDL = 1.25 K/ft Effective…

Q: Note: Concrete clear cover is 75mm. Hook end length is 125mm. Along X Along Y H REINFORCEMENT DEP TH…

A: It is given in the details that 8 no. of 12 mm diameter bars has to be placed on shorter span  And…

Q: D A 2m A siajoint method ind eCtss on men ber AB CD6D uring reds on 2. Find m leer Sedtion DATE:

A: The free body diagram of the truss is shown below.

Q: Date: 1 1 2m² for the turss Shown determi the forces in mebers BCA Hland Gl 30010 التاريخ : I H…

A: To find force in member BC,BI,GI

Q: please could someone show me how U2 = 1.98m/s. This is the correct answer but i've tried a few…

A:

Q: Problem 1 -38 Find the angle the surface tension film leaves the glass for a vertical tube immersed…

A: Given data,  Diameter of vertical tube = 0.25 inch Capillary rise = 0.08 inch Surface tension =…

Q: Evaluate: 1-cos(x) lim 3x?

A: Evaluating the above terms, we get :

Q: trickling filters.

A:

Q: ng data: Aluminum A = 2.6 sq. in Osi L = 17.3 in 1 °F E = 10519262 psi a = 12.73 x 106°F

A: To find the force in each bars -