5. Figure shows the schematic representation for the measurement of velocity ofair (density = 1.2 kg/m³) through a constant-area duct using a pitot tube and awater-tube manometer. The differential head of water (density = 1000 kg/m³)in the two columns of the manometer is 10 mm. Take acceleration due togravity as 9.8 m/s2. The velocity of air in m/s isFlow10 mm

Given data:Density of air, ρa=1.2 kg/m3Density of water, ρw=1000 kg/m3Differential head of water,…

Figure shows the schematic representation for the measurement of air (density = 1.2kg/m³) through a constant-area duct using a pitot tube and water-tube manometer. The differential head of water (density=1000 kg/m in the two columns of the manometer is 10 mm. Take acceleration due t gravity as 9.8 m/s2. The velocity of air in m/s is Flow

Figure shows the schematic representation for the measurement of air (density = 1.2kg/m³) through a constant-area duct using a pitot tube and water-tube manometer. The differential head of water (density=1000 kg/m in the two columns of the manometer is 10 mm. Take acceleration due t gravity as 9.8 m/s2. The velocity of air in m/s is Flow

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Two tubes are mounted to the roof of a car. One tube points to the front of the car while the other points to the rear. The tubes are connected to a manometer filled with a fluid of specific gravity of 0.62. The density of air is approximately 1.202 kg/m3 . When the height difference is 75mm, what is the car's speed?
Shown below is the water jet flow from a pressurized closed tank. The vertical distance between free surface and the jet nozzle is . The vertical distance between the highest point of the water jet and the jet nozzle is . The flow is steady and no energy loss is involved. The acceleration due to gravity is . The water's specific gravity is . Find the pressure at point 1________ A. -19.62 kPa (gage) B. -19.62 kPa (absolute) C. 19.62 kPa (absolute) D. 19.62 kPa (gage)
In the figure, CO2 with a density of 1.825 kg / m flows through the pipe. If the density of P1 = 170 kPa manometer liquid is 825 kg / m ^ 3; The pressure P2 and the volumetric flow of CO2. calculate.
A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. Choices are listed below and draw its FBD. A.-4.67 m B.-2.72 m C.12.74 m D.2.56
2. The pressure of water in a pipeline was measured by means of a simple manometer containing mercury. The mercury level in the open tube is 150 mm higher than that of the left tube. The height of water in the left tube is 48mm. Determine the static pressure in the pipe in a).kN/m^2. b) Head of water in meters, A. The static pressure in the pipe in kN/m^2? B. Head of water in meters =
Oil with specific gravity of 0.75 is flowing through a 6 inch pipe under a pressure of 15 psi. If the total energy relative to a datum plane 8 ft below the center of the pipe is 58.6 ft-lb/lb. Determine the discharge of oil.
Two tubes are mounted to the roof of a car. One tube points tothe front of the car while the other point to the rear. The tubeare connected to a manometer filled with fluid of specificgravity 0.6. When the height difference is 2 inches, what is thecar’s speed in miles/hr?
A U-tube differential manometer is connected to two pipes at A and B. Pipe A Contains oil of density 1400 Kg/m3 and pipe B is carrying fluid of density 850 Kg/m3. If the pressure at point A is 195 kN/m2. Find the pressure at point B for the following data h1=11 cm, h2=7.5 cm and h3=23.5 cm. The specific gravity of mercury is13.6?
A 118-mm-diameter pipe enlarges to a 149-mm-diameter pipe. At section 1 of the smaller pipe, the density of gas in steady flow is 264.656 kg/m3, and the velocity is 23 m/s; at section 2 of the larger pipe, the velocity is 15 m/s. Find the unit weight (in kN/m3) of the gas at section 2. Round off to three decimal places.
The initial reading differential manometer shown is exposed to the atmosphere at end B. a) Calculate for the pressure in pipe A and the pressure of the air inside the manometer. Express your answer in Pascals. b) Briefly explain why liquid manometers should be checked for air bubbles before being used. SG (pipe fluid)= 0.887 SG (manometer fluid) = 1.05 c = 22 cm d = 17 cm e = 25 cm
Convert 400 N-m/sec to HP
An industrial fan delivers 55,000 CFM of air through a discharge duct with a size of 3 ft x 4 ft where the static pressure is 6-inch water gage. At the inlet, the duct diameter is 4 ft and the static pressure is 1-inch water gage. The temperature of the air is 78 F and barometric pressure is 14 psia. (ρw = 62.2 lb/ft³). Determine: a). the total pressure in feet of air b). the static power in HP c). the fan power in HP