Fill in the blanks: A satellite in space is of 2m diameter and internal heat generation is 2000 W. If it is protected from direct solar radiation by earth's shadow determine its surface temperature. °C

Fill in the blanks: A satellite in space is of 2m diameter and internal heat generation is 2000 W. If it is protected from direct solar radiation by earth's shadow determine its surface temperature. °C

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.31P: A spherical communications satellite, 2 m in diameter, is placed in orbit around the earth. The...

See similar textbooks

Related questions

Q: Chips of width L_15 mm on a side are mounted to a substrate that is installed in an enclosure whose…

Q: Q2/A vertical cylinder having a length of 30 cm is maintained at 100-C and exposed to room air at…

Q: Determine the thermal conductivity of water vapor at 174°C.

Q: A very long semicylindrical furnace has a radius of 2 m. The curved top surface, whose emissivity is…

Q: A spherical interplanetary probe of 0.5-m diameter contains electronics that dissipate 150 W. If the…

A: Given data: Diameter of the probe d = 0.5 m Rate of energy dissipate Ein.=150 W Emissivity ε=0.8…

Q: determine the thermal resistance of three concentric cylinders of radious r1, r2, r3

Q: An industrial spherical oven has 2.8 m diameter. It is placed in a factory floor where the air…

A: Given: D = 2.8 m, Therefore R = 1.4 m Ta = 25 oC = 25 +273 = 298 K Qpeak load = 905 kW Ts,…

Q: Natural Convection Cooling of an Orange.An orange 102 mm in diameter having a surface temperature of…

A: GivenTw=21.1°CTD=4.4°CD=102mm=0.102mR=0.051m

Q: Calculate cooling load using the CLTD for roof No. 2 with suspended ceiling has an area of 100 ft²…

A: CLTD stands for Cooling Load Temperature difference. Given, Area A = 100 ft2 Indoor Temperature Ti =…

Q: A spherical interplanetary probe of 0.5 m diameter contains electronics that dissipate 150 W. If the…

A: Calculate the surface area of the probe A= 4 πr2 4 π (0.5/2)2 =0.7854m2

Q: A solid sphere 1 of radius r is placed inside a nollow, closed hemispherical surface 2 of radius 4r.…

A: Given data as per question Diameter of surface 1=2r Diameter of surface 2 =8r F11+F12=1F12=1Because…

Q: A very long semicylindrical furnace has a radius of 2 m. The curved top surface, whose emissivity is…

A: Given data as per questionr=2mFor Top surfaceε1=0.75Q1A1=8000W/m2For Bottom…

Q: , electrical power consumed by the hot plate will be?

A: Given: Tr=297 K Tp=403 K D=250 mm emmisivity=0.8 To determine: The electrical power consumed

Q: Consider a shed with an 8-ft×12-ft base and 4-ft height. The temperature of the outer surface of the…

A: Given DataTi=?To=20+273=293KTo1=273+0=273KA=8×12 ft2dx=4ft

Q: A circular grill of diameter 0.35 m and emissivity 0.7 is maintained at a constant surface…

Q: A horizontal steam pipe with an outside diameter of 60.0 mm passes through a large room whose walls…

Q: Driving force for the free convection is Shear stress forces Buoyancy forces None of the above…

A: This question is from heat transfer.

Q: JA: Draw the thermal network for a single cover glass flat plat solar collector (a) in terms of…

Q: Consider a shed with an 8-ftx12-ft base and 4-ft height. The temperature of the outer surface of the…

A: Write the expression of rate of heat loss from the building.…

Q: A large isothermal enclosure containing two small surfaces (surface A and surface B) is shown in the…

A: Given: Irradiation = 10000 W/m2

Q: 3. Compute for the Nusselt value of a natural convection in a small holding tank with a heating…

Q: An aluminum alloy (2024) plate, heated to a uniform temperature of Ti = 230°C, is allowed to cool…

A: Given that, Temperature of aluminum, Ti=230 °C,Ambient air, Tair=T∞=29 °C,Thickness of plate, t=16…

Q: A 2-m-diameter thin-walled stainless steel spherical tank is filled with chemicals undergoing a…

A: Given data as per question Diameter =2 m Surface temperature = 500 c Air temperature = 200 c…

Q: A metal ball with 0.15 m diameter contains heat source that dissipate 75 W. If the ball has an…

Q: The glass surfaces are polished, having an emissivity of 0.095. The diameters of the inner and outer…

A: The heat transfer coefficient due to radiation through the cylindrical surface from the inner to the…

Q: A small, oxidized, horizontal metal tube with an OD of 0.0254 m (1 in.), 0.61 m (2 ft) long, and…

Q: A greenhouse 20m long and 15m wide has a nearly flat roof 3m above the floor level. When the sun is…

A: Given data: L=20 mw=15 mh=3 mQ0=1000 W/m2ε1=0.9QCon=0.8QRad Need to determine the temperature of the…

Q: (a) Look at planet earth in space as part of the solar system: is the earth in space an isothermal…

A: (a)Earth in Solar System :

Q: A circular grill of diameter 0.15 m and emissivity 0.7 is maintained at a constant surface…

A: Given: Diameter of the cricular grill D=0.15m Emissivity=0.7 Surface temperature Ts=137°C or 410K…

Q: A steel plate is 0.3 m long, 0.1 m wide and 0.012 m thick. The plate is placed on a heating plate of…

Q: A geodesic dome constructed with an aluminum frameworkis a nearly perfect hemisphere; its diameter…

A: Given Data Diameter, d=55 m Temperature, t1= -15oC, t2=35oC. Here, the volume of geodesic dome is,…

Q: An 5-m·internal-diameter spherical tank made of 1.5-cm-thick stainless steel (k = 15 W/m·C) is used…

Q: An astronaut is at work in the service bay of a spacecraft and is surrounded by walls at -100oC. The…

A: Given data: A=3 m2T1=0+273=273KT2=-100+273=173Kε=0.05 Need to determine the rate of heat loss and…

Q: A limited amount of water in a container is subjected to 5 W/m2K convection condition as the sky…

A: radiation heat transfer In general, the radiation heat transfer from one surface to another is the…

Q: To improve indoor air quality, an Edinburgh pub has installed a vertical glass screen to cover the…

Q: T.- 100 °C Vacuum T. = 20 °C Figure 1.17 Problem 1.12 Two walls facing each other are thin, very…

A: The ratio of the temperature difference between two sides of a material to the rate of heat flow per…

Q: - (5 points) A surface of area 0.5 m², emissivity 0.8, and temperature 150 C 1s placed in a large…

Q: A manufacturing factory located at 30° N latitude has a window area 35 m2 that consists of double-…

Q: Consider a shed with an 8-ftx12-ft base and 4-ft height. The temperature of the outer surface of the…

A: Write the expressions of heat loss from the all 4 walls. Qw=2×σεAw1+Aw2Twall4-Toutside4

Q: Calculate the radiant heat loss per unit length, if the surface emissivity is 0.65.

Q: A certain body at 20C is displayed on a top of a building during the night. The body sees nothing…

A: Given Data The temperature of the body is: Tb=23°C=296 K The temperature of the sky is: Ts=110 K…

Q: Q2/A vertical cylinder having a length of 30 cm is maintained at 100-C and exposed to room air at…

Q: In Gaziantep, many people use the energy of the Sun for heating their domestic water used for having…

A: Here given,Solar radius=R3=7 X 105km=7 x 105 x 103m= 7 x 103mTemperature of the surface of the…

Concept explainers

Radiation

Radiation can be described as the energy in the form of a particular matter or electromagnetic waves traveling in the air and can be in the form of light, sound, and heat. Radiation can be detected through special instruments like X-rays. The radiation from a cooler object is less intense as compared to the radiation from hot objects.

Question

Fill in the blanks:
A satellite in space is of 2m diameter and internal heat generation is 2000 W. If it is protected from direct solar radiation by earth's
shadow determine its surface temperature.
°C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1.11 Calculate the heat loss through a glass window 7-mm thick if the inner surface temperature is 20°C and the outer surface temperature is 17°C. Comment on the possible effect of radiation on your answer.
1.13 If the outer air temperature in Problem is –2°C, calculate the convection heat transfer coefficient between the outer surface of the window and the air, assuming radiation is negligible.
Using Table 1.4 as a guide, prepare a similar table showing the orders of magnitude of the thermal resistances of a unit area for convection between a surface and various fluids.
An electrical transmission line of 1.2-cm diameter carries a current of 200 amps and has a resistance of 310-4 ohm per meter of length. If the air around this line is at v, determine the surface temperature on a windy day, assuming a wind blows across the line at 33 km/h.
1.29 A spherical interplanetary probe with a 30-cm diameter contains electronic equipment that dissipates 100 W. If the probe surface has an emissivity of 0.8, what is its surface temperature in outer space? State your assumptions in the calculations.
Determine the rate of heat transfer per meter length from a 5-cm-OD pipe at 150C placed eccentrically within a larger cylinder of 85 magnesia wool as shown in the sketch. The outside diameter of the larger cylinder is 15 cm and the surface temperature is 50C.
The air-conditioning system in a Chevrolet van for use in desert climates is to be sized. The system is to maintain an interior temperature of 20C when the van travels at 100 km/h through dry air at 30C at night. If the top of the van is idealized as a flat plate 6 m long and 2 m wide and the sides as flat plates 3 m tall and 6 m long, estimate the rate at which heat must be removed from the interior to maintain the specified
Determine the power requirement of a soldering iron in which the tip is maintained at 400C. The tip is a cylinder 3 mm in diameter and 10 mm long. The surrounding air temperature is 20C, and the average convection heat transfer coefficient over the tip is 20W/m2K. The tip is highly polished initially, giving it a very low emittance.
A person wearing a heavy parka is standing in a cold wind. Describe the modes of heat transfer determining heart loss from the person's body.
Three thin sheets of polished aluminum are placed parallel to each other so that the distance between them is very small compared to the size of the sheets. If one of the outer sheets is at 280C and the other outer sheet is at 60C, calculate the temperature of the intermediate sheet and the net rate of heat flow by radiation. Convection can be ignored.
A geodesic dome constructed with an aluminum frameworkis a nearly perfect hemisphere; its diameter measures 55.0 m on a winterday at a temperature of -15°C. How much more interior space does thedome have in the summer, when the temperature is 35°C?
Calculate the heat loss through a 1-m by 3-m glass window 7mm thick if he inner surfacetemperatures is 20C and outer surface temperature is 17C. Sketch the figure.