Find current I in the circuit below 22 j4 2 12 Ω j4 2 ww a j6 2 50/0 -j3 2 U8

Q: A) Briefly explain the effect of increasing the modulation index value on power efficiency in Full- ...

A: According to the question, we need to discuss  A) Briefly explains the effect of increasing the modu...

Q: Q 2. What current flows through the Zener diode? 1.8 k Iz 15 V Vz = 12 V

A:

Q: What is the RMS value of the voltage v(t) 2 cos(3nt + )? O 1.41 V O 1.0 V 2.0 V 2.82 V

A: if the sine signal is of the form Vmcos(wt+θ) than peak value of the signal = Vm. RMS value of the s...

Q: inductive reactance of 8 ohms i ch a capacitive reactance of 18 o then connected in series with a v ...

A:

Q: QUESTIÓN 28 In order to select the chip A19-A15 must be set to (Give only the five binary bits.) B. ...

A:

Q: A sinusoidal voltage with maximum value (336 V), and a Frequency its value (50 Hz), was applied on a...

A:

Q: 9. The strength of longitudinal joint in Fig. 1-17 is 33.3 kips/ft, whereas for the girth is 16.1 ki...

A: Internal pressure, P=150.3 psi=150.3 lbin212 inft2=21643.2 lb/ft2  

Q: Q2 A real diode for which the forward voltage drop is 0.7 V at 2.0 mA, what would be its current whe...

A:

Q: Use kirchhoff's laws to find the branch

A:

Q: 4. Does the frequency deviation depend on the frcquency of the information signal? 5. Give some prac...

A:

Q: Consider the signal x(t) and its Fourier transform X(@). The signal x(t) is given by x(t) = 311(t – ...

A:

Q: An RL circuit has an emf of 5V, a resistance of 502, an inductance of 1 H and no initial current. Fi...

A:

Q: 1. Design a voltage regulator that will maintain an output voltage of 20 V across a 1-k load with an...

A:

Q: Q 2. What current flows through the Zener diode? 1.8 k2 Iz Vz = 12 V 15 V

A:

Q: Problem 1: Question 1. Consider the circuit below: 2 kn ww 1:10 10 :1 V1 120 V R2 1 kN ww 2 kl What ...

A: The solution is given below 

Q: The voltage v = 207 sin(100t+50°) V is connected acroos a 5-H inductor. Determine the inductive reac...

A: Inductive reactance  = wL  Where w is the frequency in rad/second  and L is the frequency.   

Q: Determine the current in the following circuit: R = 50 R2 = 20 V= 10V O- 24 R- 40 iz

A:

Q: For a BJT transistor if VCC-8V, VCE= 8V, the transistor will operate in ------ region O cutoff activ...

A: BJT and MOSFET are the class of transistors used in analog electronics. They are widely used nowaday...

Q: ( Notes Done How many GPS Satellites are present?

A: A message signal is transferred from the sender to the receiver end. The signal is transmitted throu...

Q: 2Vx jia -jia2 I2 I4 12 220°A 1220° v 10 V 220°A Ii

A:

Q: A long-shunt compound generator delivers a load current of 50 A at 500 V and has armature, series fi...

A:

Q: 1. Construct the half-wave rectifier circuit as shown. 2. 3. Monitor the input voltage using the osc...

A: The rectifier is used to convert the alternating current into a direct current. The half-wave rectif...

Q: (9) The hysteresis losses in electrical machines reduced. a- By core lamination. b- By core isolatio...

A: 9) The hysteresis losses in electrical machine can be reduced by using material having least hystere...

Q: PROBLEM: Find the equivalent transfer function, T(s) = C(s)/R(s), for the system shown in Figure 5.1...

A:

Q: Q5: Choose the correct answer from the following: a. The first order system reaches 98% of its final...

A: for first order systems , output response= final value×1-e-tT where t is time and T is time constant...

Q: Draw the diagram of a full wave bridge type power supply circuit in your own words discuss in detail...

A: The full-wave bridge type power supply circuit is shown below:

Q: Determine ly using current division. Ty 20V

A: Given a circuit of voltage source 20 v and we need to find the branch current through 4 ohm resistor...

Q: 2. Consider the causal system defined in Eq. (1) 1 y[n] – 5yln – 1] + uln – 2] = r[n] + r[n – 2] + x...

A: As per our guidelines we are supposed to be answer the first three questions.  Kindly repost the oth...

Q: Evaluate the following integrals: 8. a) Lf(T)8(t -t)dr 8, c) L8(t)e-ie" dt -jot -00 b) L8(t)f(t-t)dt...

A: We need to solve given function

Q: A group of cells consisting of four rows connected in parallel, each row containing five cells conne...

A:

Q: Determine the Q-point, and find the maximum peak value of base current for linear operation. Assume ...

A:

Q: Realize the given function with 2-input basic gates only

A:

Q: Write the Boolean Expression of the truth Table of 2-1 Multiplexer 2. Write the Boolean Expression ...

A:

Q: 2. Find the Norton equivalent of the circuit in Fig. 6Ω o a 6A 6Ω

A:

Q: From the given Ammeter diagram, the span is -- A. J0407 A a. -1 O b. 4 О с. 3 o d. -1 to 3

A: Given, Ammeter diagram  

Q: Determine the voltage across capacitor #3 (C3)?   Select one: a. 7.2 volts b. 6.36 volts c. 5.65...

A:

Q: 90 ampere current flows into two parallel resistors having resistances of 12 and 24 ohms. Determine ...

A:

Q: 1. Calculate the total current in the following circuit. 10 Ω A. 0.37 A B. 1.8 A C. 20 A D. 27 A 10 ...

A:

Q: How many circuits are required to accommodate eight (8) 250w Metal Halide lamps?

A:

Q: Using thevenin theorem, determine the charge and discharge equivalent circuits for the Figure 4. ske...

A: Brief description : Here in the question they have mentioned a transient circuit which consists of r...

Q: if a solenoid wire is 100ft long

A: Magnetic field - This line which shows the interaction between the movement of electric charges and ...

Q: Obtain the transfer function of the given electrical system below expressed in Laplace form s. Let i...

A:

Q: True or False: AC is defined as the "unidirectional" flow of current; current only flows in one dire...

A:

Q: How many serial ports (UARTS) pins are there on the MEGA 2560 board? O 10 04 0 8 O 12

A: Brief description: Generally microcontrollers are used in digital circuits. Microcontroller have an ...

Q: 1. Use Gauss-Siedel iterative method to find V2, perform one iteration 2. If V2-0.98 pu, find the ma...

A: The Gauss-Seidel technique, commonly known as the Liebmann method or the method of successive displa...

Q: 11. F = A'B'C'D' + ABC + ACD + ABD

A: The solution is given below 

Q: For the circuit given below, assume Vcc= 15V, Rc= 18 KΩ, RE= 8.6 KΩ, RB1= 160 KΩ, RB2= 100 KΩ, β=100...

A:

Q: 1. How can you draw the spectrum of FM?

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please su...

Q: 4. Bundling of conductors in a transmission line reduces the risk for corona. Also, it: a. Reduces t...

A: As per bartleby guideline for more than one question asked only first is to be answered please uploa...

Q: Find the total energy stored ( in units of mJ) in the group of capacitors shown below given that the...

A: Brief description : Capacitor is an electrical element which is used to store charges in the form of...

Superposition Theorem

The superposition theorem is applied to linear systems. For such systems, the output from two different inputs equals the sum of the outputs from each input separately. On applying this theorem many times we get the output from any number of inputs equal to the sum of the outputs from the individual inputs separately.