Find ID and VDS
Q: 2. 1. Find the equivalent impedance. 11-31-2 m 1522 mo J252 ZIR
A: Given circuit, there
Q: 40V M. 5 R2. 20R3² 12- M 8 R₂ I3
A: Note : In the given question breadboard is practical based which is not possible to implement…
Q: Explain different methods of speed control of induction motor drive.
A: Different speed control methods of induction motor are as follows- 1. Change the applying frequency…
Q: A first order system has a delay time of 2.6 sec, find the system time constant. 3.75
A: Given, A first order system has Delay time, td=2.6 s
Q: b-Two aluminum and copper wire resistors consume 0.5 W when connected in parallel to 2 V DC supply.…
A:
Q: A resistance R and a 4µF capacitor are connected in series across a 220V dc supply. Across the…
A:
Q: Find the F.T. of the fall wing Signals (functions) f(t) = 3 Sgh (st) - - 1+jt aus: F(W) = {w-ze гпеш…
A: Fourier Transform is used to analyze the frequency response of non periodic signal Fourier series…
Q: 7.35 Find the solution to the differential equation 2dy (1)/dt+ 3y(t) = x(t) if (a) x(t) = 2te, with…
A: Given data : The differential equation is, 2dytdt+3yt=xt, if (a). xt=2te-t with initial condition…
Q: Electrical Engineering a light beam illuminates a detector made of n type silicon with doping…
A: A light beam illuminates a detector made of n-type silicon with doping Nd=9.3×1016 cm-3 such that…
Q: A series circuit of 27 ohms, 3.06 Henry Inductor and 0.0172 capacitor are energized by 700 Volts DC…
A:
Q: Find the F.T of the following Signals (functions) C. f(t) = 35gn (3t) 1 jt d. f(t) = 1 + cos (6H+ +…
A: Solution is attached with this notes. Thank you. (I feel there are errors in the final answer…
Q: Referring to Figure 1 below, answer the 2 15 1 05 0 05 -15 10 questions below. 2 15 1 05 0 15 10 12…
A:
Q: What is the percentage error? Slope of the line: 0.18 A Constant Current: 0.20 A
A:
Q: Determine the quality factor of the series RLC circuit. R = 35 ohms, L = 1.4 H, C = 7.4 µF. (Use 2…
A: Given, A series RLC circuit have R=35 ΩL=1.4 HC=7.4 μF
Q: vi) Calculate the value of V. Define element.
A: In this problem we apply KCL :
Q: A series RLC circuit is connected to a 400-hZ line with an applied voltage of 35.678 V. The resistor…
A: An RLC circuit consists of a resistor R, an inductor L, and a capacitor C connected either in series…
Q: 1. How to solve differential equation using transform method
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: The switch in the circuit in Fig. P7.1 has been closed for a long time before opening at t = 0. a)…
A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…
Q: 125. If voltage is equal to twice its original value, what is its corresponding change in dB? a. 3…
A: The Given is equal to twice its original values, To find corresponding change in dB.
Q: In a common base connection, a = 0.95. The voltage drop across 2 k resistance which is connected in…
A: Given, α=0.95V2kΩ=2 V
Q: 3. Consider the system shown below. M(f) (the Fourier transform of m(t)) is also shown. M (f) y(t)…
A:
Q: ALII system has H(W) = 4+jw 2 find the D.E. 6 +5jw-w² -relating the input x++) and the output y(t),…
A:
Q: Find the E.T. of the following periodic signal. -2 -1 1 2
A: Fourier series is used to analyze the frequency response,Harmonics content and Total Harmonics…
Q: In the circuit given below, V=7 V. Determine the current through the 10-kΩ resistor. V Μ 4 ΚΩ M 3 ΚΩ…
A: Given circuit, Here V= 7 Volts
Q: Vs Is Find R Rx www www 4Rx Sources Vs Is Value 20 V 7.937 mA www 2Rx
A: Given, VS=20 VIS=7.937 mA
Q: Find the E. T. of the following periodic signal -2 2
A: Given: Required: Fourier transform of the above given periodic sawtooth wave.
Q: (4) Find the F. T. of the following Signals using differentiation pro TAMIFCE* <-2 2 2 ww t Ans F(w)…
A: In this question, We need to determine the Fourier transform of the given signals. We are solving…
Q: What is the real component for the equivalent impedance, Zeq, for the following circuit if = 790…
A: Given data, ω=790 rad/s
Q: (+ -15V 15V U1 VEE 741
A: Given data, Input is given, vi=12V, 6 V, 0 V, -6 V,-12 V Circuit diagram is given as,
Q: 5. Find the F.T. of the following periodic signal 3 -2 2
A:
Q: R(5) K G(S) (5+2) (5+3) [S+5) (S+20) H(S) = 1 ((s)
A:
Q: Why transformer rated in KVA ?
A: Transformers are a type of energy converter that move power from one side of a circuit to another…
Q: Design an open loop comparator to provide the following logic: Vo = 13 V for Vi > 7.5 V Vo = -13 V…
A:
Q: Inputs A B DA DB R₁ TR₁ +Vcc HI R₂ Outpu Ov
A:
Q: A 60μF capacitor in series with a voltmeter of 100000 resistance is connected across a 120-volt…
A: A 60uF capacitor in series with a voltmeter of 10000 ohms resistance is connected across a 120-volt…
Q: For the circuit shown below, find the following and show your detailed solution: Knowing that…
A:
Q: find the inverse laplace of ( s + 18 )/( s^2 + s - 6 )
A: Given: s+18s2+s-6 Required: Inverse Laplace Transform
Q: -2 How did he get the value inside the circle X(t) = 1-t 1-t W₁ = 2 = 211 = xt) = 1-+ 1 ao = = [² x…
A:
Q: Explain the DC power internal structure.
A: DC or Direct current Direct Current (DC) Power is the unidirectional flow of electrons and is the…
Q: Find the F.T of the following Signals (functions) C. f(t) = 35gn (3t) 17;t d. f(t) = 1 + cos (6H+ +…
A:
Q: 4.Write 10 Difference between squirrel cage and slip ring with your own words...
A: Construction-wise, induction motors are straightforward and robust. The strength and adaptability of…
Q: In the circuit below Vin(t) = 10V, and has been present for a very long time. in $1 1 Ω In 2 1F HH…
A: For the above given circuit diagram we need to derive the instantaneous voltage expression for both…
Q: A 220V DC shunt motor draws a no load armature current of 2.5A when running at 1400 rpm. Determine…
A:
Q: 2 Find the F.T. of the following Signals (functions) C. f(t) = 35gn (3t) 1 jt d. f(t) = 1 + cos (6H+…
A: For the given time domain signals we need to calculate their fourier transforms by using the…
Q: Figure 4: For question 8 R1-100 ΕΞ ww R4 = 300 8. What is the total circuit resistance? R2= a) 35…
A: 8) Given data, R1=10 ΩR2 =20 ΩR3=20 ΩR4=30 Ω 9) R1=100ΩR2=200 ΩR3=100 ΩR4=150 ΩR5=100 ΩR6=300 Ω 10)…
Q: Generación 16 Región 1 Generación 1:10 Línea de transmisión Sistema de distribución residencial…
A: LetPrimary turns= N1Secondary turns =N2Primary current=I1Secondary current=…
Q: What is the resultant of vector A=2i +2j, and vector B= -2i+lj Select one: a. 3.5 b. 3 C. 5√2 d. √26…
A: Given data, A=2i+2jB=-2i+1j
Q: iii) A three-phase, 50Hz, 6-pole induction motor runs at 950 rpm. Calculate a) the synchronous speed
A:
Q: Discuss the stability of the system modeled by the following transfer function $+8 H(s) S³+58² +68…
A: Given data, Transfer function Hs=s+8s3+5s2+6s
Q: 20.a. What's the primary disadvantage of using copper conductors? A. Durability B. Cost C.…
A: 20. (a) Although one of the most electrically conductive materials known, copper is easily corroded…
Find ID and VDS
Step by step
Solved in 4 steps with 3 images
- 12. 7.46 PSPICEMULTISIM The switch in the circuit in hasbeen in position 1 for a long time. At t=0 it moves instantaneously toposition 2. How many milliseconds after the switch moves does voequal 100 V?A coil of inductance 2 Henrys and a resistance of 10 ohms is connected with an emf, E=200sin20t volts, where t is the time in seconds. I=0 when t=0. Find I when t=0.05 second.Power Electronics: According to the information obtained from the catalog, the threshold voltage value and internal resistance of the thyristor:V = 2v, R=0.84 milliohm,The current given in the figure passes through this thyristor. Wave information:Im = 1000 AD = 20f = 200hzWhat is the active power consumed on this thyristor in watts?A)184.6B)97.8C)284.3D) 382.5E) 137.2
- The voltage and current at the terminals of the circuit element are zero for t<0. For t≥0 they are v = ( 10,000t + 5 ) e−400t V, i = ( 40t + 0.05 ) e−400t A. Find the total energy delivered to the element in microjoules.A. Calculate iΔ B. Calculate V0 55V = v_g Please answer ASAPDetermin the electric field intensity at (4,-3,1) due to Ps1 = -6nC/m2 at y= -6 Ps2 = 4nC/m2 at y= 6 Ps3 = 5nC/m2 at y=-4 a. -282 ay V/m b. 271 ay V/m c. 329 ay V/m d. -282 az V/m
- circuit theory please I need the answer through 25 min, I do not have time more than 25 min Question 3) if a=166, b=27, c=3 and d=35, then find Zin for the above circuit. a. Zin = 996,00 + j213,14 ohm b. Zin = 664,00 + j267,14 ohm c. Zin = 863,20 + j186,14 ohm d. Zin = 1328,00 + j321,14 ohm e. Zin = 1660,00 + j294,14 ohm f. Zin = 1660,00 + j429,14 ohm g. Zin = 1460,80 + j280,64 ohm h. Zin = 1195,20 + j483,14 ohmA voltage e(t) = 100 sin 314 t is applied to a series circuit consisting of 10 ohmsresistance, 0.0318 henry inductance and a capacitance of 63.6 μF. Determine:a. Expression for i(t)b. Phase angle between voltage and currentc. Power factord. Active power consumede. Peak value of pulsating energyThe voltage and current at the terminals of the circuit element are zero for t<0. For t≥0 they are v=100e−50t sin 150t V,i=20e−50t sin 150t A. Find the power absorbed by the element at t=20 ms.
- 9-) Given a potential. Find the energy in the volume 0 <x, y, z <2m One of these answers: 18.70 µJ 14.17nJ 14.17µJ 18.70 nJ) A dielectric material, which has relative dielectric constant εr is 4.8 and dissipation factortanδ=0,001 at 50Hz is considered. For the electrical field of E=60kV/cm calculate dielectricloss (P) dissipated as heat (Watt/cm3on this dielectric material.When can an ac-voltage, v = 120 sin120πt reach its first peak? a. 4.167 μs b. 8.334 μs c. 4.167 ms d. 8.334 ms