Find Ix

Q: 3. Verify conservation of complex power for this rms phasor circuit. +j4 2 23 9/+ 1520° V - j22

A:

Q: 16. What does the sampling theorem tell us concerning the rate of sampling required for an analog si...

A: 16. Sampling theorem is used to sample the analog or continuous signal into discrete signal by the p...

Q: xplain what is meant and the function of virtualenv.

A: Virtualenv is a tool for building a virtual python environment. The virtual environment that is crea...

Q: (a) Determine the node voltages for the circuit shown. (b) Calculate the current through the indicat...

A:

Q: .A 10 kW, 250 V Shunt motor has an armature resistance of 0.5 ohm and a field resistance of 200 ohm....

A:

Q: Solve for the V0

A: The diode will conduct only during the forward bias and it will not conduct during the reverse bias....

Q: 1. for a given system whose input (x), output (y) relationship is given as (1) = Jx(7+ I)dr t-2 , ev...

A: a. Integral signals are always linear. Integral signals satisfy homogenity and additivity. b. It is ...

Q: In balanced star (wye) connected system, the line voltage is 0 707 times the phase voltage phasor su...

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Q: Draw the Circuit with Multism

A: The circuit can be designed with the multisim and all the parts are available in the multisim librar...

Q: 8. In the network, find the value of Z. for maximum power transfer. The load impedance has both vari...

A:

Q: Use Kirchhoff's Laws to find the branch currents indicated in the following networks

A: In this question,  We need to determine the branch current using the Kirchhoff's Laws.   

Q: 2. Solve for the transfer function

A:

Q: The current through the inductor has the form: t1

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: A capacitor of 2 µF is charged by a 100 V battery. Calculate the energy in the capacitor. If the cap...

A:

Q: For an unmodulated carrier amplitude of 16Vp and a modulation coefficient of m 0.4, determine the am...

A: The modulation index is the ratio of amplitude of message signal to amplitude of carrier signal.

Q: H.W. Find V, in Fig. below using (a) nodal analysis and (b) mesh analysis. 24/0 v j42 j2N 4Ω. 10/0°v...

A: In this question,  We need to determine the voltage Vx using the nodal analysis and mesh analysis.  ...

Q: In the given figure, Find its peak carrier amplitude of the amplitude modulated waveform.

A:

Q: A current-to-pressure transducer is used to convert a 4-20mA electronic signal into a 3-15 PSI pneum...

A:

Q: Vi Vo

A:

Q: I1 0.5Vx j20 A,077 Vx 12 Ix I2 )420°A 1Ix -jia2 I3 ell HE

A:

Q: 1.What is the overall frequency division factor when obtaining 1 Hz from 60 Hz for a digital clock a...

A: The solution is given below 

Q: v. In three phase system, the two Wattmeters meter method can be used to measure in two phases (b) T...

A: In this question we will write about two wattmeter method and low pass filter...

Q: In Non-Inverting Amplifier, if you change the. input voltage from 1Vp-p to 2Vp-p, Rf= 250K to 200K, ...

A: It is given that: Vin=2VppRf=200kRin=100k

Q: All of the diodes in the following circuit are Silicon w/ forward voltage 0.6V. Determine the value ...

A: The diodes are made of semiconductor materials. Silicon and germanium are common semiconductors for ...

Q: Preference setting is used for controlling what parameter of a generating system and who will take c...

A: The real world demands the analysis and design of complex systems. It is possible with the clear und...

Q: reactive power must this capacitor

A: Capacitor- This circuit element absorbs lagging power from the source or we can also that it deliver...

Q: j42 ll a I2 j20 0.5Ix 1020°v I3 d I1 b 62 -j 32. I4 8 20°v '1220°v Ix ell

A:

Q: Determine i si la Fuente es de 15v. Rr = 60 Ry = 40 %3D Re= 100 A OM R = 80 R9 = 60 REa R2 = 80 R1p ...

A:

Q: 100 H(jm) (fo) (Jw2 + 1)

A: Solution-   H(jW) = 100jw2jw2+1 The corner frequencies,   Wc1  =0 rad/secWc2 =1 rad/sec  The initial...

Q: A 3-phase, 12-pole, star-connected alternator has 180 slots with 10 conductors per slot and the cond...

A: In this question,  A 3-phase, 12-pole, star-connected alternator slot S=180 slots with 10 conductors...

Q: In the voltage divider below, what should be the specific resistance of R2 so that the output voltag...

A:

Q: 3. Show another circuit connection of a positive clipper circuit(together with its output waveform t...

A: Whenever the anode voltage exceeds the cathode voltage, the diode is shown to be forward biassed.

Q: Design 3: Consider a single input 2 output network shown in Fig. 2. The available components are a s...

A: Cascade network: When two or more than two networks are in tandem then this type of network is calle...

Q: tined The vame of R in Fig belouf the woltage drop across the 5s2 is 2-5 volts? I A Ia I, R 12 v D

A:

Q: Draw a series-parallel connection in DC using three lamps and two switches in the Schematic Diagram,...

A: Here is your answer! I hope this will help you. As you asked series-parallel circuit I have given al...

Q: 2. Determine the average power P delivered by each of the three sources. 6 cos 377t A 155 cos 377t V...

A:

Q: Every coil made of a metal wire has certain inductance

A: Given a coil has inductance present in it ?

Q: 13. A 200mH inductor and an 80 ohm resistor are connected in parallel across a 100 V rms, 60 Hz sour...

A:

Q: I1 j20 0.5Vx 1220° v Vx. 12 I2 Ix 1Ix -jia7 420°A I3 ell

A:

Q: A balanced Δ -load can be converted to an equivalent balanced-Y load by dividing the Δ -load impedan...

A: In this question,  A balanced Δ -load can be converted to an equivalent balanced-Y load by dividing ...

Q: 1. Explain how transmission and distribution lines, sustation equipment, and generators are protecte...

A: Protective devices and techniques- In field of electrical, Protecting devices and techniques must be...

Q: coil of inductance 150 mH and resistance 38 ohms is connected in series with a 14 ohm resistor and ...

A: Answer -      

Q: Interpret what is in the figure

A: Control systems are represented by transfer function. This  can be written in both time domain and s...

Q: DETERMINE THE PROPER SIZE CONDUCTORS for a 500 watt load that is located 100 ft from a 250 volt pane...

A: Given,THe output power is,Pout=500 WAt panel board the voltage is,V=250 VThe distance between load n...

Q: Compare the results of static or dc resistance of the diodes obtained from different values of forwa...

A: The diodes are made of semiconductor materials. Silicon and germanium are common semiconductors for ...

Q: In a series RLC circuit, at high frequencies, capacitance is dominant and the phase angle approaches...

A:

Q: Consider the networks below. Use superposition to find the indicated branch currents. I1 2260°A(A j4...

A:

Q: balanced three-phase source having a line voltage of 208-Vrms is supplying two parallel-connected th...

A:

Q: 7. Find Vo in the network using Norton's Theorem. 1220° v A 220°A Vo 12 -jia2 21x

A: In this question,  Find the voltage Vo using the Norton theorems.  Here depended and independent ene...

Q: As shown in the figure below, calculate the undamped natural vibrationangular frequency wn , damping...

A: The required parameters can be calculated by finding the closed loop transfer function of the given ...

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.