Consider the networks below. Use superposition to find the indicated branch currents. I1 2260°A(A j42 I 4 I2 62 I3 j22 620°v

Q: 2. Reduce the following block diagrams to canonical form and determine the transfer function C/R. Ex...

A: Given block diagram can be solved using Mason's gain formula or graph theory.

Q: 1 C = [1 0 0] A = 1 B = -5 -6 Determine the controllability and observability of this system. Q2) De...

A:

Q: Find Vo in the network using Norton's Theorem. 220°A 1220°v (A 12 12 Ix 2Ix -j127 Vo

A:

Q: 22 n VIN 8 V Figure 8

A: The given circuit diagram is shown below:

Q: An induction motor OF 30 HP, 220 V, 450% of the rated current with the rated voltage and delivers du...

A: During starting of induction motor we have following formula: TstTf=IscIf2sf1.3TfTf=4.5IfIf2sfsf=1.3...

Q: An AM signal has the following characteristics: fc = 150 MHz,  fm =3 kHz , Vc = 50 V , Vm = 40 V Fo...

A:

Q: R 1kr + Vin 5 v lov 15 V 20V | kHZ

A:

Q: A balanced Δ -load can be converted to an equivalent balanced-Y load by dividing the Δ -load impedan...

A: In this question,  A balanced Δ -load can be converted to an equivalent balanced-Y load by dividing ...

Q: A 40 kVA, single-phase transformer has 400 turns on the primary and 100 turns on the secondary. The ...

A:

Q: (a) Calculate the voltage vout using (i)Simple Circuit techniques for the circuit shown: (b) What is...

A: Fir negative feedback op amp circuit, we can apply virtual short condition i.e. V+ = V-   Iop Amp ha...

Q: A system consisting of three equal resistors connected in star is fed from a three-phase supply. By ...

A:

Q: EXERCISE 5.9 Consider a family of logic gates that operates under the static discipline with the fol...

A: For a family of logic gates,The thresholds voltages are as follows,VIL=1.5 VVOL=0.5 VVIH=3.5 VVOH=4....

Q: 10.3: For the circuit shown: 1. Write the voltages w.r.t currents equations (Z-Parameters). 2. Write...

A:

Q: For a series RLC circuit, the phase difference between the voltage across the capacitor and the volt...

A:

Q: SHOW YOUR SOLUTIONS. A bipolar NPN transistor has a DC Beta of 200mA. Calculate the base current IB ...

A:

Q: Consider the elrouit below, given that Z1 is a 2H inductor, 22 is aBohm resistor, 23 is a 12 ohm res...

A:

Q: 4 Ip (mA) 20아 %3D 19+ %3D Actual commercially available unit 18+ 3D 17- 3D 16- Eq. (1) 15- 14- %3D 1...

A:

Q: 10 V R2 KHW

A:

Q: Q11: Draw the circuit, equivalent circuit and the torque speed characteristics of a single phase ind...

A: Answer -

Q: 27. Determine the static or de resistance of the commercially

A: From data given forward current 4mA from figure the voltage VD=0.7v

Q: An induction motor of 30 HP, 220 V, 450% of the rated current with therated voltage and delivers dur...

A:

Q: Three voltages represented by e = 20sinwt; ez = 30sin (wt - and ez = 40sin (wt - and draw the circui...

A:

Q: Complete the Table Below: Identify the logic level of Q for each pulse cransition assuming that the ...

A: We need to fill the given truth table for J K flip flop .

Q: 3.58 a) Find the equivalent resistance Rab in the circuit in Fig. P3.58 by using a Y-to-A transforma...

A: In this question,  Find the equivalent resistance across the terminal a and b using the star Delta t...

Q: The diode starts to conduct when the voltage across it is 0.6 V. Vin is a variable DC voltage source...

A:

Q: QUESTION 14 With the following DFA, which state is a final state? s, i Start a,b OA2 O B. 1 OCIt doe...

A: The final stage is state 2. the path starts from state 0 and ends  at state 2 .

Q: enclosure used in DC motor

A: Conductor- Materials which have free electrons in valence which can flow when comes under any extern...

Q: EXERCIS E 5.9 Consider a family of logic gates that operates under the static 1.5 V, VOL discipline ...

A: Given,The thresholds voltages are,VIL=1.5 VVOL=0.5 VVIH=3.5 VVOH=4.4 V

Q: 45. Start So S1 S2

A: The digital circuits can be sequential or combinational circuits. The combinational circuits depend ...

Q: 10 V 10 Ω. 102

A:

Q: At s = 0, the admittance of the inductor is zero meaning the inductor looks iike a short circuit. Se...

A: At s=0 the impedance of inductor in s-domain is given as: Z(s)=sL The admittance is given as: Y(s)=1...

Q: In balanced star (wye) connected system, the line voltage is 0 707 times the phase voltage phasor su...

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Q: Vi RL Vo VB. nput waveform Output wavefor Negative clamper with negative bias ww-

A:

Q: The inverse Laplace transform of the following function is: F(s)= s-3 a. f(t) = 5e-3'u(t) = 5e O b. ...

A:

Q: Analyze AC network using Mesh-Current Analysis. Find the branch currents indicated in the following ...

A: In this question,   We need to determine the branch currents indicated in the following networks. An...

Q: Q17: A fully-controlled three-phase bridge rectifier circuit commutating diode across the highly ind...

A: As it is not mentioned which question is to be solved I am solving the first question as per our pol...

Q: 1. The PN junction diode D1 and D2 has the maximum power Pmax -14 mW. D1 Si Imar 160 V D2 4.7kQ 68ka...

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a...

Q: 3 In the voltage-divider circuit shown in Fig. P3.13, find the voltage v, for R2 = 10 N. Also find t...

A: Apply nodal analysis in each case and find the output voltage Vo. According to kcl , sum of the curr...

Q: The diode in the circuit is Silicon with a forward voltage of 0.7 V. If Vin= 10, R1 = 370, and R2 = ...

A: The solution is given below 

Q: Use mesh-current analysis to find the branch currents indicated in the network shown below

A: In this question, Use mesh-current analysis to find the branch currents indicated in the network sho...

Q: C(x) Uo Ud R. Cfix Figure 3: Bridge circuit with variable capacitance c(a). Exercise 2.3 Bridge Circ...

A: Since it asked to solve only exercise 2.3. In the given circuit all impedances are fixed except capa...

Q: CHOICES: Oa. Ob. QUESTION #4. Assuming ideal diodes, select from the choices shown the output wavefo...

A:  As given diode is ideal. Forward voltage drop of ideal diode is 0V i.e. act as short circuit. Rever...

Q: . A4-pole, 50-Hz, 3-phase induction motor has a slip-ring rotor with a resistance and standstill rea...

A:

Q: +Vcc RC Rg VE RE

A: We need to find out current and voltage for given circuit

Q: Find the pawcr and current dissipated in lO LED in the circuit,

A:

Q: Draw and identify at least 2 types of diode clippers (series and parallel) and clampers. Provide one...

A: Diode clampers -  Clampers are also known as DC restorers. Clamping circuits are intended to push th...

Q: 4) In the circuit given, find a) Theuenin equivalent to the right of line cd b) Thevenin equivalent ...

A:

Q: 1) Calculate the current flowing through the resistor 82 (0.52A) Er Ez 4V

A: The solution is given below 

Q: 5. A 230V series motor with 4-pole, 600 conductors wave-connected supplying a load of 7.5kW by takin...

A:

Q: vii. When two magnetic circuits are coupled....... the coupling coefficient is expressed by (a) K=M\...

A:

Superposition Theorem

The superposition theorem is applied to linear systems. For such systems, the output from two different inputs equals the sum of the outputs from each input separately. On applying this theorem many times we get the output from any number of inputs equal to the sum of the outputs from the individual inputs separately.