Find (mA) in the circuit in the figure. Round-off to 3 decimal place. Do not include units. 4 mA 3 kn 6 MA 4₁ 34 kf 2 mA

Q: An angle-modulated waveform is described by x(t) = 10cos(2π x 10°t + 3 cos (2π × 100t)) a) Determine…

A: NOTE :      As per our company guidelines we are supposed to answer only first three…

Q: Part B - Calculating apparent power and power factor A load operates at a voltage of V =450V-rms and…

A: Given data, RMS voltage Vs=450 V Active power P=10 W Reactive power Q=22 VAR

Q: NMOS transistor for VGs = 0.5, 1V, 2V, 3V

A: Given, VGS=0.5V, 1V, 2V, 3V VDS= 1.5V W=10μm L=0.2μm VTN=0.7V kn'=250 μA/V2 To find- Drain current=?…

Q: Question 1 A 30 hp, three-phase, wye connected, 60 Hz, 360 Vu, synchronous motor is operating at 50%…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub- parts…

Q: 13.5 The dc current and dc voltage sources are applied simultaneously to the circuit shown. No…

A: Given: Circuit diagram:

Q: Apply mason Rule (S&P) to block diagnon below. e(s) R(S) اجا H₂ 613 H₁ ஏழ் ந+0 H3 H₂ ((S) H₂ H. G4…

A:

Q: Question 1 Not yet answered How much kWh is consumed by a 4000W electronic circuit operated for 5…

A: Given an electronic circuit consumed, Power, P = 4000 W In time, t = 5 hours 30 minutes = 5.5 hours…

Q: QUESTION 4 Problem zb: The AC EMF in this electric circuit is described by the following equation: ε…

A: Given: Circuit diagram: E=40ei20t

Q: то Apply mason Rule (SGP) to block diegion below. * Git @ e(s) pe ((S) 6123 LEH H₁ H₂t

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: -Calculate the average power of discrete-time wave shown in the fig a? * O -1 01 06 Oo Wala pa pa pa…

A:

Q: Using Mesh Analysis, find VA. Round-off to 3 decimal place. Do not include units. Vs1 12V Hilt R₁ 6…

A:

Q: The following parts of this question are unrelated and should be treated separately. Is the…

A: Given:  A system has been defined by the equations dx(t)dt=-7-22-3x(t) +111-1u y(t)=121-1x(t)   We…

Q: (15 Points) Assuming an ideal op-amp in the circuit, determine the output voltage Vo- 4 ΚΩ ww 6 V 1…

A:

Q: 4. What is the Boolean expression for the AND-OR logic diagram B B

A: Given, The logic circuit

Q: 9m= 2.2 mA/V, Rs = 4.7 k0, RD=5kQ, R₂ = 7 kQ, R₁ = 400 k0, R₂ = 400 ko a) Draw the small-signal…

A: In small signal analysis, we connect dc voltage sources to gnd and capacitors are shorted. Detailed…

Q: Calculate Z, if ST = 3373 VA, fp = 0.938 leading and the 3 Ω resistor consumes 666 W. Work it single…

A: Given data, Apparent Power (ST)= 3373 VA Power factor (fp) = 0.938 leading Resistance (R) = 3 ohm…

Q: A 4 pole wave connected, armature of the DC shunt wound generator is connected to the following…

A:

Q: A Moving to the next question prevents changes to this answer. Question 15 Design a 5-tap FIR HPF…

A:

Q: Find the equivalent capacitor and the charge on eachcapacitor. 9V. 6µF. 3µF a Find the equivalent…

A: Given data, Circuit diagram is given as,

Q: G1 G2 H5 G6 G3 H2 H1 G4 G7 H4 H3 G5 H6

A:

Q: (b) Three loads are connected in parallel to a 240Z0° V rms of 50 Hz source. Load 1 absorbs 90 kW…

A: The detailed solution is provided below.

Q: The switch is said to be __________ when one side of it is connected to the Vdd and pressing it will…

A: Here Active High or push button or pull up resistor all have same meaning.  Active High  which…

Q: What is tungsten,CFL,led bulb... Which one save electricity and why

A: The endeavour to lower energy consumption by utilising fewer energy services is known as energy…

Q: 1. Determine the line currents in the given three-phase circuit. I₂ 44020° 440/120° n a 440-120° (50…

A:

Q: What will be the resultant capacitance of the given combination? =1mF 1mF 2mF 3mF=4mF= 5 mF

A: It  is given that: Taking, C1=1 mFC2=2 mFC3=3 mFC4=4 mFC5=5 mF

Q: 5 advantages and 2 disadvantages of electrical illumination

A: Advantages of electrical illumination 1) Low maintenance – Longer life reduces the need for…

Q: Problem 12. A cable has the following primary con- stants: resistance R= 80 22/loop km, conductance,…

A: Given: A cable has the following primary constants Resistance, R=80 Ωloop km Conductance, G=2 μSkm…

Q: (b) Consider the circuit in Figure Q.3(b). The switch has been in position 'a' for a long time…

A: Detailed solution is attached with the notes explaining each condition. Thank you.

Q: What will be the resultant capacitance of the given combination? 1mF2mF3mF=4mF= 5mF

A:

Q: An audio signal whose mathematical description is m(t) = 20 cos(2л × 1000t) modulates a carrier…

A: Note: We are authorized to answer the first three sub-parts at a time, so we are answering the first…

Q: Use nodal analysis to find V₁ in the circuit in the figure. Round-off to 3 decimal place. Do not…

A: To find V1 in the circuit

Q: A 3phase synchronous motor of 8000W at 1100V has Synchronous reactance of 8ohm per phase. find the…

A: Here, Power output, Po=8 kW; VL=1100 V;  Xs=8Ω; η=0.8 The current in the motor is minimum when the…

Q: It is desired to raise the temperature of one quart of water in a coffee percolator from 18°C to…

A:

Q: 11. Which of the following is the drawback for cordless telephones? a) Security b) Wireless…

A: The correct option along with the explanation is provided in the following section.

Q: A 3-bit PCM system with a linear midrise quantiser of step-size A = 1V is used to digitise the…

A:

Q: The open-loop transfer function of a control system is given by (a) (b) KGH (s) K s(s+1)(s+4) Sketch…

A: The given loop transfer function is KGsHs=Kss+1s+4. We need to draw the root locus and also for…

Q: Discuss the merits and demrits of feedback.

A:

Q: In VCC is connected to pins 3 and 8 so that the 7-segment LEDs will light when a low signal (ground)…

A: Given & to find: In ........, VCC is connected to pins 3 and 8 so that the 7-segment LEDs will…

Q: A 200 V, 50 Hz a.c. supply is given to capacitance of 25 micro F. If the supply is given, write the…

A:

Q: When identical partially loaded AC generating units are operating in parallel on governor control,…

A: Since you have posted multiple different questions, we will solve the first question for you. To get…

Q: In a RLC circuit Inductance is 20 mH and capacitance is 200 micro Farad. Find the resonance…

A: Given an RLC circuit with, Inductance, L=20 mH Capacitance, C=200 μF Angular resonance frequency,…

Q: A 125 m cable weighing 2 kg.s per m is suspended between two towers at the same level. The sag is 3…

A: Given cable length = 125 m sag =3 m   arc-length =2a×sinhx2a

Q: What is cooling tube in transformer? Why does a transformer need cooling?

A: Cooling is the process of transferring heat from a transformer to the outside world. The…

Q: A negative feedback amplifier is shown in Figure 1. If the gain, A, of this amplifier without…

A: Given, Gain without feedback A=5000

Q: 1. Given the information provided in Fig. 3.5, determine the level of R. + 4 V(p-p) - w R₁ -20 12…

A:

Q: the process of error controlling using an FEC encoder and decoder in wireless communication with…

A: the process of error controlling using an FEC encoder and decoder in wireless communication with…

Q: Determine voltage across resistance 2 (330 ohms) for circuit (a) if voltage across resistance 1 (6.8…

A: Given data, Circuit diagram is given as,

Q: Question # 1 a) A certain filter has the following transfer function. 1500 H(jw)= (jw+50)² Find the…

A:

Q: Nodes A to B has a voltage drop of 5.0 cos (2t + /3. Nodes A and D is connected by 0.2 F capacitor.…

A:

Q: 10. Which type of transmission technique is employed by paging system?

A: The correct option along with the explanation is provided in the following section.

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.