find Steady state responses Steady state error

Q: We need a logic circuit that gives a high output if a given hexadecimal digit is 4, 6, C, or E. The ...

A:

Q: A two-way set associative cache memory uses blocks of four words. The cache can accommodate a total ...

A:

Q: Find :ResponsesSteady stateSteady state errorRouth stability

A:

Q: S.4) the length of a three-phase power transmission line with a Nominal operating voltage of 69 kV i...

A: Given: Nominal operating voltage, Transmission line impedance, Length of transmission line, Power of...

Q: (iv and V)last two questions

A: In 12-bit signed integer, MSB is use to represent sign and rest of 11 bits are used to represent the...

Q: Are common-emitter amplifiers inverting or noninverting? What can you say about the magnitudes of th...

A: Common emitter amplifiers are inverting in nature. It inverts the signals by 1800. Common emitter am...

Q: 2 Use truth tables to prove that BC + BC + BA = A+ B.

A: solve by boolean theorem: LHS: BC+BC'+B'A          =B(C+C') +B'A          =B +B'A          =(B+B'). ...

Q: Questions:- 1-why does the speed fall slightly when the d.c. shunt motor is loaded? 2- what is the e...

A:

Q: If the blocked rotor test is to be performed on a wound rotor motor, and if the rotor winding is kep...

A: In slip ring induction motor or wound type induction motor, the block rotor test is performed to cal...

Q: Plotting the Amplitude and Phase Spectra for a Periodic Voltage Suppose that for the periodic voltag...

A: The expression for the complex exponential Fourier series expansion is given by:

Q: 2. Calculate equivalent resistance from fig.Q2. 30 2 www- 120 202 ww 25 2 602 10 2 ww 150 ww Fig: Q2...

A:

Q: Calculate the radiation resistance of a  lambda/10 wire dipole in free space.

A:

Q: Assuming a global population of 9 billion people, each using approximately 100 W of power continuous...

A: Total power consumed can be calculated as,

Q: • [Q1] Using Phasor approach, find i(t) in terms of (amp, phase, freq.?) di 10 | i dt +- 10 idt * t ...

A: Since we are authorized to solve one question at a time so i am solving only first question

Q: Please, I need to solve this question

A: given function F=A'C+AB'C'+B'C

Q: A permanent-magnet dc motor has RA=0.5 Ω. With no load, it operates at 1070 rpm and draws 0.5 A from...

A:

Q: Find the rms value of the half-wave rectified sinusoidal voltage

A: Given waveform, The above waveform is rectified DC output produced from half-wave rectifier so it i...

Q: Calculate the worst-case output voltage for the circuit shown if VOS = 2 mV, IB1 = 100 nA, and IB2 =...

A:

Q: The sending-end voltage in the circuit seen is adjusted so that the load voltage is always 13,800 V(...

A: Circuit diagram is given, (a) Frequency is given f = 50 Hz Minimum power dissipation is occurs when...

Q: Find is, i1, and i2 in the circuit shown

A:

Q: IREF = 68 μA as shown. (a) What value of R2 is required to set IO2 =16 μA if the area Q1 is changed ...

A: IREF = 68 µA IO = 16 µA   Given circuit is a wilder current source. The resistance R2 is given as, ...

Q: Why clamp on meter not used in DC circuits? Explain?

A: Given: A clamp on meter.

Q: Q: Explain in details with all figures and equations the modulation index of Amplitude Modulation (A...

A: AM modulation index: The measure or extent of amplitude variation about an un modulated carrier is c...

Q: For the circuit as shown, find R3 to set ID3 = 0.8 mA with VDD = VSS = 10 V, and ID4 = 4 mA. Calcula...

A:

Q: A unity feedback control system has the open loop transfer function. 4(1+2s) G(s) = s²(s+2) If the i...

A: Given open loop transfer function and feedback transfer function are - Given input is ramp input.

Q: 3. Design second ooder with cutoff foequency (fe) = 1 KHz. for case li) Gain=10 and Butteowoth Low P...

A:

Q: How many resistors and comparators are required to implement a 10-bit flash ADC?

A: Number of bits in flash type ADC is given, n=10 Number of comparator used in flash type ADC is given...

Q: Plz i need the answer of this question number 1  in digital electronic

A: In asynchronous counter when preset is 1 and clear is 0, all the bits of the counter are set to 1. I...

Q: Explain the similarities between motion in a gravitational field and the flow of electrons (the carr...

A: In the motion in gravity, there is a constant force which is acting on the particle towards the grou...

Q: Find the loop gain, current gain, input resistance, and output resistance for the shunt-series feedb...

A:

Q: What is a bandpass filter? How is its bandwidth defined?

A: The bandpass filter is a filter only passes those signals which have certain frequency ranges. For e...

Q: What are the reasons of fall of terminal voltage of d.c shunt generator ?

A: There are many reason in fall of terminal voltage of dc shunt generator. Armature reaction : Due to ...

Q: (a) What are the output currents in the circuit shown if the area of transistor Q1 is changed to 3A,...

A: Reference current can be calculated as, Output current can be calculated as,

Q: solve it.

A: Given values are -

Q: For the RLC circuit shown below, Derive an expression for the transfer function v¿(s) G(s) = v(s) Co...

A: The circuit in frequency domain shown below: To calculate voltage across capacitor, apply voltage d...

Q: Find the short-circuit time constants and fL for the common-source amplifier As Shown if ID = 1.5 mA...

A: Calculating resistance R1S to sort circuit C2 and C3

Q: Electrical Engineering Question

A:

Q: The power supply −VEE as shown is changed to−2 V. What are the new values of REE and RC1required to ...

A: Given VH = -0.7 V, VL = -1.3 V, VEE = -2 V, VREF = -1 V, IEE = 0.3 mA

Q: Draw the two-port representation for the npn Darlington pair in as shown including the smallsignal m...

A:

Q: What is an ideal diode? Draw its volt–ampere characteristic. After solving a circuit with ideal diod...

A:

Q: Find the midband gain, lower- and upper-cutoff frequencies, and bandwidth of the amplifier with the ...

A: To find the mid-band gain, lower- and upper-cutoff frequencies, and bandwidth of the amplifier with ...

Q: Design the bandpass filter from using a cascade of a fourthorder low-pass Butterworth filter, a four...

A: The circuit diagram for the bandpass filter from using a cascade of a fourth-order low-pass Butterwo...

Q: Calculate to the correct number of significant figures. (5.01x10^5)/(7.8x10^2)

A: Procedure to find the correct answer with a number of significant figures.  Step 1 : Multiply or div...

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.