A digital wave is received. It says the value for low is 5 V. The system registers it as low from 8V. This system switches On as of 12 V and registers High at 15 V. What is the unacceptable range of the system?

Q: The ammeter shown in Figure reads 5.00 A. Find 11, 12, and e . 15.0V 7.00 Ω + ww 5.00 Ω Μ www 2.00 Ω…

A: current and volatage calculated by using nodal analysis

Q: Q3 (a) (i) (ii) With the aid of a suitable sketch and in your own words, outline the basic…

A: Solution of question Q3.(a)(i): It is asked to discuss the basic characteristics of a strain gauge.…

Q: Determine the equivalent resistance between terminals a and b. O 6.7520 Q O 5.9253 Q O 7.6547 Q Ⓒ…

A:

Q: Example12/ Open write T-L with L=30 m, ZR = Zo = 502, f=50 MHZ Find Z, and Za d = 10 m Use the…

A: We need to find out the impedance on transmission line

Q: Quà L) transistor can be used as a electrical switch (T/F) 2) Consider the following robot…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: (c) A circuit shown in Figure Q4.c has an a.c. source of 50 V and internal resistance Rin 2 k2 is…

A:

Q: Q3 Ⓡ (i) (ii) With the aid of a suitable sketch and in your own words, outline the basic…

A:

Q: The figure below shows a three-stage circuit using two-supply emitter bias. What are the…

A: Given  A multistage amplifier and is given all the resistor values.we need to determine the…

Q: R1. ww 5 Ohms R4 ww 3 Ohms R2 ww 3 Ohms ww 6 Ohms R3 ww 9 Ohms

A:

Q: Q3: Determine the Nyquist rate of sampling required for the signal g(t)=e^(-2|t|) (Approximate the…

A:

Q: 4ax + Say - zaz dimensions 3 cm by 6 cm lying on y = 5 in the +y-direction. O 56.55 mWb; O 45 kWb; O…

A: We need to find out the flux Passing through the given surface

Q: Express the impedances in Fig. 15.120 in both polar and rec- tangular forms. www R=6.801 (a) L=12 H…

A: We need to find out the impedance of given elements

Q: Simplify the following Boolean functions by tracing it on a K Map, grouping of blocks the best…

A: Given K-map has 4 variables i.e. 16 entries or minterms. For simplest simplification try to get…

Q: Problem 3 Use phasor analysis techniques to determine the steady-state load current i (expressed in…

A: For the given circuit Using phasor analysis techniques  the steady-state load current iL is…

Q: Calculate the output voltage of an op-amp summing amplifier for the following sets of voltages and…

A: The output voltage of the inverting summing amplifier can be obtained by using the kirchhoff's…

Q: An ideal battery of terminal voltage 22 volts charges two practical batteries connected in parallel…

A:

Q: 2.13 F the circuit in Fig. 2.77, use KCL to find the branch currents I₁ to 14. 2 A 12 4 A 7 A 3 A 13

A:

Q: oltage-current relationships in resistive, inductive, and capacitive circuits with sinusoidal…

A: Ohm's law:- Voltage across the conductor is directly proportional to current flowing in conductor…

Q: F = A'B + B'C + C'D Implement the function F using: a. one 16X1 multiplexer b. one 8X1 multiplexer…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: Which of the following is true about resistors that are connected in series? The reciprocal of the…

A:

Q: a o 10 ohms bo 30 ohms 20 ohms 15 ohms 25 ohms 40 ohms

A:

Q: 3. A 3 phase, 50 Hz, 434-V, supply is connected to a, Y-connected induction motor and synchronous…

A: Given data, Voltage VL=434 V Impedance of each phase of induction motor Zp=1.25+j2.17 Ω Current…

Q: A TRIAC phase control circuit has a load resistance of 71 and is powered by an AC source of 163…

A:

Q: 2.20 Determine i, in the circuit of Fig. 2.84. io 4Ω www 5% 36 V

A: We need to find out the current for given circuit

Q: a- b r1 5 Ohms V1 15 V www i1 r2 3 Ohms i2 V2 8 V 믐 R_LOAD ww 10 Ohms r3 3 Ohms i3 V3 + 믐 3 V

A:

Q: 1C 2.4 (a) alculate current i in Fig. 2.68 when the switch is in position 1. (b)ind the current when…

A: In this question,  We need to calculate the current i at different different position.  We know…

Q: Find V, in the circuit below ww 4 ΚΩ 4 ΚΩ 6V (2mA 2 mA + (1) 2 ΚΩ 4 mA Σ2 ΚΩ Vo

A: This is a basic problem of circuits. The voltage Vo can be calculated by applying nodal analysis and…

Q: Analog Input + 100kn Now read in the measured voltage from this circuit. You will notice it is on a…

A: An ADC is a analog to digital converter, it is used for transfering an analogue signal to digital…

Q: Compute for the current it in the circuit shown below. a 1.0695 A 1.0672 A 1.0745 A 1.0724 A b r1 5…

A:

Q: By applying the two golden rules of ideal operational amplifier circuits and the superposition…

A: The Given circuit is      It is Ideal op-amp; The Voltage gain V0=R2R1V2-V1

Q: What are the properties of a circle Jfet in the subject of field effect transistor

A: Field Effect Transistor:  The field-effect transistor (FET) is a kind of transistor that uses an…

Q: 3. Write the differential equation for the system shown in Figure R(s) 55 +254 +45³ +²+4 C(s) 5+755…

A:

Q: Calculate the distance from the apex of the 1st and 2nd dipole element of a log – periodic antenna…

A: For better performance across the frequency range of interest, it is advisable to design the antenna…

Q: כו חסו A 200 load receives power from parallel-connected battery cells, as shown in the figure…

A:

Q: Large Signal Ampl: 1. Determine the input power, output power, and efficiency resulting in a class B…

A: The conversion efficiency of a Class B Amplifier is expressed as the ratio of Peak signal voltage…

Q: 3) A generator of electromotive force E=12V and internal resistance r=1W feeds two resistances, of…

A:

Q: An antenna has a loss resistance, Re=10Ω and a radiation resistance of Rr=120Ω. Determine the…

A:

Q: able 1: Oscillator circuit parameters and circuit components C2 = 5100 pF; Amplifier gain = 11;…

A: It is given that: C2=5100 pFAmplifier gain=A=11R1R2=C2C1f=20 KHz

Q: The characteristic equation for a system is given by A=8³+10s² +118 +6. Using Continued Fraction…

A: The Given equation is ∆=s3+10s2+11s+6 To determine the h1 coefficient by using continued fraction.

Q: Express your answer in rectangular and polar forms, and draw the impedance diagram. R₁ = 1k ww ZT…

A:

Q: .11 In the circuit of Fig. 2.75, calculate V₁ and V₂. 1V 2 V + + + + 5 V 1 V₂

A:

Q: Hand written plzz 2) Ris) C(s) K G,(s) G₂ (5) X (s) Sketch the root locus for the system above. D(S)…

A:

Q: A long solenoid has a radius of 3 cm, 5000 turns/m, and carries current I= 0.25 A. The region 0 <p…

A: Given,Radius, r=3 cmTurns, n=5000 turns/mCurrent,I=0.25 AFor 0&lt;ρ&lt;a,μr=5andFor…

Q: A capacitor and resistor are connected in series to an A.C supply of 50V and 50Hz. The current is 2A…

A:

Q: An inductance of 15mH has a current drawing I = 15sin(650t - 300) A. Determine the equation of…

A:

Q: A Yagi antenna has a gain of 10 dBi and a front–to–back ratio of 15 dB. It is located from a…

A: It is given that: GR=10 dBir=15dBf=10MHzPL=2dBPT=100kW

Q: The armature of a 4-pole, 130 slots shunt generator is lap wound with four conductors per slot. The…

A:

Q: Compute for the current is in the circuit shown below. O 1.0724 A O 1.0745 A O 1.0695 A O 1.0672 A a…

A:

Q: R www + C 24 i(t) HE Vo

A: In frequency domain  Capacitor impedance is given by  Zc= 1/cs ohms Where as  for resistor Zr = R…

Q: Compute for the voltage vab O-13.7037 V O-12.5784 V -13.3752 V a R5 2 Ohms V3 미다 10V V1 20V R6 ww 9…

A: Given