Find the conductance of a resistor of resistance (a) 10 Ω (b) 2 ΚΩ (c) 2 mΩ

Q: he Electric Field is Ē= 5,6 â+9ây+1,2 â in the region z>9,3 with the dielectric constant € = 1,15.…

A:

Q: What rule about AC and DC signals using capacitors is being shown diagram below? (two part answer) m…

A: For DC signals, the capacitor is open circuited.Therefore the DC voltage at node shown is : Vdc= V*…

Q: Consider the open loop transfer function k -2 -4 s+6 (s+3)(s+5)* In the root locus diagram the…

A: Open loop transfer function is given by,

Q: What is the voltage on out node for given ideal op-amp.

A:

Q: An 6.6 kV. three-phase star-connected synchronous motor is working at full load and draws a curren…

A: Given Data:A three-phase star-connected synchronous motor with,Line voltage Line current Armature…

Q: Q1. Determine Vo in terms of Vi, Vrand Vs in the circuit of figure 1 using nodal analysis. 30 ΚΩ…

A: Circuit diagram is given as,

Q: R₂ 16 Buildled (11) A B Is R₂ R₂ R₁ www R₁ = 10 92 R, = 30 Ω R, = 10 Ω R₁ = 1022 R₁ = 7.5 2 1=1 A…

A: Thevenin and Norton theorem is used to analyze the complex electrical circuits by converting it into…

Q: Also from same question, he required the value of K to make the system Marginally and the value of…

A:

Q: Find time 't' (m sec). When the transistor enters saturation VBE = 0.7V,VCE = 0.2V, Blarge (ON)…

A:

Q: Determine the Thévenin equivalent circuit of the circuit shown in Figure 3, to the left of terminals…

A: Thevenin voltage is the open circuit voltage across ab terminals with load is open…

Q: (a) (b) Design a digital logic circuit that compares two 2-bit numbers, A and B as shown in Figure…

A: To do:a) We have to design a digital logic circuit that compares two 2-bit numbers.b) Implement the…

Q: Ise Norton's theorem to find Vo in the following circuit. 1mA V₂ 4000 2k0 ww 1k0 Vx3kn 3 kn Vo

A: In this questionWe need to determine the voltage Vo as shown the circuit using the Norton theorem.

Q: A Binary PAM employs rectangular pulses of duration To and amplitudes ±A to transmit digital data at…

A: It is given that:

Q: What is the equivalent resistance in kOhm if three resistors of 4.3 kOhm, 1.4 kOhm, and 2.2 kOhm are…

A: Resistances are given,

Q: By what factor the SNR changes if we coherently integrate 10 pulses instead of using a single puls…

A: The SNR will increase by a factor of 10 if we coherently integrate 10 pulses instead of using a…

Q: Q4. Use a Karnaugh map to minimize the following standard SOP expression: (15 M) ABC + ABC + ABC +…

A: Step-1->

Q: Consider the circuit shown in Figure E1.3.1 and determine the unknown currents using KCL.

A: It is given that:The circuit diagram is shown below:

Q: 8PFE-5 What is the current I, in the circuit ? 16 -j1Q L₂

A: Circuit diagram is given as,

Q: A sliding bar is moving to the left along a conductive rail of width W= 10 cm in the presence of a…

A:

Q: Multiply A B where A=5235° and B=3245º.

A: A = 5 B = 3We have to find the Result after multiplication of A and B.

Q: Question 4 Consider the following RC filter. A) Find the transfer function of this filter? B) Find…

A: The above question is based on RC filters.Since multiple subparts to the same question have been…

Q: H(s) 2+1+ is a (t) = sin(2x325+), find the output y(t). is the transfer function of a 2nd order…

A: Given:Transfer function H(s) = R = 2500 Ohms L = 1HC = Input signal x(t) = To determine:Output y(t)

Q: Zin w=10 krad/s an + v dμF HH bmH m + си soru 3) yukarıdaki devrede a=166, b=27, c=3 ve d=35…

A:

Q: n the circuit given below, Ra=Rb=Rc=9 ohm loads are fed with an AC voltage with a fundamental…

A: Inverter are used to convert DC input to AC output. AC Output can be single phase or Three…

Q: Calculate the mesh current i1.

A: we are not allowed to provide handwritten solution. so providing you typewritten solution.It is…

Q: Q4/ For the figure shown below, choose the correct .Transfer function {+i s-paine Re s+1/s2+4s+5 O…

A:

Q: Q) Since VDD=+15 V, VTH= +2 V and K= 100mA/V^2 in the circuit below, what is the ID current?  (R…

A: For the given enhancement type MOSFET amplifier circuit the value of drain current needs to be…

Q: If the cathode voltage of a forward-biased silicon diode equals 2.6 V, the anode voltage equals 0.7…

A: It is given that:In a forward biased silicon diode,Cathode voltage, .

Q: Given VDD=3V and VB=2V, how can I bias the M3 and M4 transistors so that they are in saturation…

A:

Q: + Icopa VB ↑ Rout MI Iref VDD o M₂ M3 M₂ + ) VB ↑ Re Icopal Que

A: The second structure is a cascode current mirror.Hence Rout of second circuit is higher than that of…

Q: 4.3) Calculate the voltage drop across every resistor (8 of them). 4.3) Calculate the power…

A:

Q: A) Write down the characteristics B) Find vo and i, in the following circuit. of an ideal op-amp.

A:

Q: Find  Vfb and Vcf

A: In this questionWe need to determine the voltage Vfb  and Vcf  as shown the circuit. We are solving…

Q: Question 1:.... a) Sketch the root locus.. b) What are the values of the gain and poles at the…

A:

Q: 3) The Switch in the circuit shown in Figure has been closed for a long time. The Switch opens at…

A:

Q: A capacitor is discharged by connecting a resistor across its terminals at t=0. The voltage measure…

A: In this step, We need to determine the signal power across the terminal for v(t). We knowPower P=…

Q: Assume the base transit time of a BJT is 100 ps and carriers cross the 1.2 μm B-C space charge…

A: Step-1->Assume a npn BJT transistor cross section as shown ib fig-1

Q: Question: The capacitance C₁, of a diaphragm pressure sensor increases as the measured pressure…

A:

Q: A synchronous, three-phase motor, connected in Y, with a frequency of 60Hz, 2300V, has a synchronous…

A: It is given that: frequency,  synchronous reactance, efficiency,  The power factor angle=15…

Q: The larger short circuit current at a certain point of the network corresponds to: Select one: OA…

A: The short circuit current at a certain network node corresponds to the utility's limited short…

Q: A generator is feeding the load. A second load will then be connected in parallel with the first…

A: Given data:Idle frequency of the generator The slope of droop characteristics generator Load 1…

Q: Q4) Determine the low and high noise margins RB Vin O-W 10ΚΩ Vcc=5V Rc {1kΩ V (on) = 0.7V BE F -O Vo…

A: The given NPN transistor is shown below.The given parameters are written below. Volts. Volts.…

Q: 2. Convert Variables in the Coordinate system as follows: c) Point d) Point C(p = 2.5, -0.7, z=1.5)…

A:

Q: b) How much current is drawn from the battery shown in Figure 7? 400 $2 b 500 £2 700 22 12.0 V…

A: Circuit diagram is given as,

Q: Determine (i) the output. voltage and (ii) the peak inverse voltage. Assume the diode to be ideal.…

A: The above circuit is a single-phase full bridge diode rectifier.

Q: In the following electrical circuit in the figure, R=2 Kohm, L=2 H and C=2 Microfarad are given. a-…

A: Given:A circuit, with R=2 K, L=2 H and C=2 F, To do:a- Obtain the transfer function. b- Draw the…

Q: O aq www + v duF a. Zin = 1620.00+j117.83 ohm b. Zin - 1080.00+ 1147.83 ohm Oc Zin = 1404.00…

A: The question is about thevenin impedance.

Q: Determine S' = O a. O b. S' ~ 0 0 c. O d. O e. alc OV BE when ß-100, VBE(on)=0.7V and VĎ(on)=0.7V.…

A:

Q: A 5 kW 125 V shunt generator operates at 1800 r/min If the field current is 1.8 A and the armature…

A: Output power Terminal voltage Field current Armature resistance

Q: A coil having an area 2m² is placed in a magnetic field which changes from 1Wb/m² to 4Wb/m² in an…

A: Cross sectional area of wire Magnetic field is changes from Change in magnetic field Time t = 2 sec.

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.