Find the current, I, in the circuit shown in Figure 1 by applying Thevenin's theorem. 1522 1022 2022 247 [ 12Q2 8Q 1022
Q: 1. Design a 8 - to - 1 multiplexer using 2-to-1 multiplexer using blocks.
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: Example 7.12 An AM transmitter has a carrier power of 1 kW at a carrier frequency of 10 MHz. It…
A: In plots values are denoted in closed brackets.
Q: What is the value of Rx in kohms to be connected in parallel to a 75 kohms to reduce the value of…
A:
Q: multiplexer contains. multiplexer contains.... select lines 4-1 4 O 20 8 O select lines 16-1 4 O 8 5…
A: In this question we need to choose a correct option
Q: 0 22 5V
A: IV charterstics of circuit is given as assume V is voltage source and total current I is flow in the…
Q: A certain appliance draws 22 A across 25 V power source, how much will a spend if I use it for 8…
A:
Q: B. Find the current through a 5-H inductor if the voltage across it is: v(1) (301² lo. 1>0 1<0
A:
Q: Hello, Not sure if this is possible but am i able to delete his answer from the system?
A: The solution is provided in the following section.
Q: 21: Assume that V is a function of y and at y =2, V=5 volt and at y = 4, V = 10 volt. a) Fi. cis.…
A: In this equation shows that the potential distribution in a region is depend the local charge of…
Q: Sketch each of the following special digital sequences: a. 58 (n) b. -28 (n - 5) c. -5u(n)
A: For the above given questions we need to plot sequence of the given discrete time domain signals.
Q: 9. Ohm's Law and DC Circuit: Suppose, your team was assigned to check the status of the wiring in a…
A:
Q: R + CC PC + W₁ +CC IR N 21 ly Z₂ 23 PC + W₂ 1B B. Supply voltage = 400V (line-to-line), phase…
A: Types of power measurement Three wattmeter method Two wattmeter method One wattmeter method
Q: 17. The input power to a 6-pole, 3-phase, 50 Hz induction motor is 42 KW; the speed is 970 rpm. The…
A:
Q: Design a circuit to bias the MOSFET in figure shown, so that its drain current is 5 μA. Estimate…
A: MOSFET is the metal oxide semiconductor field effect transistor. It allow the flow of current in a…
Q: 2. A 60 W electric light bulb is connected to a 240 V supply. Determine (a) the current flowing in…
A: Given, Electric Bulb power rating, P = 60 W Supply voltage, Vs=240 V
Q: Q3/Find maximum and minimum voltage gain of the circuit showing in figure if rds varies from 500 to…
A: Given, Maximum and Minimum voltage, rds →50 ohm to 120 k-ohmKCL at…
Q: Given a 50 μC point charge located at the origin. find the total electric flux passing through a)…
A: Given, Point Charge Q = 50 micro coulomb at origin.
Q: a) Determine the suitable capacitor to make 90° electrical between Im and la at starting running of…
A: Given data, Za=7.8+j3.2 ΩZm=2.4+j3.8 Ω Supply voltage V = 205 V Frequency f = 60 Hz Angle between im…
Q: A single phase transformer is given: SN= = 100 kVA, V₁10 kV t = 25. The short circuit parameters…
A:
Q: What will be the value of the current source present in the given circuit if the voltage of the…
A: Given circuit, Voltage of the given sources are 2 V and 6 V.
Q: The current entering a terminal is given by i(t)=4t Amps. How much charge accumulates after 3…
A: It is given that: it=4t A
Q: The input waveform shown in the figure below is applied to an inverter, which is used to operate a…
A: The input waveform shown in the figure below is applied to an inverter, which is used to operate a…
Q: Find your for the circuit in Figure 3, if Vi = 2sin(ot) Volt. Assume that all op-amps in the circuit…
A:
Q: Solve for all currents using superposition. R3 13 12 Vi 18V R₁ } I₁ R2 #H V₂ 1 12V R₁ = 12kn R2 =…
A:
Q: Example 5.1 A LPF circuit consisting of a resistor of 2 k in series with a capacitor of 0.1uf is…
A: A LPF circuit consisting of a resistor of 2 k in series with a capacitor of 0.1uf is connected…
Q: The phase angle of the system G(S) = (a) 0° and 90° (b) 0° and -90° S+5 ; varies between S²+8s+9 (c)…
A: In this question, We need to choose the correct options What is angle of given G(s) varry between?…
Q: The region between concentric spherical conducting shells r=0.5 m and r = 1 m is charge free. If…
A:
Q: 4. Input two numbers from buttons and display them in a two 7-segment led. Serial ports are used to…
A: In case of asynchronous serial communication start and stop bits are used to specify the start and…
Q: 3. For the following plant 0.125 G(s) = (s+0.750)(8 +0.500) (s+0.250) under a unitary closed loop…
A: Given,Gs=0.125s+0.750s+0.500s+0.250The plant is under a unittary closed loop with controller Gcs.
Q: Assume the capacitor to be fully discharged before the switch closes to position 1 at t=0: A.…
A: The circuit is given as The value of resistance is given as R1=2kΩR2=5kΩC=25μF
Q: 1 8 2 7 R₁ 3 6 R₂ 4 5 R₁
A: We need to find out the total total resistance and current for given circuit .
Q: LA J Z₁ lc Three-phase source Feeder lines Balanced load the above circuit diagram, we have source…
A:
Q: Q1] a) Design a control system such that the resulting closed-loop, unity feedback system meets the…
A: Given Few parameters of a control system.we need to design a control system. Please find the below…
Q: Example 5.3 Calculate the cut-off or "breakpoint" frequency (fe) for a simple passive high pass…
A:
Q: Construct the magnitude and phase plot for the following transfer functions H(s) = 41 (s+0) (s +52…
A: Given A transfer function.we need to draw both magnitude and phase plot. Please find the below…
Q: Q3/ Find E at the point P placed at (0,3,4) in Cartesian coordinates due to a point charge Q = 0.5…
A:
Q: Given: 1. x(n) = [1 2 3 5 7 9 4] and h(n) = [−1 2 -3] 2. x(n) = [1 4 6 7 8 3 5 2] and h(n) = [1 1 1…
A:
Q: c) For the circiut shown in fig.(2), the switch has been closed for a long time. It opens at t=0,…
A: We need to find out the voltage for given circuit
Q: +41mV +15 mV Calculate Vo for the circuit shown below 600 k www 15kQ2 www 30 k www 30 ks2 www 15KQ2…
A:
Q: Subject name: Microcomputer application principle Question: Four 1KB EPROMs are used to make a 4KB…
A:
Q: Q6/ (Practical part) 1- Write the steps to solve the thevenin circuit with suitable diagrams and…
A:
Q: Using previous syndrome table, find the corrected word for the received word [R]=[1010011].
A: First, the receiver will find [S] from the reminder of R(X)/g(X) 1 1 0…
Q: 1 52 V 2 452 www E V₂ ww 10 2-22 M 2A 100 4 12 V4 3 www C 2.12 ww 5n SA 3.2 ≤42 0 1A
A:
Q: 23) Design a perceptron neural network to distinguish patterns between bananas nd pineapples, based…
A: In this chapter we have designed three different neural networks to distinguish between apples and…
Q: Q2/ Find the potential at a point P, which lies on the axis of a ring of radius a, charged with a…
A: The amount of work required to shift a unit charge from a reference point to a specific place in an…
Q: Q4. In a CE germanium transistor amplifier circuit shown in (fig. 5). Determine the 0.985. operating…
A: For the above given common emitter amplifier circuit we need to calculate all the DC parameters and…
Q: A separately excited DC generator shown in Fig.1. Let the adjusted resistance equal to 80 2. The…
A: The circuit diagram of separately excited DC generator is shown below, Where,Adjusted resistance…
Q: What are the types of surge diverters, explain any two?
A: Given: Types of surge diverters.
Q: In the following parallel circuit, find the equivalent resistance and the total current in the…
A: given here a parallel circuit, we need to find the equivalent resistance and the total current in…
Q: Problem 1 Find i, and the power developed in the dependent current source, 2xx- 6Ω 3Ω 5 Ω ww 2V |+…
A: The circuit diagram is shown below,
Step by step
Solved in 6 steps with 6 images
- In an R-L parallel circuit, ET=208 volts, R=2.4k, and XL=1.8k. Find IT.1. Circuit Topology (Show solution) a. Simplify the circuit below such that there is only one voltage source and one equivalent resistor Rs in the circuit. Do not use source transformation. What is Rs? b. Simplify the circuit below such that there is only one current source I1 and one equivalent resistor Rp in the circuit. Do not use source transformation. What is Rp?For the circuit in the figure, draw the equivalent circuit and values I1, I2 and ID1, ID2.find? need handwritten only ,otherwise downvote.)
- Can you please explain the steps on how to solve for equations lll, IV, and V to get the current values of I1, I2, I3Using Kirchhoff's Rules, compute the current (mA) and voltage (V) values of the circuit if R1=2kΩ and R2=7kΩ.im new to the concept of nodal analysis so when finding vab u applied nodal analysis to get v1 but on what basis did you put the values in the numerator and denominator? and what part of the circuit did you not take into account while calculating it? since there seem to be some missing values. i mean what does each number refer to. also when calculating vth and used v1 to find it how did u get x2/2+1? i know about the voltage division rule but im a bit confused can you please elaborate on all these points?
- A clocked Mealy sequential network has one input (X) and two outputs (Z1Z2).If Circuit receives (0,1,0) input while haven't received the (1,0,0) input before circuit would give Z1 = 1 result. For every (1,0,0) input received circuit would give Z2 = 1 output. If ever the circuit's Z2 output becomes Z2=1 circuit's Z1 output wont be Z1=1 afterwards but if Z1 output becomes Z1=1 it won't affect Z2 outputs capability of resulting 1. Draw the circuit it should consist of ROM and D-FFs and write the first 5 lines of the ROM programFind the equations and Verify the loops and junctions rule if I1=0.06 I2=0.25 I3=0.4^ I4=0.74 I5=0.4 I6=0.32 R1=25 R2=45 R3=10 R4=15 R5=20 R6=40 e1= 10 , e2=35find i1, i2, i3, and i4 of the circuit
- In the electrical circuit given in the figure, u(t) voltage is system input and i2(t) current is system output. x1(t)= i1(t) current and x2(t)=uc(t) voltage system states. What is the value of A11 and A21 in the state space model of ?Find the voltages Vc, V2 and currents I1, I2.Please answer all the subparts you can count this question as 2 questions and take my rights these all subparts are connected each other please dont leave just solving first three. Please asnswer the question step by step and please care to explain the question in detailed with your own sentence and explain why you used that formula, calculations etc asap. Thanks in advance.