Answered: In the following parallel circuit, find…

In the following parallel circuit, find the equivalent resistance and the total current in the circuit. Given the following: R1=6kΩ R2=3kΩ R3=7.3kΩ VT=20V

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 16PP: An R-L parallel circuit has an applied voltage of 208 volts and a total current of 2 amperes. The...

See similar textbooks

Related questions

Q: Determine the unknown voltages using Kirchhoff's voltage law V₂ www R₂ = 5.6 k 10 V 6 V 24 V- V₁ R₁…

Q: Q1) A. Answer the following question: 1. What is the reciprocal of resistance? 2. An electric heater…

Q: Polona EX2: infinite line along the z-axis with 20 nc/m. Calculate the capacitance between p=10 and…

Q: Balanced 3 Phase Supply A +PC- A +CC C Line-to-line supply voltage is 380 V with the phase sequence…

A: Methods of three phase power measurement One wattmeter method Two wattmeter method Three wattmeter…

Q: 21: Assume that V is a function of y and at y=2, V-5 volt and at y = 4, V = 10 volt. a) Fi cis. 30μc…

A: Electric field is also known as electric strength and electric intensity. Electric field is the…

Q: "In getting the Norton's equivalent current source, we assume all sources to be equal to zero…

A: In norton theorem circuit is replace by norton equivalent current source parallel with norton…

Q: Determine the unknown voltages using Kirchhoff's voltage law V₂ www R₂ = 5.6 k 10 V 6 V 24 V- V₁ R₁…

Q: 21) For the circuit shown in fig.(*), find the average power consumed n the 2 2 resistor if: v(t) =…

A: Given circuit with Voltage and current source v(t) and i(t) with harmonics.

Q: A 12-stage impulse voltage generator has a capacitor C. The wave front resistance equal to 0.6kΩ and…

A: n= 12 Wave front resistance, R1 =0.6 kilo-ohm = 600 ohm Wave tail resistance, R2 =7019 ohm Wave…

Q: Question 3: Find the total response of the system described by the following differential equation…

A: Given here an equation and asked to find the total response.

Q: What is the PDP for the symmetrical reference inverter in Fig. below with an average load…

A: The inverter diagram is shown below, Where,The load capacitance is,C=100 pF

Q: 1. A periodic signal x(t) has a trigonometric Fourier series expansion: x(t) = ao + En=1 ancos nwot…

A: In this question we will write about Fourier series and their coefficients..... Note :- as per our…

Q: serial adder is an example of Sequential network combinational circuit grated circuit coded outputs…

A: In this question we will write about decoder and sequential circuit.....

Q: Example 7.12 An AM transmitter has a carrier power of 1 kW at a carrier frequency of 10 MHz. It…

A: In plots values are denoted in closed brackets.

Q: 4. Input two numbers from buttons and display them in a two 7-segment led. Serial ports are used to…

A: In case of asynchronous serial communication start and stop bits are used to specify the start and…

Q: Problem 6. The resistance of 1.5 km of wire of cross-sectional area 0.17 mm² is 150 22. Determine…

A: Given: Resistance, R=150 Ω Length, l = 1.5 km = 1500 m Cross sectional area, A=0.17 mm2=0.17×10-6 m2

Q: Find the total response of the system described by the following differential equation given that y…

Q: What are the W/L ratios for the transistors based on Fig. below ?of a three-input NAND gate +2.5 V Q…

A: Given: Consider the following figure: To find: What are the W/L ratios for the transistors based on…

Q: In an RLC series circuit as shown in Figure 2, R = 40 , L = 1 H, C = 16 x 104 F, and the voltage…

A: Since you have posted multiple different questions. we will solve the first question for you. To get…

Q: Design a simple current mirror using a current of 1 µA and VGS of 1 volt.

A: Given that I=1μA, VGS=1V The basic constant current source current mirror is shown below.

Q: Q1:- Find i, (t) for t> 0 in the following network fig. (1): 4 kst www 2k12 2 kt 12 k 4 mA 100 μF,…

Q: Q/using Thevenin's theorem, find the current passing in the resistance 3 ohm ? 2 A 452 20V IA 25 32

A: Given here a electrical circuit and asked to find the current through the 3 ohm resistor using…

Q: C *.accepts this data and redistributes it to the n outputs................. encoder De-multiplexer…

A: Combinational circuit outputs depends on present inputs Sequential circuit output depends on present…

Q: Find the inverse z-transform of X (2) = 1 (1-0.25z-¹)

A: Given: Xz=11-0.25z-1

Q: the following series circuit, find the equivalent resistance and voltage across each resistance.…

Q: A 14/2 type NM copper used for a general lighting branch circuit Ampacity : Maximum fuse or circuit…

A: Circuit breaker:- Circuit breakers are used for safety purpose in electrical equipment. It is used…

Q: 23. A 7.46 KW, 230 V, 3-phase, 50 Hz 6 pole squirrel cage induction motor operates a full-load slip…

Q: The shaft torque of a diesel motor driving a 100V dc shunt-wound generator is 25Nm. The armature…

Q: Assume that V is a function of y and at y =2, V=5 volt and at y = 4, V = 10 volt. a) Fi. cis. b) Now…

Q: (3) A digital system is required to amplify a binary encoded audio signal. The user should be able…

A: For a digital system we need to calculate the minimum number of bits required to encode in staraight…

Q: Construct the magnitude and phase plot for the following transfer functions 100(s +20) H(s) = s(s+…

A: By observing se can se that the system is single input single output. The order of the system can be…

Q: 1 52 V 2 452 www E V₂ ww 10 2-22 M 2A 100 4 12 V4 3 www C 2.12 ww 5n SA 3.2 ≤42 0 1A

Q: a:Find the transfer function for the control system of fig. ? b:Determine the transfer function for…

A: For the above given question we need to calculate the transfer function of the system by using block…

Q: In RL and RC parallel circuit, if the value of R= √L/C, then prove that the impedance of the entire…

Q: B/ Find the (BCD) for the decimal number (71536) when the code is :- 1- code (9,- 4, 3, -2) 2- code…

A: Given here a decimal number and asked to find its representation in BCD code when different codes…

Q: B. Find the current through a 5-H inductor if the voltage across it is: (301² v(t)= 1o. 1>0 1<0

Q: Q1/ Write ( 1- The logical expression Y (A, B, C, D) = (0, 3, 5, 7, 8, 12, 14) is equivalent to Y…

A: NOTE: . As per our company guidelines we are supposed to answer only first three sub parts only.…

Q: Explain about rectifying action of crystal diode

A: Crystal Diode A semiconductor diode or P-N junction diode is a two-term device that allows the…

Q: What will be the resonant frequency (in kHz) of a tank circuit when the capacitance and inductance…

A: Given, A tank circuit with, Capacitance, C=0.04 mF Inductance, L=0.04 mH

Q: b. For the simple circuit shown in figure, the state variable x is the line current I, The…

A: The Given Measurement errors are I:0.04A, U:0.02V, P:0.1 W.

Q: Find the Thevenin's and Norton's equivalent circuit -j5 Ω . 12 Ω 60/45° V j6 Ω 13 Ω 10 Ω bc 8 Ω

Q: +41mV +15 mV Calculate Vo for the circuit shown below 600 k www 15kQ2 www 30 k www 30 ks2 www 15KQ2…

Q: Q3/ Determine the centre frequency, maximum gain, bandwidth and type filter for the circuiting…

A: The given circuit is a cascade connection of high pass filter and low pass filter.

Q: . Compute the value of C which results in resonance for the circuit shown below wher f=2500/pie Hz…

A: In this question, We need to determine the value of capacitance C If resonance frequency = 2500/π…

Q: For the series circuit in Figure 3. Determine the total impedance Z₁ expressed in Rectangular form.…

Q: Q1) Choose the correct answer 1. A periodic signal x(t) has a trigonometric Fourier series…

Q: 25-9. A tuned circuit consisting of 40-µH inductance and 100-pF capaci- tance in series has a…

A: Given, A tuned circuit consists, L=40 μHC=100 pFBW=25 kHz

Q: For the circuit of fig.(1), the voltage and current sources are given in a form of Fourier series…

A: Given data : Vt=60+40sinωt+40sin3ωt+20sin5ωt+30Vit=30+20sinωt+15sin2ωt+10+10sin3ωt A

Q: An asynchronous electric motor has a characteristic of 2500 W / 220V / 45Hz / 0.85 pf. Calculate (a)…

A: Synchronous motor is a motor in which the motor runs at synchronous speed. The stator of the…

Q: Example 13.2. A 2-wire d.c. distributor AB is 300 metres long. It is fed at point A. The various…

Question

In the following parallel circuit, find the equivalent resistance and the total current in the circuit. Given the following: R1=6kΩ R2=3kΩ R3=7.3kΩ VT=20V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Refer to the circuit shown in Figure 6-22. The circuit has an applied voltage of 24 V and the resistors have values as follows: R1=1kR2=300R3=750R4=1k An ammeter and a voltmeter indicate the following values: IT=42.5mAI1=24mAE1=24VI2=18.5mAE2=5.5VI3=0AE3=18.5VI4=18.5mAE4=18.5V What is the most likely problem with this circuit? FIGURE 8-22 Determine resistor values using the color code and find all missing electrical values.
The voltage drop of a series circuit is _____. a. the amount of voltage lost through any load b. proportional to the resistance in that part of the circuit c. equal to the voltage being applied to the circuit d. all of the above
A series circuit contains the following values of resistors: R1=510R2=680R3=390R4=750 Assume a source voltage of 48 V. Use the general voltage divider formula to calculate the voltage drop across each of the resistors. E1=VE2=VE3=VE4=V
Refer to Figure 8-21. Assume that the resistors have the following values: R1=150R2=120R3=47R4=220 Assume that an ohmmeter connected across the entire circuit indicates a value of 245 . Does this reading indicate that there is a problem with the circuit and, if so, what is the most likely problem? FIGURE 8-21 Series-parallel circuit.
In the following series circuit, find the equivalent resistance and voltage across each resistance. Given the following: R1=1.2kΩ R2=5kΩ R3=3kΩ VT=25V
Using the voltage divider rule, determine the voltage Vab in the circuit below. Vab=Va-Vb
In an electrical circuit four resistors are connected in parallel and their equivalent resistance is 50ohms. Find the value of each resistors if the currents through each impedance are 0.8, 0.4, 0.6 and 0.2 ampere.
The purely series resistive circuit has 12V dc supply and R1=2 ohms, R2= 1.5 ohms, and R3= 2.5 ohms. Calculate the total resistance, total current, and voltage in each resistor. Using a clean sheet with your name, show your complete solution and upload the image of your solution. Box all your answers in solution
When the resistors are connected in series the total resistance is measured as shown below. Solve for the total resistance. Note: Show systematic solution.
Show me a circuit diagram that has a 10V voltage source called, E1, which supplies a current I1. There are two resistors in series: R1 which is 4.8ohms and R2 which is 3.2ohms. There is a node between the resistors called “a”. The ground is on the negative end of the voltage source.
The circuit is composed of series parallel resistors with a voltage source. Compute for total resistance (Rt) , Total current (It) and V1…..when SW1 is open.
A delta connected resistors have the same resistance "x". Find the equivalent wye connected resistors in terms of "x".