Find the difference. 11010011two − 1011101two _____two

Q: Draw state diagram for sequence 11011 of non overlapping condition.

A: To draw state diagram each state is represented by a circle. The transition from one state to…

Q: what is the standing wave of a 75 ohm connected to 50 ohm transmission line?

A: The characteristic impedance is Z0=50 ohms.  The load impedance is, ZL=75 ohms The standing wave…

Q: What is 11? (Do not include the unit) * Your answer

A: In this question we need to find a current I1

Q: 5) Simultaneous opening of local as well as remote breakers are achieved with distance protection…

A: Choose the correct option Simultaneous opening of local as well as remote breakers are achieved with…

Q: Which button is used to cut the component in LTspice program?

A: Electrical circuits are designed for various experiments. The circuit is first run on a circuit…

Q: In a string of suspension insulator with three units,the line unit has 15kV and k=0.15. The voltage…

A:

Q: 2. What is type of Ring counter Explain them? 3. what is Decade Counter Explain it?

A: to explain the type of ring counter to explain decade counter

Q: TRUE OR FALSE? Prior period error are corrected current and prospectively.

A: Prior period error It is defined as The financial statements prepared from deletion as well as…

Q: The sequence of the positive sequence network is ………………………. To the faulty network

A: Fill in the blanks with appropriate words: This is based on the fault.    The sequence of the…

Q: When used as service equipment, a panelboard (load center) must be ______________________ that is…

A:

Q: What is the approximate line-to- grounded arcing fault value on a 480 / 277-volt system where the…

A: The given system is a 480 / 277-volt system.  The line-line-to-ground-fault current is 30,000…

Q: differentiate between overhead service connection and under ground service connection with sketch

A: Overhead Service Connection:- Electric locomotives, trolleybuses, and trams receive their electrical…

Q: b. Ground-fault protection c. Service-entrance conductors d. Branch circuits

A: Given: The answer is shown below:

Q: True or False: We can use BLOG term in 66 blocks to remember the wire order, and remember to start…

A:

Q: In a signal phase, pedestrians are allowed to cross the street walking in the same direction as…

A: It is given that: Crosswalk length=L=722 ft=36 ftWE=9 ftWE<10 ftδp=4 ft/secNpld=20

Q: How many numbers

A:

Q: With the aim of a schematic, explain the principle of high impedance busbar protection.

A: High impedance bus bar protection requires High impedance CT with high knee point voltage and the…

Q: When the address bus is turned on, 1. ALE DEN* DT/R* 1O/M*

A: address bus in the microprocessor used to transfer the address data from the one point to other…

Q: rating of a OCPD reads 25 KA as the interrupting capacity of the unit - a short circuit beyond that…

A: In this solution we discuss about shot circuit capacity of CB's.

Q: Which of the device number used to show the directional power relay in drawings of power system…

A: 32 - Directional Power Relay 21 - Distance Relay 59 - Overvoltage Relay  52 - AC Circuit Breaker

Q: can you explain the highlighted

A: Brief description: According to the given question they want to know explanation for the shaded part…

Q: Correct and detailed answer will be Upvoted else downvoted. Thank you!

A: According to question: As there two voltage sources of different frequencies of 4rad/s and 8rad/s…

Q: Go straight a head and at the * traffic lights

A: Go straight ahead and turn at the traffic lights.

Q: d IB, Ic, Ie, and VCE-

A: A bipolar junction transistor is a three terminal device having controlled current at the controlled…

Q: How many 2x1 multiplexers will be required to construct 8x1 multiplexer?

A: In the given problem we have to construct an 8x1 multiplexer with the 2x1 multiplexer. There are two…

Q: how are changes to sections of code from previous identified in the nec

A: Under the National Electrical Code (NEC), It provides the electrical safety in industrial…

Q: Subject Test

A: The given data from the question is depicted below: P-n junction diode is doped on p-side with…

Q: please create a venn diagram using words given in the box to contrast and compare electric motor and…

A: Comparison between electric motors and generators from the given points: Electric Motor…

Q: What is the purpose of installing a bell to a residential building?

A: A bell installed to a resident building is used as a signaling device. Which gives indication of…

Q: Get the positive and negative half cycle of both questions please,

A: According to the question, we need to plot the outputs for the given circuit. Note: Considering the…

Q: Please need correct answer fast Q1)

A:

Q: Where does the 10 come from?

A:

Q: b) What is the difference between systematic and random errors; then list the reasons for equipment…

A: Random Error :-  The uncertain disturbance occur in the experiment is known as random error. These…

Q: For large services busbar may be used from the ______ to service equipment

A:

Q: 84. Which of the following is not a communication system? a. Telex b. Telephone c. Hand signals d.…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Question No. 9 Differentiate between Gray and BCD Codes.

A:

Q: What is the minimum height of electrical service entrance

A: The Minimum Height for an Electric Service Meter is actually specified by the local electric utility…

Q: Which statement is correct

A:

Q: Tubular strip lights is an best example for |type lamp.

A: Given  Tubular strip lights

Q: The contractor is controlled by?

A: According to the question we have to discuss the contractor is controlled by.

Q: flab,code):1I(0, 3,6,9,1!,19,20,24,25, 26,27,28, 29, 30) ΠD (,.a,12,13)

A:

Q: Implement the following functions using 4:1 Multiplexer

A:

Q: Z1

A: Given that R1=5ΩR2=3ΩC2=17F

Q: Please answer very soon will give rating surely

A: Let the current flow according to the given rating be i.

Q: Which one is gray code?

A:

Q: No plagarism please! Correct and detailed answer will be Upvoted else downvoted. Thank you!

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.