Answered: Find the force constant of the spring.…

Find the force constant of the spring. Assume that the angle that the ramp makes with the horizontal is 22°. Recall that the mass of the puck is 0.180 kg and g= 9.80 m/s?

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.48P: Find the smallest distance d for which the hook will remain at rest when acted on by the force P....

See similar textbooks

Related questions

Q: A ball of mass m1 and a block of mass m2 are attached by a lightweight cord that passes over a…

A: Draw a free-body diagram of the given system. Part (a) Apply Newton's second law to the mass m1,…

Q: The coefficient of kinetic friction under block A in Fig. 24-A is 0.30 and under block B is 0.20.…

Q: Two objects are connected by a light string that passes over a frictionless pulley as shown in…

Q: 3. The 75-kg chest shown is intended to be moved P= 400 N 15° 一十一 under the condition shown. Does…

Q: A jet traveling at a speed of 120 m/s executes a vertical loop with a radius of 500 m. (See next…

Q: Find the downward acceleration of ml if it has a mass of 27.8 kg and the kinetic coefficient of…

A: Note: it is asked to determine the acceleration when the surface is frictionless. Consider the free…

Q: k Force Cart I Cart 2 Sensor Mass = M Mass = 3.5M The figure above shows second experimental setup.…

A: After releasing from spring the cart 1 is free to move with some velocity and when it collides with…

Q: There is a 3,2kg slider ring is going down from the rest position A and slides in frictionless guide…

A: Calculate the potential energy of the slider at A considering B as datum surface. UA=mghA Here, UA…

Q: The propeller on an airboat used in the Florida Everglades moves air at the rate of 40 kg/s. When at…

A: The flow across the propeller is applying a thrust on the airboat. This force can be used to move…

Q: A block of mass m = 1.40 kg is at rest on a ramp of mass M = 3.90 kg which, in turn, is at rest on a…

A: Given Data: The mass of the block is m=1.40 kg. The mass of the ramp is M=3.90 kg. The displacement…

Q: A comet orbits the sun (mass mS) in an elliptical orbit of semi-major axis a and eccentricity e. (a)…

A: The orbital speed of cornet orbiting around sun is given by:→v=GM(2r-1a)12 where, M=Mass of…

Q: The system in the figure is released from a standstill. Using the conservation of energy, Find the…

A: The free-body diagram of the system is shown as the velocity at the starting point will be zero and…

Q: A 200-lb block is sliding along a horizontal plane at 4 ft/s when a force P is applied on it as…

Q: In a Porter governor, the mass of the central load is 18 kg and the mass of each ball is 2 kg. The…

Q: A ball of mass m, and a block of mass m, are attached by a lightweight cord that passes over a…

A: From the Newtons second law on the ball, For the ball to accelerate upwards, the necessary…

Q: A flypress has two rotating spheres, each of mass 5 kg, fixed to a horizontal arm, s that they are…

Q: m R

Q: In the figure below, what is the acceleration of mass (m)? How long does it take to go from the…

A: In the given problem, using D'Alemberts principle, an inertia force will b applied opposite to the…

Q: Obtain the equation of motion by drawing the free body diagrams of the given system.

Q: A block of mass m,= 20kg is attached to a spring with a spring constant k 100N/m and dropped from…

Q: The box has a mass of 50 kg and is at rest. When it is pulled with 1000 N it reaches speed of 5m/s.…

A: Given data: Initial velocity of the box, u = 0 m/s. Final velocity, v = 5 m/s. Mass of the box, m =…

Q: Derive the kinetic energy equations and the mass equivalents of the system shown.

Q: An air-to-air missile with an engine thrust of ( 45 kN ) was launched hortzontally from a fighter…

A: The force which the engine of an aircraft exerts on the plane is termed as thrust. This thrust…

Q: Iction the box and the inCiined planie is 0.45, A. the tension B. the frictional force C. If the…

A: here take angle +ve w.r.t. horizontal in clockwise and -ve w.r.t. horizontal in counter clock wise…

Q: The figure shows a junction of mass m = 10kg sliding on a rod in a vertical plane. Positioned 1…

Q: The figure shows a pendulum bob that is moving in a vertical plane. At an angle theta 0° it has a…

A: Draw a diagram for the problem when the angle is 30o. Here, A, B, and C are as shown in the…

Q: A 200-lb block is sliding along a horizontal plane at 4 ft/s when a force P is applied on it as…

Q: The 2 kg bracelet in the figure is released at point A without initial velocity. The ring moves…

A: we are given; Mass=2kg Spring constant k=600N/m

Q: Q3: In the system, find the motion equation of the mass (m).

Q: Find the downward acceleration of m1 if it has a mass of 18.6 kg and the kinetic coefficient of…

A: Given data: - The mass of block 1 is m1 = 18.6 kg. The mass of block 2 is m2 = 5 kg. The mass of…

Q: The free-body diagram is shown. Find the normal force N and the friction force F. Your answers will…

A: Consider the free body diagram shown below for the skier.

Q: (a) Find expressions for the mass's (vertical) velocity v(t) (relative to its equilibrium position)…

Q: 2.The block on the incline has a mass of 50 kg and the hanging weight 100 kg. The coefficient of…

Q: A 200-lb block is sliding along a horizontal plane at 4 ft/s when a force P is applied on it as…

Q: Rocket sleds were used to test aircraft and its effects on human subjects at high speeds. It is…

Q: Consider three identical masses, each with mass m, which slide frictionlessly along a hoop with…

Q: A 5-kg small ball is doing circular motion in horizontal plane connected by two strings A and B to…

A: Given: The mas of the ball is m=5 kg, The speed of the ball at the location shown is v=3.5 m/s. The…

Q: A "swing ride" is shown in the figure. For b=1.6 m, L=4.2 m and 0=36° neglect the mass of the cables…

A: Given:-b=1.6mL=4.2mθ=36°m=37kgTo find:-1) Radiys of horizontal circle2) Tension in cable3) Velocity…

Q: Problem 4 A crate of mass M rests on a horizontal plane having a coefficient of kinetic friction Hx.…

A: Velocity of crate after t seconds will be, v=[PM(cosθ+μksinθ)-μkg]t.

Q: A body of weight 450 N is pulled up along an inclined plane having inclination 30° to the horizontal…

A: Given: W=450 Nθ= 30°μ=0.25

Q: Two pucks (masses ma and mB) collide in an elastic collision on a frictionless air hockey table.…

A: Given, Known are mA , mB , vA1 , vA2

Q: Two propellers of lengths and masses l, L and m, M rotate in the same direction, as shown in the…

A: To find: The angular velocity with which the right propeller ends up after both propellers have…

Q: Find the downward acceleration of ml if it has a mass of 87.3 kg and the kinetic coefficient of…

A: Given: Mass of the block 1 is 87.3 kg. Coefficient of friction is 0.2. The system is shown below:

Q: Find the smallest distance d for which the hook will remain at rest when acted on by the force P.…

A: To determine the distance d for which the hook will remain at rest.

Question

Find the force constant of the spring. Assume that the angle that the ramp makes with the horizontal is 22°. Recall that the mass of the puck is 0.180 kg and
q= 9.80 m/s².

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Elastic Constants and Their Relationship

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The chain OA is 25 ft long and weighs 5 lb/ft. Find the maximum force in the chain and the distance H.
In a modified version of the cart and bucket, the angle of the slope is alpha = 34.9∘ and the bucket weighs 295 N. The cart moves up the incline and the bucket moves downward, both at constant speed. The cable has negligible mass, and there is no friction. What is the weight of the cart?What is the tension in the cable?
Obtain the equation of motion by drawing the free body diagrams of the given system.
When the mass of the second stage of the rocket is x, find the equations of ⊿V1 for the first stage and ⊿V2 for the second stage.
The angle of the slope 23.0∘ and use a different cart and a different bucket. You observe that the cart and bucket remain at rest when released and that the tension in the cable of negligible mass is 175 N. There is no friction. What is the weight of the cart? What is the combined weight of the cart and bucket?
Find the weight suspended from a vertical spring whose modulus is 100 lbs/ft and around 2 seconds as its period of motion.
The system in the figure is released from a standstill. Using the conservation of energy, Find the velocity of mass m1 after hitting the ground and the maximum height at which m2 will rise. Use the masses in terms of gravitational acceleration and h? (neglect friction forces)
A “swing ride” is shown in the figure. For b=1.6 m , L=3.8 m and θ=31o ,neglect the mass of the cables and treat the chair and person as one particle with mass m=33 kg:
Calculate the expected acceleration (Eq. 2) and the experimental acceleration (Eq. 3). This hanging mass will supply the unbalanced (net) force acting on the cart. The track is assumed to be frictionless, so the only force present is that from the hanging mass. m1 (hanging mass), m2 (cart).
In a governor of the Hartnell type the arms of the bell-crank leversare equal in length, and those carrying the operating masses arevertical when the governor is rotating at its mean speed of 775rev/min, with the masses moving in a circle of 175 mm diameter -The usual central controlling spring is replaced by two paralleltension springs direetly connecting the operating masses. Find(a) the magnitude of each operating mass if a force of 90 N isrequired at the sleeve to maintain it in the mean speed positionwhen the specd is increased from 775 to 800 rev/m in(b) the stiffness, or rate, of each spring if the ratio of sleevemovement to increase of speed is 1 mm to 10 revImin when inthe mean speed position.
A spring-based toy gun is used to shoot a ball of mass M straight up.The ball is not attached to the spring. The ball is pushed downward into the spring so that the spring is compressed toa distance S below its relaxation point. After the release, the ball reaches a maximum height 3S,measured from its relaxation position, see Fig. 1(b). (a) Find the constant of the spring. (b) Findthe equilibrium point of the ball when it is on the compressed spring with no forces other than gravity and thespring acting on it. Clearly indicate the point you are using as the origin of your coordinate system and which direction is positive.system and which direction is positive. (c) Now the ball is glued to the spring so that it oscillates up and downinstead of flying off the spring. The spring is again compressed to the same distance S below itsof relaxation. Write an equation for the position of the ball as a function of time after it is released. Indicateclearly which point you are using as the origin…
The super-container vessel has a total mass displacement of 23000 long tons. This vessel towed by a tugboat with α=20⁰ angle with horizontal. If a constant tension is applied as F=320 kN by the tugboat, please calculate the time to bring the vessel to a speed of 2 knot from the rest. At these low speeds, please neglect the hull resistance that created by the motion. Note: (1 long tons = 1016.05 kg, 1 knot=1.151 mi/hr= 0.5144 m/s)