Answered: Find the odd one out. Link state…

Find the odd one out. Link state update Link state request Link state response Hello packet What is the default router priority value for all OSPF router? 0 1 200 255

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 3RQ

See similar textbooks

Related questions

Q: Configure the router interface GO/O on R1 with the following addresses. Read the tasks required and…

A: Given: The course is switching and routing and wireless essentials

Q: Question 13 Which of the following actions correspond to SDN approach? A router exchanges messages…

A: Software-Defined Networking (SDN) is a method of network design that enables a network to be…

Q: 84. A network point that provides entrance into another network is called as ___________. a. Node b.…

A: A network point that provides entrance into another network is called as ___________.

Q: as a next hop address associated with a destination network? a. local routes b. remote routes c.…

A: 18)Which routing table entry has a next hop address associated with a destination network? a. local…

Q: A router in the same subnet as a designated router will share routing information with which routers…

A: option c - designated router and backup designated router. These routers helps to exchange…

Q: A router has the following RIP routing table: NET COST DEST. Netl E Net2 |2 Net3 1 F Net4 5 G What…

A: Given ,

Q: Which of the following option is the correct statement regarding the router? Choose an answer A…

A: Introduction: The input ports of the router can perform several functions.

Q: Moving to the next question prevents changes to this answer. 06 Question 5 Save Amer Suppose that a…

Q: ____ is a non-proprietary FHRP protocol that provides mechanism for determining which router should…

A: The correct answer is : (a) Virtual Router Redundancy Protocol

Q: 20)This command is used to display ARP table in a Cisco router. a. tracert b. ping c. show ip arp d.…

A: Required: This command is used to display ARP table in a Cisco router. a. tracert b. ping c. show ip…

Q: Observe the router configuration command given below and identify the following: Router(config)#ip…

A: It is defined as the device that receives and sends data on computer networks. Routers are…

Q: Router priority is based on the following: Group of answer choices loopback0 address ip address…

A: An IP address is a unique address that identifies a device on the internet or a local network.

Q: Assume the command #access-list 10 permit any follows each standard ACL below or #access-list 110…

A: Access Control Lists (ACLs) perform packet filtering to control the movement of packets through a…

Q: oth RIP and OSPF discover a route to a particular network. The two routes are different, but their…

A: Option a is the correct option. OSPF will be preferred because it has a lower administrative…

Q: Divide the following networks into multiple area and assign a type for each router (IR, BR, ABR,…

A: ANSWER: Internal Routers will be routers whose interfaces all have a place with a similar area.…

Q: When a router with a higher priority joins the same group, issue the command to compel the HSRP…

A: Introduction: Hot Standby Router Technology (HSRP) is a Cisco proprietary protocol that allows for…

Q: Find the Network address, subnet mask and broadcast address of the network 80 Hosta LAN 1 10.0.0.0/8…

A: Given : Find the Network address, subnet mask and broadcast address of the network

Q: Draw a NAT Table Entry at the Router for the Computer (A) (shown with a smiley face J) trying to…

A: The above question is solved in step 2:-

Q: 11. The router which is Joining local areas to backbone area in hierarchical structure of OSPS is…

A: Solution:- 11. Routing devices that belong to more than one area and connect one or more OSPF local…

Q: A bridge uses a filtering table; a router uses a routing table. Can you explain the difference?

A: Bridge and router A bridge can filter, flood or forward based on its MAC address forwarding table.…

Q: An ICMP time exceeded message is generated

A: A time exceeded message is generated if The time to live field has zero value and Fragments of the…

Q: Create an IPv6 Default route in Router1 to PC5 (2001:db8:5::/64)

A: the IPV6 default route is created for router 1 below

Q: In case if a router learned more than one paths that are guide to the destination network from the…

A: Given:

Q: 143. Which of the following device is used to connect two systems, especially if the systems use…

A: Given: 143. Which of the following device is used to connect two systems, especially if the…

Q: Which is not the element of router? Routing table Forwarding Table Buffers…

A: Given: Which is not the element of the router? Routing table Forwarding Table…

Q: 3. A router has the following RIP routing table: NET COST DEST. Netl 4 Net2 2 C Net3 1 F Net4 5 G…

A: Net cost Dest Net1 3 E Net2 2 C Net3 1 F Net4 5 G

Q: Create IPv6 Static and Default Route: Create Static Route from Host A to Host B Create…

A: Static Routing: ============================================================================== 1.It…

Q: Access control lists (ACL) are rules, typically applied to router interfaces, that specify permitted…

A: In computer networking, an ACL is one of the most fundamental components of security. The main idea…

Q: A _______ is a three-layer device that handles packets based on their logical addresses. a. repeater…

A: We are asked a question on a device which deals with logical addresses and is used to transfer the…

Q: Multiple choice in network You have an interface on a router with the IP address of…

A: Given: IP address of 192.168.192.17/29. Required: to find the broadcast address the hosts will use…

Q: For the Internerwork shown in Figure Q4 below, Show the basc configuration (do nor include IP…

A: for the internetwork shown in figure q4 below, show the basic configuration (do not include ip…

Q: The following two configuration commands can realize the router RTA to the same destination10.1.1.0…

A: Solution:-- 1)As given in the question is asked for the correct answer of the given…

Q: Copy running-config to startup-config Set name for routers in the network. Change the clock rate as…

A: Instructions: 1. Enter into privileged mode 2. Show the active configuration in memory 3. View the…

Q: Create IPv6 Static and Default Route: a) Create an IPv6 Default route in Router2 to PC0…

A: Create an IPv6 Default route in Router2 to PC0 (2001:db8:3::/64) Before configuring the device with…

Q: Which of the following actions correspond to SDN approach? A router exchanges messages with another…

A: Option A- is incorrect because in SDN routers dont exchange messages with each other directly.…

Q: The functions of dynamic routing protocols are: O determining the default gateway O determining the…

A: Dynamic routing is a networking technique that provides optimal data routing.…

Q: What does a distance vector router send to neighboring routers as part of a periodic routing-table…

A: Here option a) is correct the entire routing table

Q: Network congestion is manifested by which of the following? a. packet loss caused by buffer…

A: Network gets congested when the traffic gets too much on the network.

Q: q18- When the destination network is not listed in the routing table of a Cisco router, what is…

A: A router is a systems administration gadget that advances information bundles between PC…

Q: 1. Enter privileged EXEC mode. 2. Enter global configuration mode. 3. Apply a hostname BA to…

A: 1.Privileged EXEC mode. From user EXEC mode, enter the enable command. prompt:- Switch# To exit to…

Q: answer all the three choosing the answer option. Thanks a lot in advance. 54) ___________ A passive…

A: A passive IDS is a type of system which is designed for only monitoring and analyzing activity of…

Q: What name is given to the packet journey as it moves from one router to the next? Select one: A. Hop…

A: The Internet Protocol (IP) is a network protocol that describes how communications are routed from…

Q: 4. An ACK segment that carries data will not consume sequence number. True / False. Answer: 5.…

A: 1. An ACK segment that carries data will not consume sequence number ANS: - False An ACK segment…

Q: Write the command to force the HSRP protocol to conduct a re-election process when a router with…

A: Hot Standby Router Protocol (HSRP) A large class of legacy host of implementations that don't…

Q: Multiple choice in network To avoids ARP request for every IP datagram Select one: a. Use ARP…

A: ARP cache is a cache memory where ARP entries are stored. Static Routing and DHCP are for…

Q: List all the static routes on each of the 4 routers required for full communication across the…

A: This is very simple. First, let us understand what is static routing. Static routing is a form of…

Q: Q No 7 a) A host with IP address 132.23.44.20 and physical address B2:34:55:10:22:10 has a packet to…

A: ARP is Address Resolution Protocol. An ARP request contains the IP and Physical address of the…

Q: In link state routing, the routing table for each router is other routers A. the same as O B.…

A: I have given an answer in step 2.

Q: Assuming that the OSPF priority is the default value, determine the router-id for each of the…

A: i give this question answer in next step, Priority in OSPF is mainly used to influence/determine a…

Q: Routers look at the ________________ when making a routing decision.

A: Routers will help in routing the data packets from sender to receiver through the network

Concept explainers

Linux

An operating system (OS) is the software which manages hardware and resources, like CPU, storage and memory. The OS bridges the applications and hardware and makes the connections between all of your software and the hardware resources.

Question

Find the odd one out.

		Link state update
		Link state request
		Link state response
		Hello packet

What is the default router priority value for all OSPF router?

0

1

200

255

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

A router has a ________ to map destination addresses to the appropriate outbound link end-to-end table forwarding table mapping table connection table proxy table
q1- What name is given to the packet journey as it moves from one router to the next? Select one: A. Hop B. TTL C. Trip D. Step
QUESTION 19 DNS is a scalable protocol True False QUESTION 20 Network layer is implemented only in the network core True False QUESTION 34 Switch may allow multiple simultaneous transmissions across different ports True False QUESTION 35 Carrier sense multiple access (CSMA) eliminates all collisions True False
When redistributing a route into EIGRP, what is the mandatory parameter to use? Administrative distance may be affected by a variety of factors, including the exit interface and the IP address of the next hop.
A host-to-host link may contain several packets. Please submit a schedule of all the tasks required to fulfill one shipment. Is one delay expected to endure a set period of time while the other may be changed according to circumstances?