Answered: Which is not the element of router?…

Engineering

Computer Science

Which is not the element of router? Routing table Forwarding Table Buffers I/O Ports

Management Of Information Security

6th Edition

ISBN:9781337405713

Author:WHITMAN, Michael.

Publisher:WHITMAN, Michael.

Chapter6: Risk Management: Assessing Risk

Section: Chapter Questions

Problem 12RQ

See similar textbooks

Related questions

Q: router redundancy network, the IPv4 address of the _______________ router is configured as the…

A: In a router redundancy network, the IPv4 address of the _______________ router is configured as the…

Q: A router in the same subnet as a designated router will share routing information with which routers…

A: option c - designated router and backup designated router. These routers helps to exchange…

Q: Which of the following option is the correct statement regarding the router? Choose an answer A…

A: Introduction: The input ports of the router can perform several functions.

Q: When we run IPCONFIG without any switches, we will see all of the following information, except:…

A: ipconfig displays Internet Protocol version 4 (IPv4) and IPv6 addresses, subnet mask, and default…

Q: Suppose the destination not stored in the MAC table, what wvill happen no option is correct the…

A: The correct option is option c) the switch will send request to all except the port that is came…

Q: ____ is a non-proprietary FHRP protocol that provides mechanism for determining which router should…

A: The correct answer is : (a) Virtual Router Redundancy Protocol

Q: In a network, the local hosts are able to communicate only within the LAN, but are not able to…

A: In a network, the local hosts are able to communicate only within the LAN, but are not able to…

Q: Observe the router configuration command given below and identify the following: Router(config)#ip…

A: It is defined as the device that receives and sends data on computer networks. Routers are…

Q: Since a gateway (NAT) router only has one public IP address, but may forward packets from many…

A: We are going to understand how NAT works and how NAT could remember these many IP addresses to…

Q: Refer to the below exhibit. What protocol should be configured on SW-A Port O/1if it is to send…

A: Lets see the solution.

Q: Router priority is based on the following: Group of answer choices loopback0 address ip address…

A: An IP address is a unique address that identifies a device on the internet or a local network.

Q: Describe the structure of the IPv4 packet and the role of the major fields in the packet header!…

A: Note: There are multiple questions are given in one question. According to the rule, you will get…

Q: Find the odd one out. Link state update Link state request Link state response…

A: Hello packet. Is the odd one out

Q: When a router can’t determine a path to a message‘s destination, where does it send the message? a.…

A: Router: Router refers to a networking device, which is used to transfer data packets between…

Q: For some good reasons, a network administrator has created the following configuration to the…

A: Ipv6 static routing is used to define a connection between network using ipv6 protocol. The above…

Q: Draw a NAT Table Entry at the Router for the Computer (A) (shown with a smiley face J) trying to…

A: The above question is solved in step 2:-

Q: What is the fixed address registered in the network adapters that enable computers to connect to the…

A: Media Access Control (MAC) Address MAC address is a 48 bit address which is attached inside the…

Q: Which of the following allows a router to respond to an ARP request that is intended for a remote…

A: Given that: Which of the following allows a router to respond to an ARP request that is intended for…

Q: A bridge uses a filtering table; a router uses a routing table. Can you explain the difference?

A: Bridge and router A bridge can filter, flood or forward based on its MAC address forwarding table.…

Q: An ICMP time exceeded message is generated

A: A time exceeded message is generated if The time to live field has zero value and Fragments of the…

Q: PC1 PC2 S1 GO/0/0 GO/0/1 S2 .1 Looking for a DHCPV4 server. I cannot forward broadcasts between…

A: Given: To configure interface in VLAN

Q: PF router needs to have an unique router ID which is based on the highest IP address on any active…

A: Introduction: Routers use the Internet Protocol (IP) to connect networks, and OSPF (Open Shortest…

Q: The ___________ command is used to change the router name in packet tracer. Host Name…

A: As per the question, we need to fill the blank with appropriate choice that makes the statement…

Q: Use given Figure 1 to configure a two-router network. All router configurations must be assumed and…

A: Actually, IP stands for Internet Protocol..

Q: In a(n) _______ configuration, the administrator types the port numbers, the IP addresses, or other…

A: GIVEN: In a(n) _______ configuration, the administrator types the port numbers, the IP…

Q: An administrator is trying to enable the interface of a router. To accomplish this task, the…

A: To enable interface of router , an admin can use no shutdown command.

Q: a. Write the command to enable IPv6 unicast routing in both routers (lmark) b. Enable OSPFv3 on all…

A: According to Bartelby guidelines we are suppose to answer only 3 sub part of the question at a time.…

Q: Populate the following table with the addressing information you have located. Table 1 Router…

A: All the information can be gathered from the given image .

Q: A _______ is a three-layer device that handles packets based on their logical addresses. a. repeater…

A: We are asked a question on a device which deals with logical addresses and is used to transfer the…

Q: Multiple choice in network You have an interface on a router with the IP address of…

A: Given: IP address of 192.168.192.17/29. Required: to find the broadcast address the hosts will use…

Q: MAC address on hosts, switches and routers? Explain Draw the switch table (fully populate

A: Do we need to configure MAC address on hosts, switches and routers? Explain Draw the switch table…

Q: Determine the false statement: A. UDP uses destination IP and destination port number to identify…

Q: H1 is unplugged from this LAN by the system administrator. Does this change affect the switch table?…

A: Question:- Does change affect the table ? Answer :- No , if Host-1 is unplugged from network then…

Q: Which router command allows you to view the entire contents of all access lists?

A: Router command is asked which can be used to view the entire contents of all access lists.

Q: For the Internerwork shown in Figure Q4 below, Show the basc configuration (do nor include IP…

A: for the internetwork shown in figure q4 below, show the basic configuration (do not include ip…

Q: Copy running-config to startup-config Set name for routers in the network. Change the clock rate as…

A: Instructions: 1. Enter into privileged mode 2. Show the active configuration in memory 3. View the…

Q: a host find out the MAC address of the nearest router (= default gateway)

A: a host find out the MAC address of the nearest router

Q: How does a host find out the MAC address of the nearest router (= default gateway)? Group of answer…

A: Answer: It sees the router's IP in the computer configuration and then sends an ARP request

Q: Which one of the following mechanism can be used to prevent a sigle point of failure at the default…

A: given... question is Which one of the following mechanism can be used to prevent at point of failure…

Q: Which protocol is used the majority of the time when bonding ports between a busy server and a…

A: Link Aggregation Control Protocol is an IEEE standard defined in IEEE 802.3ad. LACP allows devices…

Q: what four functions do all routers contr

A: Introduction: It is a device used in the network to forward data packets.It redirects the data…

Q: (Cisco Packet Tracer) Requirements A. Configure PCs host IP settings B. Configure the basic router…

A: Answer :

Q: Write IOS Commands to perform the following in a router, specify the mode of configuration for each…

Q: Write the command to force the HSRP protocol to conduct a re-election process when a router with…

A: Hot Standby Router Protocol (HSRP) A large class of legacy host of implementations that don't…

Q: If we use the ROUTE -F command to wipe clean the Routing Table, our system cannot connect to the…

A: route command in Linux is used when you want to work with the IP/kernel routing table. It is mainly…

Q: A.You are working as a network engineer at Shell Info. The organization uses Cisco's IOS on all of…

A: To remove static route open command line and type this command: route delete 0.0.0.0 mask 0.0.0.0…

Q: Assume that only two Routers (Router-X and Router-Y) are involved in the virtual router…

A: Priority Scheduling: Every task gets executed depending on its priority value in this environment.…

Q: Which of the following devices can be used to connect computers and other end devices in a LAN? a.…

A: Answer : Router

Q: Which of the following actions correspond to SDN approach? A router exchanges messages with another…

A: SDN approach is stand by software defined network approach.

Concept explainers

Linux

An operating system (OS) is the software which manages hardware and resources, like CPU, storage and memory. The OS bridges the applications and hardware and makes the connections between all of your software and the hardware resources.

Question

Which is not the element of router?

		Routing table
		Forwarding Table
		Buffers
		I/O Ports

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

THINKING CRITICALLY Which of the following hosts on a corporate intranet are on the same subnet? a. b. c. d.
Which two of the following hosts on a corporate intranet are on the same subnet? a.192.168.2.143255.255.255.0b.172.54.98.3255.255.0.0c.192.168.5.57255.255.255.0d.172.54.72.89255.255.0.0
Network latency issues are often caused by SELinux or AppArmor restrictions. True or False?
Before a computer can use a router, with what configuration information must it beprovided?a. routing tableb. subnet maskc. default gatewayd. default router
Routers look at the ________________ when making a routing decision. Destination IP address Source IP address Destination MAC address Source MAC address
Question 4In UDP the datagram contains the source and destination IP address and the source and destination port address. True False