Find the phase relations for the following pairs of sinusoids. Sketch the curve e and i and determine which one LAGS and LEADS. a. v = 60 sin(377 t + 50°) V ; i = 3 sin(754t − 10°)A b. v = 6.4 sin(7.1 πt + 30°) V ; i = 7.3 sin(7.1 πt − 10°)A c. v = 42.3 sin(400 t + 60°) V ; i = −4.1 sin(400t − 50°)A

Find the phase relations for the following pairs of sinusoids. Sketch the curve e and i and determine which one LAGS and LEADS. a. v = 60 sin(377 t + 50°) V ; i = 3 sin(754t − 10°)A b. v = 6.4 sin(7.1 πt + 30°) V ; i = 7.3 sin(7.1 πt − 10°)A c. v = 42.3 sin(400 t + 60°) V ; i = −4.1 sin(400t − 50°)A

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.2MCQ: If the rms phasor of a voltage is given by V=12060 volts, then the corresponding v(t) is given by...

See similar textbooks

Similar questions

Ex. 1844. Given a sinusoidal voltage source in series with R,L, and C. The sinusoidal voltage source has a frequency of 500 Hz. R=7 Ohms, L=8 milliHenry, C=6 microFarad, V=20sin(wt) volts. Solve for the capacitor steady-state phasor current and voltage. I(jw)=Aexp(jB), vc(jw)=Dexp(jE), Express radian angles between [-pi/2,pi/2]. Solve for the capacitor steady-state time-domain current and voltage: i(t)=Fsin(wt+G), vc(t)=Hsin(wt+K) Ans: w,A,B,D,E,F,G,H,K all MKS units. ans:9
Ex. 1844. Given a sinusoidal voltage source in series with R,L, and C. The sinusoidal voltage source has a frequency of 600 Hz. R=5 Ohms, L=2 milliHenry, C=4 microFarad, V=20sin(wt) volts. Solve for the capacitor steady-state phasor current and voltage. I(jw)=Aexp(jB), vc(jw)=Dexp(jE), IMPORTANT RESTRICTION: Express radian angles between [-pi/2,pi/2]. Solve for the capacitor steady-state time-domain current and voltage: i(t)=Fsin(wt+G), vc(t)=Hsin(wt+K) Ans: w,A,B,D,E,F,G,H,K all MKS units. ans:9
Two alternating voltages are given by v1 = 15sinωt volts and v2 = 25 sin (ωt – π/6) volts. Plot both functions on the same axes and hence determine a sinusoidal expression for the resultant vr = v1 + v2. Check your answer using an analytical method. Your manager has asked you to analyse the variation in in results between the two methods
Given a sinusoidal voltage source in series with R,L, and C. The sinusoidal frequency is 600 Hz. R=2 Ohms, L=5 milliHenry, C=200 microFarad, V=70sin(wt) volts. Determine the watts and VARs for the capacitor, resistor, inductor, and source. Also find power factor. Given R1=9 Ohms, R2=1 Ohms, L= 3 milliHenries, and a sinusoidal voltage source of 5 volts amplitude and 60 Hz freqency all in series. Determine the voltage across R1: magnitude (volts), frequency (Hz), and phase (degrees).
The following circuit is powered by a polyharmonic voltage whose expression is: v(t) = 100+141.sin (1000t) + 70.7.sin (2000t) V. It is requested: a) The expression of the instantaneous current.b) Plot the amplitude and phase spectra of the voltage and current.c) The values of the apparent, active, reactive and distortion powers, justifying the results
Find the sinusoidal expression for the current iS for the system shown below: i1 = 6 mA sin(377t +180°) i2 = 8 mA sin (377t) i3 =2i2 A) iS=18 mA sin (377t) B) is = 16 mA sin (377t) C) is= 12.726 mA (sin 377t +20∘∘)
find the phase, frequency, amplitude, period of the sinusoid v(t) = 10sin(377t +45°). Graphically sketch the position of the sinusoid
1. A 70-Vac source has the following waveform. Determine: a. Vpkb. Vpk-pkc. Vrmsd. Periode. Frequencyf. Angular Velocityg. Phase Angle h. equation of the waveform (in time domain)i. the instantaneous voltage when t = 120 msj. the angle (1st occurrence) after t = 0 when the voltage is +80 Vk. the time (2nd occurrence) after t = 0 when the voltage is –10 VAnswers:a. 98.9949 Vb. 197.9899 Vc. 70 Vd. 100 mse. 10 Hzf. 20π rad/secg. 54.9124°h. v(t) = 98.9949sin(20πt - 54.9124°)i. 29.0880 Vj. 108.8253°k. 66.8639 msGive the solution for K ONLY Ans: 66.8639 ms
If a current 5.0 A lags the applied voltage 230 V by an angle ϕ, it can be resolved into two components, OA in phase with the voltage and OB lagging by 90°. If the phasor diagram in to a circuit possessing resistance and inductance in series, OA and OB must not be labelled and respectively. It has become the practice to say that the power factor is laggingwhen the current lags the supply voltage, and leading when the current leads the supply voltage. This means that the supply voltage is regarded as the reference quantity. (a) A 30 μ F capacitor is connected across the applied voltage, 50 Hz supply. Calculate the reactance of 30 μ F capacitor connected across applied voltage (b) the reactance of the capacitor; (c) the current.
Find the phase relation for the following pairs of sinusoids, (which leads and lags which by how much). Draw the phasor diagram e = 100 cos(7.2(pi)t + 2pi/9)V I = 2.5cos(7.2(pi)t - pi/12)A
Suppose we are to convert the phasor current I(jw) to the sinusoidal current i(t). Which of the following statements is/are true? The magnitude of the phasor current I(jw) is equal to the amplitude of the sinusoidal current i(t). The magnitude of the phasor current I(jw) is equal to the effective value of the sinusoidal current i(t). The angle of the phasor current I(jw) is equal to the phase shift of the sinusoidal current i(t). a. 2 and 3 b. 1 and 3 c. 2 only d. 1 only
22. Most loads are either inductive or capacitive, which of the following is not reactive in nature? Motors PC Light Bulbs Sprinkler 27. Find the amplitude of a given time domain voltage equation v(t) = 100 sin(200t + 30 deg) V. 100 60 200 30 28. A coil of copper wire has a resistance of 5.46 at 750 C what will be its resistance at 250 5.02 4.58 4.84 4.35 30. It describes the sum of angular frequency and the phase. velocity amplitude conjugate argument 31. What is the instantaneous value of a given time domain circuit with v(t) = 100 sin(377t) in 5mS. 87.45 4.75 3.29 95.10