Answered: Find the phase relationship between the…

Engineering

Electrical Engineering

Find the phase relationship between the following waveforms;- V=+2 sin (wt) I=-2 sin (wt)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.2P: Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your...

See similar textbooks

Related questions

Q: Plot the waveforms of current ly as funcuons of tine. Sz At=1 sec 8A S t=l see ww www www 0.8~ オーo…

Q: rad If w = 2n · 60 = 377aa, find the time-domain functions for the following phasor voltage and…

Q: R1 1k V1 VOFF = 0 VAMPL = 4V FREQ = 10kHZ C1 0.1uF Figure 2 2.3 Plot the waveform v for the voltage…

Q: Q8\ Determine the fifth roots of 2-j5 in polar coordinates.

Q: 2. A current source in a linear circuit has is = 8cos(500nt – 25°) %3D (a) What is the amplitude of…

Q: Q5: Covert the following phaser domains to time domains and vise versa 食 V= 50 sin V= 30 sin V=…

A: in time domain Vt=Vm↑ cos cot+θ ↙this can be sine or cosine value voltage here…

Q: If V = 60V at α = 30° and t = 1.5 ms, determine the mathematical expression for the sinusodial…

Q: he AC circuit below has o = 10 rad/s and is in steady state. The phasor iagram shows the phasors of…

Q: Vcc Rc R, R2 Rc Q2 ww ww ww

A: According to the question we have to Find the frequency value for the circuit for the given values.…

Q: A voltage wave having an equation e = 220 sin(314t+45°) + 100 sin(942t - 45°) is impressed across a…

A: Given parameters: Voltage wave expression- e =220sin314t + 45° + 100sin942t - 45° Resistance, R = 10…

Q: For the circuit below, R1=10 kW, R2=20 kW, RC=3.3kW and C1=20 nF C2=10 nF are given. Find the…

Q: H.W: Show that, sinc(0) = Sa(0) = %3D %3D

A: proof above equation

Q: From the waveform shown in the figure, determine the parameters of the harmonic voltage u(t) =…

Q: suppose R=337ohms; C=0.63microF; L=80mH; current in circuit is i(t)=Icos(9600rad/s)t where I is…

A: Ans. Shown below

Q: . Find the period of a sinusoidal current that has a radian frequency of 13 M rads/s a. 483.3210 ms…

Q: In a circuit, voltage and current waveforms are given as v(t) = 80 sin (415t - 40) and i(t) = 2…

A: Angle of V(t)= -40 Angle of i(t)=+70

Q: A radio-frequency voltage signal with a certain angular frequency w is given by its phasor - a red…

A: In this problem the signal phase angle is asked. It means that the complex function's orientation…

Q: Q Find the capacitance C necessary to improve the power factor to 0.95 lagging in the circuit shown…

Q: Q2) Assuming a sinusoidal source and uniform load flow. Analyze the following circuits and draw…

A: 1) The transformer is 1:1 transformer so the secondary voltage will be equal to primary voltage. For…

Q: 1. solve equation of the sinusoidal signal v(t) from the information, where v(t) = Vp sin ωt.…

A: In this question, solve equation of the sinusoidal signal v(t) from the information, where v(t) =…

Q: The equation of the current in a pure inductor circuit is i = 4.25 sin 157t when the impressed emf…

Q: Determine the output wave-form for the network in the figure below then calculate the average and…

Q: Sketch the final waveform of below circuit. V1 D2 9V R1 25V

A: The solution is given below

Q: What is the phasor representation of I(t)=I∘cos(ωt) at half-period? Explain. A.← B.↑ C.→ D.↗

A: According to the question, we need to find phasor representation of It=I0 cosωt A.← B.↑ C.→…

Q: 1 k2 + VL 1 µF Vs Z0 In the above figure the source frequency is 1000 rad/sec and the amplitude of…

Q: Find the current flowing through the RLC circuit connected through an AC source of 240 V as given…

A: Given data, V=240 V, R=100 Ω, L=100 mH, C=100 μF, f=50 Hz Given circuit diagram,

Q: For the waveform shown below, find Vrms v(t) HAA 4 6 8 l10 -1 2.

A: It is given that:

Q: Example: Convert the following phasors to the time domain if the frequency is 400 Hz. a) V = 10/20°…

Q: 2. Explain phasor Diagram of a sinusoidal Waveform.

Q: Iwo voltages V1= 8coswt and V2 =5sinwt are inputs to an analogue circuit. a) Determine an expression…

A: We have given two voltage sources V1=8cosωt and V2=5sinωt are inputs to an analogue circuit.…

Q: It Given : VT = Vm cos wt Vm = 310V 2) f = 60HZ = 28 2 R4 L, - 0.06 H Find: Ca) RMS caleu lated…

Q: An AC circuit has a frequency of 400 Hz. A 16-Ω resistor, a 0.0119-H inductor, and a 16.6-µF…

A: Given data are: f=400 Hz R=16 Ohms L= 0.0119 H C = 16.6 Micro Farad The…

Q: -T = r(cos0 + sin@cosø)

Q: 1. Set the function signal generator to generate square wave at f = 650 Hz and Vs p.p = 8 V. 2.…

Q: Vcc RC R RC C, -O2 Q. Q2 ww ww ww

A: We need to calculate the frequency value for the given circuit and draw the waveform for O1, O2,…

Q: 3. A sinusoidal voltage is applied to the circuit below. Determine the following: I, Irm, lavg, Ip-…

A: Given that sinusoidal voltage equal to 10V ad R = 1k ohm To find Ip Irms Iavg Ip-p

Q: Q5) For the waveform shown below, find Vrms v(t) A 2 LAA: 4 6 l10 t -1

A: The given waveform is shown below. Find Vrms.

Q: 4. Consider the two sinusoidal signals x1(t) = 3cos(@t + n/2) and x 2(1) = (3+j2)cos(@t). Let P(1)…

Q: Find the current flowing through the RLC circuit connected through an AC source of 240 V as given…

A: Given data, Supply voltage V = 240 V Resistance R=100 Ω Inductance L=100 mH Capacitance C=100 μF…

Q: Q2. Assuming a sinusoidal source and a uniform load current, analyze the following circuits, draw…

A: To draw their waveforms and mathematical relations for each circuit

Q: Please show your solution step by step. For the given question take y =5 The current across a 10mH…

A: We know voltage and current relationship for inductor , we Will use that to find out voltage across…

Q: v(t)=28*sin(8*pi*t) is a sinusoidal signal. What is the Vrms of v(t) in terms of V?

A: According to the question we need to calculate the value of Vrms.

Q: For the component shown with the given voltage and current reference directions, the voltage across…

A: A element is said to deliver energy when current leaves the possitive terminal and element observes…

Q: (p) Suppose for some arbitrary system: 1 20.97 s+2 - j2 ' s+ 2+ j2 12-0.97 H(s) = = + Write down…

A: For finding h(t) we have to take invese Laplace transform and given h(t) is causal so take only…

Q: The phasor of the impedance of an AC circuit has no vertical component. What does this mean? there…

A: Consider in case of a pure inductive circuit the current lags the voltage by an angle of 90 degree.…

Q: Q6. (a) For two sinusoidal voltages v₁ = 30 sin(at) V and v₂ = 30 sin(wt + 0.25m) V, evaluate the…

A: Given v1 = 30sin(ωt) v2 = 30sin(ωt + 0.25π) v1 + v2 = vsin(ωt +β) RMS values of v1, v2, v1+v2 half…

Q: Question. The figure given below is a plot of a sinusoidal wave. From the plot, determine values for…

Q: . Find the phasor representation of the following functions. Use Cosine as a reference A. 4 cos(2πt…

A: Given functions, A. ft=4 cos2πt-40° B. ft=2 sin 4π103t-40°

Q: 1. In the cirouit below in (a), Us(t) is given by the waveform displayed in (b). Determine iL(t),…

Question

I need to solve this question immediately. Notce (For the first picture, I need to draw the functions on graph paper). Please solve Question one in pic.1 and Question two in pic.2

Find the phase relationship between the following waveforms;-
V=+2 sin (wt)
I=-2 sin (wt)

SECTION 17.7 A-Y, Y-A Conversions
32. Using the A-Y or Y-A conversion, determine the current I for
the networks in Fig. 17.85.
12 0
12 2
9Ω
E = 60 V Z0°
Z,
YT
12 0
3 0
(b)
FIG. 17.85
Problem 32.
ll

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Assume you are working on sinusoidal ac supply voltage which is in the form of 150 sin 220 t. So apply this voltage find out following parameters. Analyze the average value of voltage. Options: A)89.85volt B)90.75volt C)86.45volt D)95.55volt
In a given circuit the applied voltage and resulting current are given as follows: v= - 200 cos (377t -45°) volts; i= 10 sin (377t +20°) Amps. Find the phase angle between the voltage and current waves. Which wave lags?
Two loads are connected in parallel to an ac source and take currents of 10 and 40 amp, respectively. If the sinusoidal waves of the component currents are out of phase by 30 elec deg, calculate the resultant current.
Find a value of inductance less than 100 Henries, which ensures that the current, IS(t), is in phase with the source voltage, VS(t) = 12 cos (2000t-45°).
Assume you are working on sinusoidal ac supply voltage which is in the form of 150 sin 220 t. So apply this voltage find out following parameters. Calculate the time period of waveform Options: A)0.035 Sec B)0.0285 Sec C)0.026 Sec D)0.015 Sec
The voltage and current values of a sinusoidal supply are given as v(t)= 240sin(314t) V i(t)=5sin(314t) A. What will be the instantaneous power?
Polyphase is defined by the presence of two or more sinusoidal voltages, each with a distinct phase angle. True False
Two units, connected in parallel, are energized by an a-c source. If the component currents are 15 and 19 amp, respectively, calculate the corresponding sinusoidal waves are out of phase by 60 electrical degrees, calculate the rms value of the total current.
If the rms phasor voltage is given as V angle= 60-degree, then how v(t) can be written.
Given a sinusoidal current of A=108cos(266t+Θ); what is the magnitude of the voltage at t=6.9 ms if the resistance is 27Ω and the phase difference is 3.21 rads, how long does it take for the waveform to complete 1/32 cycle?
|PLEASE ANSWER WITH SIMPLE COMPLETE SOLUTION FOR ME TO UNDERSTAND| An industrial motor circuit has a frequency of 35Hz and a sinusoidal voltage v=83sin(ωt+ Θ °); what is the magnitude of the current if the resistance is 365Ω at t=1.86 ms. Find the average current and peak-to-peak current if the given sinusoidal formula is the phase difference is 3.23 radians
Given a sinusoidal current of A=3cos(351t+Θ); what is the magnitude of the voltage at t=4.1 ms if the resistance is 48 Ω and the phase difference is 1.53 rads, how long does it take for the waveform to complete 1/32 cycle?