Inverse distance methodSTATIONPRECIPITATIONCOORDINATESA48(5.-6)C52(-8,4)D60(-3,-2)E47.7(5,2)F62(-3,-2)G30(4.-3)H?(-1,2)Find The Precipitation Of H using inverse distance method. Note That F And D Has The SameCoordinate.

Answered: Image /qna-images/answer/2fdc4e5d-1d4b-4423-b939-06a7dc98a6cf.jpg

Answered: Find The Precipitation Of H using…

Engineering

Civil Engineering

Find The Precipitation Of H using inverse distance method. Note That F And D Has The Same Coordinate.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: In which of the following scenarios using traffic simulation is more helpful than data-driven…

A: The following scenarios using traffic simulation is more helpful than data-driven predictive models:…

Q: AW 610 x 155 beam has two cover plates 400 x 20 mm thick placed on top and bottom of the section.…

A: Give properrties of W610 x 155 A = 19700 mm2 tw =12.7 mm…

Q: For a circular slab carrying a uniformly distributed load, the ratio of the maximum negative to…

A: As we know that, Maximum negative radial moment = 3WR216 Maximum positive radial moment = 6WR216

Q: Draw the shear and moment diagram of the loaded beam shown in the figure. Determine the Vmax and…

A: Shear force and bending moment When loads are applied to a structure, internal forces such as shear…

Q: Why are different extractants used in the determination of available Phosphorus in soils?

A: There are 17 essential nutrients required by the plants for their growth. Among that Phosphorous is…

Q: In direct shear test, continue taking readings until the horizontal shear load peaks and then falls,…

A: Explanation : The shear strength and shear strength parameters of soil such angle of internal…

Q: PI Elev 108.00m 1.50m -3% +6% A Sta 1+060 PT PC Sta 1+000 Elev 100.00m Based on the given…

Q: NO. 1. What is the maximum bending stress in the uniformly loaded cantilever beam as shown if the…

Q: The table below represents the vertical coordinates of the hydrograph of a rainstorm over a…

A: This question is from Water Resources Engineering.

Q: Ex 12-5: Farm is irrigated with irrigation interval 8 days, leaching depth in one irrigation 2.5 cm,…

Q: Oil (sg=0.87) flows from A to E as shown. The head loss is assumed to be as follows: A to B = 0.45…

A: To Determine Pressure at point C in Psi.

Q: If the soil sample is having a plastic limit of 28%, natural moisture content of 44% and a liquidity…

A: This question is related to the Soil Mechanics.

Q: 3.3. The displacement components u, at a point in a body are given by the functional components u₁ =…

Q: For the following beams, draw the simplified free-body diagram and below it the shear and bendir…

Q: you by c Feet The is not your ow of Universt W₁ do not use it any were your on Philippines Property…

Q: Determine the following of the truss shown using the method of consistent deformations: Answer:…

Q: for Pile shown in fig. below, Sind Qu дозжаз т 3m =30 Sand Ks=1.3 S=0.84 16 kN m. -- F Sand S=0.74…

A: Given, Ap = 0.3m x 0.3 m = 0.09 m2 L = 10 m

Q: In Mohr method, higher pH will produce AgOH as contaminant True False

Q: The slope at A Assume E = 29000 ksi, 1 = 984 in* b) the deflection at B 7 kips/ft 11 ft B 4 kips/ft…

Q: What is the Open Systems Interconnection reference model and how does it work?

A: Open Systems Interconnection reference model: The Open Systems Interconnect (OSI) reference model is…

Q: 904. To avoid interference, a link in a certain machine is de- signed so that its cross-sectional…

Q: Find the value of potential energy Mass=2.4 kg h=0.8 m g=10 m/s2

A: Potential energy is the energy possessed by the body by virtue of it's position.

Q: MOHRS 10min зомра зопра 10 min 2

Q: Direct Shear Test is performed to determine the consolidated -drained shear strength of a clay soils…

A: Answer:- a sandy to silty soil Explaination Direct Shear Test is actually performed to determine…

Q: Oil (sg=0.87) flows from A to E as shown. The head loss is assumed to be as follows: A to B = 0.45…

Q: • Drain is 15m above the impervious layer. The soil is non-homogeneous ,the first layer have…

Q: Draw the shear and moment diagram of the loaded beam shown in the figure. Determine the Vmax and…

A: Given:- The magnitude of the uniform load = 20 kN/m The magnitude of the point load 1 = 30 kN The…

Q: Determine the following of the truss shown using the method of consistent deformations: Answer:…

Q: 21- Using dimensional analysis to find the relationship between the shear stress (t) which depends…

Q: A one-ton car is initially travelling at 10 kph when it combusts 50 grams of fuel with calorific…

A: Solution-The given values are as followsv1=10kphCV=15000kjm=1000khTo DetermineThe final velocity of…

Q: 6.2. The design storm of a watershed has the depths of rainfall of 4.9 and 3.9cm for the consecutive…

Q: For a shallow foundation shown below: Estimate the moments about the x- and y-axis; assume that the…

Q: 1.Bitumen is obtained from a) Wood b) Petroleum c) Coal d) Kerosene 2. The resistance to flow is…

A: 1. Answer: b Explanation: Bitumen is the product which can be obtained from the petroleum and it is…

Q: If a rock is dropped from a height of 100ft, its position t seconds after it is dropped until it…

Q: Draw the shear and moment diagrams for the cantilever beam shown and determine the maximum absolute…

Q: The seepage loss in cm²/sec for a hydraulic structure, if the flow net contains 5 flow lines and 9…

A: This question is related to the Soil Mechanics.

Q: The roof of a single-story storage building shown is subjected to a uniformly distributed load of…

Q: Determine the following: a. Shear and Bending Moment Equation b. Shear and Bending Moment Diagram c.…

Q: I. Problem Solving: Answer the following and show your complete solutions. Round off your final…

Q: A 400 mm x 600 mm rectangular tied column is reinforced with eight 28-mm Ø spaced symmetrically as…

Q: A shopping centre has two types of checkouts, traditional checkouts which are staffed by cashiers,…

A: given that An average 20 older people an hour left the staffed checkout Approximately one young…

Q: A hockey puck is traveling to the left with a velocity of ₁ = 12 m/s when it is struck by a hockey…

Q: In the figure below, a fluid with a specific gravity of 0.77 is flowing. The mass flow rate is…

Q: For the figure shown below, find the deflection at the point (B) and (C)? |= Constant. 100 kN A 2m D

A: Given, P = 100 kN

Q: Two reservoirs A and B having elevations 250 m and 150 m, respectively are connected by a 250mm…

A: This question is related to the Fluid Mechanics and hydraulic Engineering.

Q: Column Load at Grid B3 A L1 + + (2) (3) L1 L1 The floor construction in this structure comprises two…

Q: 4 kN/m B 0.8 m 1.5 m 10 kN/m DA C + 1.0 m 8 kN.m 1.0 m

Q: Determine the reactions at A and B (in Newtons).

Q: 2. A car is to be driven up a 7° incline road. Determine the automobiles braking distance from 30…

Q: 2 skilled workers can do 36m² of floor finishes in a day. Assuming that a skilled worker rate is Php…

Concept explainers

Precipitation

Precipitation forms the basis of the water cycle on the Earth. The air is packed with water molecules in the form of moisture or water vapor. This water vapor usually rises to the atmosphere due to density differences. Precipitation represents any form of water, in liquid form or frozen form that forms in the earth's atmosphere. The water vapor up in the atmosphere condenses due to low temperature and it leads to the formation of clouds. The water vapor that forms clouds on account of condensation, is preferably known as cloud droplet. These cloud droplets when become heavy and can no longer sustain the weight of condensed water droplets, they come to the Earth in the form of rain, snow, ice pellets, and hail. Precipitation patterns, evaporation, and condensation are the three parameters that decide the global water cycle, climate change, and weather. Additionally, smoke and dust particles are equally important parameters for precipitation, as they provide the surface area for the water vapors to get condensed and to form water droplets. So they are known as condensation nuclei. The presence of other pollutants in the air also serves as condensation nuclei. Precipitation always results in the pure water supply to earth, as the salt from the seawater does not evaporate with the water.

Question

Inverse distance method
STATION
PRECIPITATION
COORDINATES
A
48
(5.-6)
C
52
(-8,4)
D
60
(-3,-2)
E
47.7
(5,2)
F
62
(-3,-2)
G
30
(4.-3)
H
?
(-1,2)
Find The Precipitation Of H using inverse distance method. Note That F And D Has The Same
Coordinate.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Inverse distance method -theory

VIEW

Co-ordinate with reference to H

VIEW

Final calculation

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

OIL WITH SP.GR. 0.95 FLOWS AT 200 ? ??/??? THROUGHA 500 METER OF 200 MM DIAMETER PIPE (? =0.0225).DETERMINE THE HEAD LOSS A. 121.16 ?????? B.106.21 ??????C. 116.20 ?????? D.161.20 ?????
\begin{array}{r}3 \frac{4}{5} \\-1 \frac{1}{3} \\\hline\end{array}
An ESP must treat 800,000 acfm with 99.1% efficiency. Assuming an effective drift velocity of 14 ft/min, calculate the required collection area.a. 152,000 ft2b. 269,000 ft2c. 347,000 ft2d. 462,000 ft2
Consider plane inviscid flow through asymmetric diffuser,as in Fig. C8.3. Only the upper half is shown. The flow isto expand from inlet half-width h to exit half-width 2h, asshown. The expansion angle θ is 18.5° (L ≈ 3h). Set up anonsquare potential flow mesh for this problem, and calculate and plot (a) the velocity distribution and (b) thepressure coefficient along the centerline. Assume uniforminlet and exit flows.
2. GLYCERIN (SP.GR. = 1.26 AND ABSOLUTEVISCOSITY OF 1.49 ?? − ? ) FLOWS THROUGH ARECTANGULAR CONDUIT 300 MM BY 450 MM AT THERATE OF 160 ? ??/???. DETERMINE THE HEAD LOST PER KILOMETERLENGTH OF THE PIPE. A. 35.27 ?????? B.32.57 ??????C. 37.52 ?????? D.37.25 ?????s
A 3-hour stom occurred in a place and the precipitations in the neighbouring rain- gauge stations P. Q and R were mcasured as 3.8, 4.1 and 4.5 cm, respectively. The precipitation in the bottle was broken. The normal precipitations in the four stations P. Q. R and S, as per station S could not be measured since the rain-gauge 2 R. previous records were 43, 48, 53 und 50 cm, respectively. Estimate the storm precipitation at station S.
Assuming an effective drift velocity of 0.25 ft/sec, calculate the required plate area, ft2. An ESP must treat 400,000 aefin with 98.6% efficiency.
Three Reservoir, named A, B, and C are connected by Pipe 1, Pipe2, and Pipe 3 respectively joining at a common junction. Determine the into or out of the reservoir A, B, and C in the pipe system, given the following data: Use n=0.011 for all pipes, hf=10.29n^2LQ^2/D^16/3 Reservoir A (EL 30m), Reservoir B (EL 24m), and Reservoir C (EL 15m) Pipe1: 30cm dia., 1200m long Pipe2: 20cm dia., 900m long Pipe3: 15cm dia., 1500m long
Water flows in a trapezoidal channel with side slope 1V:3H, bottom width of 16 ft and water depth of 4.5ft. The channel bottom drops 0.1ft every 100ft. Length, n=0.015. Show Complete Solutiona. Compute the velocity in ft/s (using Manning, Kutter)b. Compute the flow rate in ft3/s (using Manning, Kutter)
Very urgent. F = 9 kN q = 3 kN/m L = 0.5 m
HYDROLOGY WHEN t0 = 8:00AM WHAT IS THE INTENSITY OF THE OF THE RAINFALL BETWEEN 9:00AM AND 9:30AM USING A 30-MIN INTERVAL PLEASE SHOW STEP BY STEP COMPUTATION
A large storage tank open at thé top and filles with water develops a small home 16.0m vélos water level if thé flow raté IS 2.50*10^_3. Déterminé thé speed