Answered: Find the rank of the followng matrix…

Find the rank of the followng matrix For z1, find the rank of matrix A. A = 1 2 1 1 00 Find z such that the matrix A is not full rank.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.20MCQ: Consider Figure 2.9 of the text, Let the nodal equations in matrix form be given by Eq. (2.4. 1) of...

See similar textbooks

Related questions

Q: a. A 5-kW AC motor has a power factor of 65% lagging when it is connected to a 200-V 50-Hz mains.…

A: GIVEN: Power P=5kW power factor cos∅ =65% lagging = 0.65 V=200v = Vrms f= 50Hz

Q: The output voltage from an amplifier is 4V. If the voltage gain is 27 dB, calculate the value of the…

A: Given, Amplifier having Output voltage (Vout) = 4V The Voltage Gain (Av) = 27 dB The value of input…

Q: Q- A carrier wave of frequency 2.5 GHz amplitude is modulated with two modulated with two modulating…

A: Given- Carrier wave frequency=2.5 GHz, Modulating frequencies=1 KHz & 2 KHz, To Find- The total…

Q: Write a function using the block diagram shown below

A: The given gate diagram is shown below,

Q: R₁ R₂ R3 R4 Rs R6 R7 RA W R₂ R₂ W R₁ 30 V R₁2 R₁3 R₁4 75 Ω 25 Ω 50 Ω R₁1 50 Ω 25 Ω 75 Ω Fig. 3.1 W…

A: Given: A network with 30 v dc supply along 14 resistance with various values connected in variety…

Q: Bandwidth of the input to pulse code modulator is restricted to 4 kHz. The input varies from -3.8V…

A: We need to find out the number of bits per sample for given signal to noise ratio and given signal…

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: Given data, Zener voltage Vz=12 V Change in Zener voltage △V=0.0.5 V Change in current △I=10 mA=…

Q: What is the equivalent resistance between the points A and B of the network. 202 Aww 492 g 1002 www…

A: We simplify above circuit to calculate equivalent resistance, as one can see in digaram:

Q: P1: By inspection obtain node-voltage equations (GV=I) and write MATLAB commands and provide…

Q: 04- A- Consider the circuit in Fig.5, all the transistors are identical, where Re = 10 K2, B is…

A: Given: Early voltage VA=130V Resistor, Rc=10kΩ

Q: 1. Using one of the relationships for resistors connected in parallel, solve for the total…

A: Here given two different questions as per guidelines i have to answer first one please ask remaining…

Q: For a pulse-amplitude modulated (PAM) transmission of voice signal having maximum frequency equal to…

A: Given, For PAM ( Pulse Amplitude Modulation) signal, The maximum frequency component of voice…

Q: Assume that the resistor R3 is the load. Disconnect it and calculate theoretically the Thévenin…

Q: Prior to the formation of the depletion region, electrons were injected to the P type silicon from…

Q: The voltage across a 5-kΩ resistor is 16 V. Find the current through the resistor.

A: We need to find out the current through the resistor , we will it find out by using of ohm's law .

Q: 40 m 10 V Figure 6.5 1202 Select one: A. 4 V B. 10 V C. 6 V D. 8 V + V₂ See Figure 6.5. What is the…

A: We need to find out the open circuit voltage for given circuit

Q: 402 www 10 V Figure 6.5 Select one: A. 4 V B. 10 V w C. 6 V D. 8 V 120 Mw 622 See Figure 6.5. What…

A: Given circuit,

Q: Draw a block diagram for a negative-feedback system that might be used to control the level of light…

A: Negative-Feedback System:- A system with negative feedback feeds back a portion of its output to the…

Q: A technician wants to energize a 24 volt motor, but lacks a 24 volt battery to do it with. Instead,…

A: Solution !! This is perhaps the most direct solution (setting each power supply to output 12 volts):

Q: The figure below shows a mobility Nyquist plot representing the response of a single mode. The three…

A: The given Nyquist plot represents the response of a single mode. Now, as per the data given in the…

Q: 3. Write the Boolean expression: A B + D Y

A: The given circuit is,

Q: Calculate the current through the resistance R3 of the measurement circuit of the experiment, using…

Q: Determine the bit rate and quantization step of the ADC in the sampling of analog signal with x[n]…

A: We need to find out the data rate and step size for given ADC , we also need to find outnumber of…

Q: 3. Find Req. A B REQ R₁ = 652 R3 = 40 www R4 = 852 R₂ = 80 m Rg=1002 R₁ = 42 Re=622 Rg=652 www R7 =…

Q: Based on the signals below, find the Fourier transform of x(t) for (a)-(e). -2 x(t) n 2 (a) -2 -1…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

A: Total Power Pt = 2500 W Side band power PSB = 400 W We have to determine the modulation percentage μ…

Q: The output voltage from an amplifier is 4V. If the voltage gain is 27 dB, calculate the value of the…

A: Voltage = 4V Voltage gain = 27 dB We have to determine the value of the input voltage assuming that…

Q: d) The frequency f of 12лсos(300t) =300/2 O True O False

A: This is a basic problem of sinusoidal. The solution is given in the next step

Q: Apply DeMorgan’s theorems to each expression a. [ A B’ ( C + D’ ) ]’ b. ( A + B’ + C + D’ )’ + ( A…

Q: Determine minimum sampling frequency x(t)=4.5cos(194.53t)

A: As per guidelines i have to answer first question only.please ask remaining again.

Q: Two DC generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohms run in…

Q: 7. Use the truth table below to create a circuit in verilog HDL with three inputs (x,y,z) and four…

Q: n your own words, how does the Philippine Electrical Code contribute to the electrical designs,…

A: PHILIPPINE ELECTRICAL CODE ( PEC ) PEC Consists of two types of electrical installation buildings,…

Q: 4.33 Three single-phase, 10-kVA, 2400/120-V, 60-Hz transformers are connected to form a three-phase,…

A: Single phase transformer rating : 2400/120 V Three phase transformer bank rating : 4160/208 V

Q: Explain the superposition theorem and also explain Thévenin's and Norton's theorems.

A: Explain: Super position Theorem Thevenin Theorem Norton Theorem

Q: Given Figure shows the input characteristic for an n-p-n silicon transistor. When the base emitter…

A: The graph is given as the input characteristic of an n-p-n silicon transistor. The input…

Q: Which of these can be installed without needing an electrical permit first? A. Hot tub B. Bank of…

A: Electrical permit:- Evidence that an electrical contractor was in charge of the electrical work can…

Q: 1. A 5-kW AC motor has a power factor of 65% lagging when it is connected to a 200-V 50-Hz mains.…

Q: To avoid collision of two messages, Data Link layer keeps an eye on wh the media is free. This is…

Q: Determine the pulse duration of a periodic pulse train whose duty cycle is 15% and period is 120…

A: In this question we need to find pulse duration.

Q: A 1.2-kW toaster takes roughly 4 minutes to heat four slices of bread. Find the cost of operating…

Q: An accelerometer of sensitivity 10 mV/g is used to measure the acceleration of a vibrating beam. A…

A: Given, Sensitivity=10mV/g number of bit=12 bits sampling frequency, fs=25KHz cpacitance C1=1 nF

Q: Q- A carrier wave of frequency 2.5 GHz amplitude is modulated with two modulated with two modulating…

A: We need to find out the total bandwidth for given signal .

Q: Solve for ID in IMG 18 V 2kQ 1100 mA. round off your answer with 1 decimal value V-1.7 V 0.51 k

A: FET are voltage controlled device. BJT is current controlled device JFET is stand for Junction field…

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

Q: Q4: (answer in phasor form) V = 10 cos 4t i 552 0.1 F

A: We will find out the current and voltage for given circuit ,

Q: consider two buses connected by an impedance of (0 + 5j) Q. The bus '1' voltage is 100 230° V, and…

Q: In a series circuit, certain general rules may be stated with regard to quantities of voltage,…

A: Solution !! “In a series circuit, voltage drops add to equal the total.” “In a series circuit,…

Q: Yız (G₁ Z-4% 20MVA X, -15% X₂=18% X-3% If: T1: 11kV-138 kv T2: 11kV-138kV T3: 20 kV-138 kv G1: 11kV…

Q: 128. A sine wave has a frequency of 50 Hz. Its angular frequency will be A. 50 radians/sec B. 50 n…

A: Given data, Frequency is given as, f=50 Hz.

Question

Find the rank of the followng matrix
For z1, find the rank of matrix A.
A =
1
2
1
1 00
Find z such that the matrix A is not full rank.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a 4*4 Y bus matrix the number of non zero elements are 12. Find the sparsity of the system?
For the circuit attached: A. Write out the matrix equation for the voltages at the nodes B. Relate i0 to the appropriate nodal voltage(s) and resistance values.
Find the inverse of the following matrices A=[ matrix 2&3\\ -1&-4 matrix ] B=[ matrix 1&-4&8\\ -3&5&7\\ 6&2&-2 matrix ]
An electrical circuit is analysed using mesh analysis resulting in the following system of equations:i1+i2+2i3=9 4i1+4i2-3i3=3 5i1+i2+2i3=13 Determine the values of i1, i2 and i3: (i) Using Cramer’s rule(ii) By writing the system in matrix form and finding the inverse of the coefficient matrix
Answer in Linear Algebra: Matrices, Vectors, Determinants, Linear Systems
mutual leakage terms for flux linkage Ks, Ks^-1 , Ls If I multiply Ks by it inverse I should get the intentity matrix, then If I muliply by Ls matrix I should get the Ls matrix right. I did the matrix but It doenst not become the indenty matrix multpy by Ls and I also I have no Idea how the anwer would Lis at the last term of the last matrix on the first picture.
Use Alternate Thévenin and Norton transformations to solve for i.
Find circular convolution of two sequences x[n]=[4,3,2,4] andh[n]=[4,-2,3,2] using DFT transformation method (Use matrix method to find DFT and IDFT)
Determine I2 for the given equations of voltage: 5v = 2I1 + 3I2; 5v = 3I2 + 4I3; and 5v = 2I1 + 4I3. Use Cramer’s Rule.
Write node voltage equations for the circuit shown below and arrange them in matrix form. Where (E = 75 volt) and (R = 12 Ω). Note: You do not have to solve the equations.
Consider Figure 2.9 of the text, Let the nodal equations in matrix form be given by Eq. (2.4. 1) of the text. A. The element Y11 is given by (a) 0 (b) j/l3 (c)j7 B. The element Y31 is given by (a) 0 (b) j5 (c) jl C. The admittance matrix is always symmetric square. (a) False (b) True
Just simplify the matrix