Find the rms value of the voltage waveform of the given figure as well as the average power absorbed by a 9.52 resistor when the voltage is applied across that resistor. v(t) 8 Ил 02 5 7 10 12 The rms value of the given voltage waveform is The average power absorbed by the 9.52 resistor is Check V (Calculate to 2 decimal places) W (Calculate to 2 decimal places)

Find the rms value of the voltage waveform of the given figure as well as the average power absorbed by a 9.52 resistor when the voltage is applied across that resistor. v(t) 8 Ил 02 5 7 10 12 The rms value of the given voltage waveform is The average power absorbed by the 9.52 resistor is Check V (Calculate to 2 decimal places) W (Calculate to 2 decimal places)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.2MCQ: If the rms phasor of a voltage is given by V=12060 volts, then the corresponding v(t) is given by...

See similar textbooks

Similar questions

Find the following unknowns given the voltage: v(t) = 440 cos (2513t +195°) V. a.Averageb. Rms Values
A voltage given by v(t) = 311 cos (311 pi t) V is applied to a 50-ohm resistance. (a.) Sketch v(t) to scale versus time. (b.) Determine the rms value of the voltage and the average power delivered to the resistance. (c.)Determine the power as a function of time and sketch to scale.
Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the current in B lags behind A by pi/3 radians and the line current is 23.4 amp, determine the current in B.
Determine the rms (or effective) value ofv(t) = VDC + vAC = 50 + 70.7 cos(377t) V
1) 169sin 377t a) What is the RMS value? b) What is the Average value?
Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the current in B lags A by p/3 radians and the line current is 23.3 amp, determine the current in B.
Determine the rms value of v(t)=5+10 cos(20πt).
An AC generator causes 50 Hz current in a circuit containing a 290 Ω resistor, 4.89 µF capacitor, 0.362 H inductor, and switch in series. At time t=0, the switch is closed at an instant when the voltage from the generator is 0 V. We measure the rms current as 41.1 mA. a) Write an expression for the instantaneous voltage (aka, the voltage as a function of time). v(t) = ______ b) Does the voltage lead or lag the current? Explain how you know. c) Draw a phasor diagram at an instant when the current is zero. Label the phase angle. d) Draw a phasor diagram at an instant when the current is maximum. Label the phase angle.
Calculate the RMS value of the following function
44. The equation for 60 cycles current sine wave having RMS value 30 amperes, will be __ A. 42.4 sin120pi t Amp B. 30 sin 120t AmpC. 30 sin60t AmpD. 42.4 sin 60pi t Amp
(i) An alternating voltage E=200 Sin 314t is applied to a device which offers an ohmic resistance of 20Ω to the flow of current in one direction, while presenting the flow of current in opposite direction. Calculate; (a) Rms Value (b) Average Value (c) Form Factor for the current over one cycle
calculate the rms value in v of this signal shown below: