Find the steady-state -state magnitude gain excitation of the following circuit : If Nin = с 7 10 sin at Nout what is Now? for pure sinusoid

Q: V 1 R Im k ka Ta 1 Jea eq Ö 1 S @m

A:

Q: A 60-Hz induction motor runs at 860 r/min at full load. Determine a. the synchronous speed, b. the…

A: Given: In an induction motor, Supply frequency, f=60 Hz. Speed, Nr=860 rpm. Number of poles, P=8.

Q: A 500 nF capacitor is connected in series with a 100 kohm resistor and the circuit is connected to a…

A: Capacitance = 500 nF Resistance = 100 Ω = 100×103 Voltage = 50V

Q: Problem 4 For the circuit shown below: a) Use the voltage-division principle to calculate the…

A: In this question we need to find a voltage across R3 by using voltage division method and current…

Q: Find v₁ and v₂ in the circuit using nodal analysis. 10 Ω ν 5Ω 2Ω 6A 4Ω V2 3A

A: Given circuit,

Q: Verify that the closed-loop transfer function T(s) = C(s)/R(s) in terms of parameters a and pressed…

A: Given that: The block diagram is shown below. A continuous time, linear, time-invariant feedback…

Q: Hand calculate the phasor voltage for VR1 and Vc₁ using the 50 2 source resistance. Compare the hand…

A: Given RC series circuit Source voltage Vs=Vin =2.5 V at f =500 Hz R =390 Ω C =1 μF Internal…

Q: Given the equation for Charge q (t) = aebt + 20 calculate the value of Current in Amps at t = 0.08…

A:

Q: In the Internet of Things, which of the following is responsible for translating an electrical…

A: Introduction -  The internet of things,  is a networked system of interconnected computing devices,…

Q: AJFET-based common-source amplifier uses a VDD of 60V and an RD of 10kOhm. The JFET has a Vp of -8…

A: According to the question, For the CS JFET amplifier, we need to calculate (1) Voltage gain. (2)…

Q: The figure below shows a mobility Nyquist plot representing the response of a single mode. The three…

A: The given Nyquist plot represents the response of a single mode. Now, as per the data given in the…

Q: Question RF carrier 10 kV at 1 MHz is a amplitude modulated and modulation index is 0.6. peak…

A: This is a problem of amplitude modulation. The solution is given in the next step.

Q: 9. The time constant of the circuit shown in the figure below is A. 25 sec. B. 0 sec. C. .025 sec.…

A: Given data, Circuit diagram is given as,

Q: 4. Acar lot uses incandescent lamps to supply outside lighting during the night. There are three…

A:

Q: Problem-3 A 8-bit A/D convertor is used over a span of zero to of 1.0 V 2.56 V. What is the binary…

A: Given- 8-bit A/D converter , Span - 0 to 2.56 V ,   To find- Binary representation of 1.0 V signal.

Q: The expression of equivalent impedance (ZN) in the circuit shown below is? 21 ww N

A: Solution !!   Explanation: The impedance between the points a and b with the source replaced by a…

Q: In the Internet of Things, which of the following is responsible for translating an electrical…

A:

Q: A 15 nC point charge is at the origin in free space. Calculate V1 if point P1 is located .at P1 (-2,…

A: Here the given option is not matching as per the solution. The detailed solution is given in the…

Q: The terminal p.d. of a d.c. source is 22.5V when supplying a load current of 10 A. If the emf is 24V…

A:

Q: J-KL (K+LM) + (M+LM)

A: Given here a expression and asked to reduce the expression and drawing the circuit.

Q: + v₁ (t) (~ - vo(t) 50Ω Circuit Load 2. Suppose vi(t)=0 for t0. Assume a cut-in voltage = 0.7V.…

A: We need to find out the output voltage for given circuit and given input , we will find out it when…

Q: In general terms, the capacitance is ? determined by =Q/V0 True O False

A: In this question,  We need to choose the correct option  We are solving this Problem using the…

Q: he no load secondary voltage 1-phase transformer is 232 V and full load secondary voltage is 222 V,…

A: Given, VNL= 232 V VFL= 222 V % regulation = ?

Q: In the Internet of Things, which of the following is responsible for translating an electrical…

A: Electrical quantity: There are many electrical and electronics device which works when an electrical…

Q: Consider a hardware timer supplied by a synchronous clock source with a frequency of 250 kHz. How…

A: Given: The frequency of synchronous clock source, f=250 kHz. Number of counts in clock source,…

Q: Simplify the following expression by applying one of the theorems. State the theorem use (d) (UV' +…

A:

Q: Given Figure shows the input characteristic for an n-p-n silicon transistor. When the base emitter…

A: Given: Required: Base current at VBE=0.65 Volts, Static resistance, dynamic resistance.

Q: 1) GO ↑ (0 ܪܚ 10 10 101 10 no curent มน no current 101110 10-52 Co A to RT- 2500000 I+= 2.4000 A & S…

A:

Q: Complete a total table for this capacitor circuit.. (to 3 decimal places) Label all JUNCTIONS 12.0…

A:

Q: x(t) = e-3tu(t)

A:

Q: 5² +35+k 25³ +45² +55 Find the value of k that makes the final value of the system output 38. The…

A: We need to find out unknown value of k .we will use final value theorem to find out value of k .

Q: 4. The total capacitance for this circuit is C₁ SF C₂ 10 F C₁ 10 F

A: Given data, Circuit diagram is given as,

Q: Follow up questions.. (b) Pick a pair of values for parameters α and β such that the closed-loop…

A:

Q: 5. Find the transfer function and identify the poles and zeros for the circuit: following V₁: N"; R…

A: "Since you have asked multiple questions, we will solve the first  question for you. If you want…

Q: A force (Ft) per unit charge (Qt) gives the potential difference (V) True O False O

A:

Q: 1. Find the values of I1, I2, V₁ and V₂. 12/0° V + 3 Ω + V₁ 1:4 Ideal + W 4Ω V₂ -j10 Ω 24/0° V +

A:

Q: 3. Calculate the value of voltage in the circuit. 1=3 mA

A: Given data, Circuit diagram is given as,

Q: Consider a hardware timer supplied by a synchronous clock source with a frequency of 250 kHz. How…

A: Given: Frequency of synchronous clock, f=250 kHz. Number of counts, n=150.

Q: Calculate the current through the resistance R3 of the measurement circuit of the experiment, using…

A:

Q: A coil of inductance 50 mH and resistance 5 ohm is connected to a 110V, d.c. supply. Determine the…

A: In this question,  We need to determine final value of current, current after 4ms and 6ms. We know,…

Q: Does the following discrete system have the parameter of memory, y[n] = x[n-1] + x[n] ? O Maybe O…

A: Q.1) Memory system:-  A system is said to be memory system if its output is depends on past or…

Q: 5 V 7. Find i, in the circuit in Fig. 3.46. ΤΑ www 4 A ww www 11.

A: The given circuit is,

Q: contains three 60-watt lamps. The light fixture presently installed over the mirror contains four…

A: A homeowner has asked to install a lighted mirror in a bathroom. The mirror contains eight 40-watt…

Q: Decimal equivalent of Octal number (764), is, O 498 500 496 502

A: Given: The octal number is 7648.

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: In this question, We need to choose the correct option We know , impedance of the zener diode  Z=…

Q: WA (↑ 2 5 lov 15 + VX- 10 SOV

A:

Q: R1 8kQ R2 5kQ R3 1kQ R4 1.5KQ V1 Ab 12 V Figure 2 R5 3kQ R6 6kQ R7 4.5kQ

A:

Q: For the circuit, find lo when vs=12V and vs=24V. 6Ω Μ 2 Ω Μ + 2 = 4Ω ww 8 Ω Το 4Ω 30x

A: We need to find out the current for given circuit , first we will find out voltage then we will find…

Q: 1) Determine the bit rate and quantization step of the ADC in the sampling of analog signal with…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: In the circuit shown, a 5 V Zener diode is used to regulate the voltage across load R.. The input is…

A: Solution !!