Choose the correct answer/s? Find the time-domainof the followingsources: V = 200<0° V and I = 10<45°ANote: In most circuits, the givensource (either voltage or current) isin RMS values, so it should notedlike "Vrms = 240<0° V". If the case ofno denote, assume first the sourceis in RMS. So when converting itinto time-domain, convert it to Vmax[maximum value, Vmax = Vrms /(0.707)]i(t) = 10 cos(wt - 135°) ANFTOCv(t) = 200 sin(wt - 90°) Vi(t) = 10 cos(wt - 45°) Ai(t) = 10 sin(wt - 45°) Ai(t) = 10 sin (wt - 135°) Av(t) = 200 cos(wt) VOv(t) = 200 cos(wt + 1°) VOv(t) = 200 sin(wt) V

Given: V=200∠0° and I=10∠45°

Answered: Find the time-domain of the following…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A voltage is given by v( t )=10 sin(1000πt+30°). First, use a cosine function to express v(t). Then, find the angular frequency, the frequency in hertz, the phase angle, the period, and the rms value. Find the power that this voltage delivers to a 50-Ω resistance. Find the first value of time after t=0 that v(t) reaches its peak value. Sketch v(t) to scale versus time. * Denotes that answers are contained in the Student Solutions files. See See Appendix E for more information about accessing the Student Solutions.
A voltage is given by v(t)=50 sin(500πt+120°).. First, use a cosine function to express v(t). Then, find the angular frequency, the frequency in hertz, the phase angle, the period, and the rms value. Find the power that this voltage delivers to a 50-Ω resistance. Find the first value of time after t=0 that v(t) reaches its peak value. Sketch v(t) to scale versus time. * Denotes that answers are contained in the Student Solutions files. See See Appendix E for more information about accessing the Student Solutions.
Exercise 11) Transform the circuit in phasor domain representation2) Determine the value of total impedance, ZT3) Determine the value of total current, IT4) Determine the value of voltage across resistor and capacitor5) Convert in rms values.
A series RLC circuit having values of ? = 250Ω, ? = 3??, and ? = 4?? is shunted across a sinusoidal voltage given by the expression ?(?) =200 sin(200?? − 16°) ?. Look for the following: a. The equivalent impedance of the connection b. The phasor and instantaneous current flowing through the connection c. Draw the phasor diagram of the supply voltage and the total current. What is the phase difference of the two? d. What is the phasor and instantaneous voltage across the capacitor? e. If a 75?? capacitor is shunted across the load, what is now the value of the equivalent impedance in the connection?
At t=−2 ms, a sinusoidal voltage is known to be zero and goingpositive. The voltage is next zero at t=8 ms. It is also known that thevoltage is 80.9 V at t=0.1. What is the frequency of v in hertz?2. What is the expression for v?
A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this impedance is a series combination of a 120Ω resistor and another passive component. If the circuit has a sinusoidal voltage source whose frequency is 120 Hz. What is the value of the component in series with the 120Ω resistor? (Note: Express the value assuming a metric scaling of μ(10-6). Provide your answer in decimal form, up to 3 decimal places.)
Consider the voltage v(t)= 40sin(100πt+140 o ) V. a) Find the period of this voltage in millisecond and the voltage value at t=6 ms. b) This voltage is applied to the circuit below. Find VR , VC and VL phasors and and draw them on the realimaginary axis. Find vR(t) , vC(t) and vL(t) via inverse phasor, comment phase angles. c) Find active, reactive and complex power (P,Q,S) on the inductor.
a) What is the time domain expression for the current? b) If the load impendance is created by an inductor with value L=375 mH, find the phaser voltage Vx? c) If the load impendance is created by a capacitor with value C=16.7 uF, find the phaser voltage Vx?
The frequency of the sinusoidal voltage sourcein the circuit is adjusted until ig is in phase with vg.1. What is the value of ω in radians per second?2. If vg=15 cosωt V (where ω is the frequency found in [a]), what isthe steady-state expression for ig?
The frequency of the source voltage in the circuit isadjusted until vg is in phase with ig. What is the value of ω inradians per second?2. If ig=60 cosωt mA (where ω is the frequency found in [a]), what isthe steady-state expression for vg?
Application of Complex Number to EE (25 pts). Using Ohm’s Law (? = ? × ?), determine the following given a component having an impedance (Z) equation below and a current (I) equation passing through it. ? = (?? ??)^? + (? − ??)^?/? ohms; ? = ? ? amps a. Evaluate and simplify the component’s impedance (Z). Express your answer in polar form and in ohms. Use the principal root value only (if applicable). b. Evaluate and simplify the current (I) passing through the component. Express your answer in polar form and in amperes. c. Using Ohm’s Law (? = ? × ?), determine the voltage (V) across the component. Express your answer in polar form and in volts.
Please answer quickly "To perform phasor addition, its better expressed the phasors in polar form and add all the real compnents and add all the imaginary components separately to get the sum of the phasors." True False "Mathematically, in phase means that the phase angle of two waves are the same and its phase difference is 180." True False The functional transformation of ac electrical parameters from time domain to phasor domain representaion requires to get the RMS value of the electrical parameter and its phase angle to show its polar form representation. True False

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS

Find the time-domain of the following sources: V = 200<0° V and I = 10<45° A Note: In most circuits, the given source (either voltage or current) is in RMS values, so it should noted like "Vrms = 240<0° V". If the case of no denote, assume first the source is in RMS. So when converting it