In a string of two unit suspension insulators, if the insulator voltages are 60% and 40% of theline voltage, respectively, find the ratio of the insulator's own capacitance and the earthcapacitance"y12C₁2 PC₁1121CCV2V₁1

Answered: Image /qna-images/answer/ded01cae-9cfa-4616-99a3-a06b51c924cd.jpg

Answered: , find the ratio

Engineering

Electrical Engineering

, find the ratio

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.29P

See similar textbooks

Related questions

Q: 1. An unbalanced wye connected load whose impedance per phase are given as Zin = 6 + j8N, Z2n = 102…

A: Given:- Z1n=6+j8ΩZ2n=10ΩZ3n=5+j10ΩVL=220 V We have to find the positive sequence component of line…

Q: Q-6) A bank wants to install an alarm system with 3 movement sensors to prevent false alarms…

Q: (10) 1. Find the equivalent resistance between terminals a and b. 9-sh :72 Ja 9b 3-2

A: Given circuit,

Q: How to solve these equations 3 ,4 ,5

Q: a)If the open loop transfer function of a unity negative feedback is given by 45 G(s) = (s +15) (s +…

A: Given: A closed loop system, Open loop transfer function, Gs=45s+15s+1 Unity negative feedback, Hs=1…

Q: 1. The collector-base voltage of a Si transistor is a. None of these b. zero c. 0.7 volts d. 0.3…

Q: The 2G GSM technology uses a carrier separation of a. 1.25 MHz b. 200 KHz c. 30 KHz d. 300 KHz

A: GSM technology: This technology removes the analog system and starts digitalization. So the speed of…

Q: From the circuit shown, if the inputs A and B are both 1, Q3 is/has A) a collector-emitter voltage…

A: The circuit is given as' For A=1 & B=1, Both transistor Q1 and Q2 will be ON. Now, these 2…

Q: 1. Simplify ABC+ĀBC+ABC+ABC 2. Simplify ABCD+ABCD+BCD + ABCD

Q: Find the capacitor voltage at t= 0.5 ms that is associated with the current shown graphically in the…

A: Given: Current through capacitor with respect to time, Capacitance, C=0.71 μF

Q: The minimum spectrum allocation required for W-CDMA is a. 5MHz b. 2MHz c. 500KHz d. 100KHz

A: The solution is provided in the following section.

Q: 5. 85.5J of energy are converted into heat in nine seconds. What power is dissipated? [9.5 W]

A: Given, Energy, E = 85.5 J Time, t = 9 second

Q: The minimum spectrum allocation required for W-CDMA is

A: The correct solution is provided in the following section.

Q: An n-type piece of silicon experiences an electric field equal to 0.2 V/um. Calculate the velocity…

A: Given, A n-type piece of Si experiences An electric field E=0.2 V/μm Mobility, μn=1350 cm2/Vsμp=480…

Q: R₁ 5.0 Ω a R₂ 78 Ω U Τ Εξ Εξ 0.1002 Τη ww 0.50 Ω 1005 Ω h R₂ Μ 40 Ω R₂ - 20 Ω e *0.20 Ω ΣΑ

Q: II. Determine whether or not each of the following signals is periodic. If a signal is periodic,…

Q: A shunt generator running at 1000 r.p.m. has generated e.m.f. as 200 V. If the speed increases to…

A: Given data, Initial speed N1=1000 rpm Initial voltage E1=200 V Now speed is increases to N2=1200 rpm

Q: From the circuit shown, if the inputs A and B are 1 and 0 respectively, Q3 is? in the active region?…

Q: The process of transferring a mobile station from one base station to another is a. MSC b. Roamer c.…

A: What is the process of transferring a mobile station form one base to another

Q: .18. Find Vout in the following circuit: 10 ΚΩ www + 5 V 15 V 40 ΚΩ Vout

Q: VBB 2 V www +₁ RE 1.0 ΚΩ Vcc 10 V

Q: A resistor of 30 is connected in series with a capacitor of 50 µF. Calculate (a) the impedance and…

Q: A bridge consists of the following elements as : Arm AB: A choke coil having a resistance R, and…

Q: a) Find the voltage-gain adjustment for the figure below 56

A: Given:

Q: 4) Let h(t) be the triangular pulse shown in Fig (a) below, and x(t) be the impulse train in Fig.…

A: Convolution is a mathematical operator. It is used to evaluate response of LTI system. It express…

Q: A coil of inductance 320 mH and negligible resistance is connected in series with a 150 resistor to…

A: Given a series RL circuit, Coil Inductance, L=320 mH Resistance, R=150 Ω Supply voltage, Vs=240 V…

Q: 3. For each of the circuits shown in Fig. P5.57, find the labeled node voltages. The NMOS…

A: It is given that: Vtn=0.9 Vkn'WL=1.5mAV2

Q: 6) Consider the following multistage amplifier. Draw the corresponding small signal model. Label,…

A: The small signal equivalent circuit can be obtained by replacing the transistor with its equivalent…

Q: Solve for the voltage drop across the 1H inductor using Thevenin's theorem. 2.5 sin(10t+99) V 2 Ω 31…

Q: ► Write the Boolean equation for each of the logic gate circuits: ▶ A C D 6 (0) D 8 C D (b) D

Q: 4) Let h(t) be the triangular pulse shown in Fig (a) below, and x(t) be the impulse train in Fig.…

Q: 4. The switch has been open for a long time and is closed at t = 0. The circuit parameters are…

Q: Types of analog modulation are:

A: The correct option along with the explanation is provided in the following section.

Q: (a) Calculate the reactance of a coil (XL) of inductance 0.25 H (Henry) when it is connected to a 60…

Q: Find the equivalent resistance of the circuit in the Figure P18.9 3.00 Ω 10.0 Ω www 5,00 £2 www 4.00…

A: Given data, Circuit diagram is given as,

Q: What inductance will give the same reactance as a capacitor of 2 µF when both are at 50 Hz? 5 H 10 H…

A: Given data, Capacitance C=2 μF Frequency f = 50 Hz

Q: Draw the NOR equivalent a) circuit of the expression CD b) c) Draw the NAND equivalent circuit of…

Q: Design a non-inverting amplifier that has a gain of 12. Assume value for Rf then find Ri.

A: The required resistor value for the non inverting amplifier can be obtained by using the expression…

Q: 1. For the circuits (a) through (d) in the figure below (Figure 1). Assume a = 50, and Varl = 0.7…

Q: .R4 320 V1 tr 120V R2 ww 40 R5 -100 Hi R1 20 R3 42 R6 22 V2 -110V

Q: The transistor has a β = 300. The transistor is? A. A switch B. In active region C. In cut-off…

Q: Part 3- Graphing draw a best-fit line through the points, and calculate the slope. Be sure to label…

A: The given data is shown below: The plot of the voltage versus current is shown below:

Q: For the POT in the figure, if Rac= 10K and Rab-44% of the POT rated value, then Rbc equals: MM.…

Q: 330 Ω 1.5 V + 1.5V 560 Ω 2 13 560 Ω 3 14 1000 Ω

A: Given a circuit I1 = ? I4 = ?

Q: An electrical equipment in an office takes a current of 20 A from a 230V supply. The equipment is…

A: Given data, Current is given I = 20 A Voltage V =230 V Time t = 30 hour

Q: Refer to the figure shown, the collector-base voltage of the transistor if β = 140 is

A: Given data, β=140

Q: The values of low cut-off frequency and high cut-off frequency of a band-pass filter are 32 kHz and…

A: Given: For a band pass filter, Lower cutoff frequency, fL=32 kHz Upper cutoff frequency, fH=60 kHz

Q: 3) A 32 - MHz square wave clocks a 5-bit ripple counter. Find the output frequency? A) 1 MHz MHz B)…

A: Given, A 32 - MHz square wave clocks a 5 - bit ripple counter. Input frequency, fin=32 MHz Number of…

Q: The circuit shown in the figure is an example of A.) AND gate b) SPDT electronic switch C) inverter…

Q: An air filled rectangular waveguide of dimension 7 x 3.5 cm² operates in the dominant TE₁0 mode. The…

A: Given: An air filled rectangular waveguide operates in TE10 mode. Dimensions, a×b=7×3.5 cm2…

Question

100%

In a string of two unit suspension insulators, if the insulator voltages are 60% and 40% of the
line voltage, respectively, find the ratio of the insulator's own capacitance and the earth
capacitance
"y
12
C₁2 P
C₁1
12
1
C
C
V2
V₁1

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Solve for the value of the capacitance (in nF unit) if R2 = 1035 ohms and Xc = 2132 ohms. Round your answer to 2 decimal places.
A string of 8 suspension insulators is to be fitted with a grading ring. If the pin to earth capacitances are all equal to C, find the values of line to pin capacitances that would give a uniform voltage distribution over the string.
When this resultant voltage is applied to a circuit consisting of a 10-Ω resistor and a capacitance of 17.3 Ω reactance connected in series, find an expression for the instantaneous value of the current flowing, expressed in the same form
Write the solution
a 3 units suspension insulator, the voltage across the top and middle units are 30% and 32% respectively of the line voltage, find the ratio of capacitance of insulator to that of its capacitance to earth and efficiency of the system.
Q1) Following the system shown below, find if said system is stable or not:
9. If the GMR of the Conductor increases, the Inductance decreases. Select one: True False
In a string of three identical suspension insulator units supporting transmission line conductor.if the self capacitance of each unit is debited as C farads, The capacitance of each connector pin to ground can be taken as 0.1C farad's. If the maximum permissible voltage per unit is given as 20 kva then calculate A.maximum safe working voltage B.string efficiency
A solenoid is to have an inductance of 0.285 mH, a cross-sectional area of 6.00x10-4 m2, and a length of 36.0cm. How many turns per unit length should it have? (Ans. 1.02x103 turns/m) If the self-induced emf is -12.5 mV at a given time, at what rate is the current changing at that instant. (Ans. 43.9 A/s)
4. An aluminum conductor having a cross-sectional area of 1843 MCM is used to transmit power from a high-voltage dc (HVDC) generating station to a large urban center. If the city is 900 km from the generating station, determine the resistance of the conductor at a temperature of 20oC. (Use 1 ft = 0.3048 m.) *Round off to 4 decimal digits.
Please give solution
Mathematics Q11