Find the value of m so that the given function y = xm is a solution of the given differential equation. a. xy" + 2y' = 0 b. x²y" 7xy' + 15y = 0

Q: Use slop deflection method, and draw shear -ce and Bending moment Diagram.

A: there will only be horizontal displacement at B and no vertical displacement. due to the hinged end…

Q: PROB: COMPUTE THE FORCE IN EACH MEMBER OF THE TRUSS Stown In TISE FIGURE USING MOJ. 8kN 24m с 2.4…

A:

Q: Q2: To estimate error ratio in a level instrument, the following reading were taken in meters. If…

A: The formula for the elevation considering curvature and refraction combinedly is: Combined…

Q: A grit chamber of rectangular cross-section is to be designed to remove particles with diameter of…

A: Given data- Diameter of particles d=0.25 mmG=2.70settling velocity Vs=2.5 cm/swidth of chamber…

Q: In a three-phase signal system design for a four-leg intersection, the critical flow ratios. for…

A: Given: Three phase signal system Critical flow ratios  Total lost time in each phase  To find :…

Q: For the footing shown in Figure (1), calculate the immediate settlement for a creep time of (7…

A: Solution: Given: σol=152 kpa t = 7 years Schmertmann method S=C1C2σol∑1NIZihixqci where,…

Q: A right angled triangular notch is used to measure the flow in a flume. If the head measured is 20…

A: Given:Head(H)=20 cm=0.2 mCd=0.62θ=90°Now,Discharge through a right angle triangular notch is given…

Q: With reference to a standard Cartesian (x, y) plane, the parabolic velocity distribution profile of…

A:

Q: The intake of a compressor is 15 psig (pounds per square inch gaugereading). The exhaust has a…

A: Intake pressure=15psig Exhaust pressure=140psig

Q: For the soil profile shown below, the piezometer reading is 1 m above the W.T level calculate the…

A:

Q: Explain linear misclosure traversing?

A:

Q: THE SIONE THE ACTS STEEL IS CONCRETE SLAB IS ALONG USED SLAB 200 mm то SUPPORT IS THAT THICK.…

A: Given Data A concrete slab which is 200 mm thick Width of the slab is 4 m The length of the slab is…

Q: A body moving through still water at 6 m/sec produces a water velocity of 4 m/sec at a point 1 m…

A:

Q: w, determine the beam deflection at point H. A

A:

Q: If Void ratio of soil is 0.334 Determine Porosity of soil

A:

Q: Shown below is a triangular truss with members that are symmetrical with the vertical middle members…

A:

Q: Q-9: How many days would be required by a clay stratum 5 m thick, draining at both ends with…

A: Given data, Thickness of clay stratum= 5m Coefficient of consolidation = 50×10^-⁴cm²/s T50=0.197…

Q: A venturimeter as shown in the figure (not to scale) is connected to measure the flow of water in a…

A:

Q: Five flow table measurements were done for a mortar mix prepared with 1200 grams of Ordinary…

A: Given data: mass of OPC=1200 grams Flow table observations are also given: Sr. No. Water content…

Q: From laboratory investigations, the liquid limit, plastic limit, natural moisture content and flow…

A:

Q: eterm n in t

A: we will divide the section into 4  parts and, then calculate the Moment of inertia of each part and…

Q: The beam shown in the figure below is subject to a moment of M = 10 kN.m as illustrated. Calculate…

A:

Q: express each Fahrenheit scale temperatureas a Rankine scale temperature. 85°F

A: Given values: Temperature in Fahrenheit scale = 85°F

Q: Only answer

A: Given: Target cost=$200MTarget band=$180M to $220MTarget contractor fee=$25MCost saving ratio=70/30…

Q: A body moving through still water at 6 m/sec produces a water velocity of 4 m/sec at a point 1 m…

A:

Q: 4. The distances from the centroid of the shapes in Fig. (1.4) (1 &2) to X and Y axes, (y₁, x₁) are-…

A:

Q: 1. The table below presents the calculated areas of closed contour lines (reservoir) taken by a…

A: Given:-

Q: Question: For a culturable command area of 1000 hectare with intensity of irrigation of 50%, the…

A: Given data- Culturable command area CCA=1000 haIntensity of irrigation I=50%Duty D=2000 ha/cumec25%…

Q: List the steps involved in making elementary traverse computations.

A: Traverse Surveying: It is a popular method of surveying in which a number of survey lines are…

Q: Q2: To estimate error ratio in a level instrument, the following reading were taken in meters. If…

A: Given:R.L. of A=24.60 mDistance between A and B (d)=200 md=0.2 KmWhen the instrument was set up…

Q: Find the initial length of rod if strain value is 0.0003 and change in length value 0.3 mm

A: Given Change in length value = 0.3 mm Strain value = 0.0003 Required Initial length of rod

Q: A venturimeter as shown in the figure (not to scale) is connected to measure the flow of water in a…

A:

Q: Flow rate of a fluid (density = 1000 kg/m³) in a small diameter tube is 800 mm³/s. The length and…

A:

Q: A right angled triangular notch is used to measure the flow in a flume. If the head measured is 20…

A:

Q: Prob. 1.4-13. For the overhanging beam shown in Fig. P1.4-13: (a) determine expressions for the…

A:

Q: 1. The truss has 5 equilateral triangles. 3m on a side (all vertex angles are 60°). With the given…

A: Given data  All vertex angles = 60° Find force in each members and it type (nature of member either…

Q: express each Fahrenheit scale temperatureas a Rankine scale temperature.Express 300K in °F.

A: Given: Temperature = 300 K

Q: beam

A:

Q: A rigid retaining wall of 6 m height (Fig. Ex. 11.11) has two layers of backfill. The top layer to a…

A: Given : Height of retaining wall = 6m Depth of sandy clay = 1.5m  c = 12.15 Kn/m2 gamma = 16.4 Kn/m3…

Q: The measured angles about point P have the following observed values. angle APB = 12°20' angle BPC =…

A: Given,∠APB=12° 20'∠BPC=37° 35'∠CPD=35° 55'andTrue value of ∠APD=87° 10'Now,Measured value of…

Q: The side of a square land was measured as 150 m and is in error by 0.05 m. What is the corresponding…

A: Given data: Side of a square land was measured as 150 m. Error, d(side) = 0.05 m Error in computed…

Q: The top width and the depth of flow in a triangular channel were measured as 4 m and 1 m,…

A:

Q: obtain a relation for the maximum and minimum stresses at the base of a symmetrical column, when it…

A: Given: The base of a symmetrical column is subjected to (a) an eccentric load about one axis, and…

Q: Example (3): Calculate all the member forces for the truss given in the figure below.

A:

Q: Determine the magnitude and direction of the resultant force, F, measured counterclockwise from the…

A: Given :

Q: Draw the shear force and bending moment diagrams for the structure that it shows. Indicate the…

A: Draw FBD of the given beam:

Q: In a stream line steady flow, two points A and B on a stream line are 1 m apart and the flow…

A: Given data- distance s=1 mvelocity-VA=2 m/sVB=5 m/sTo Find-The acceleration of the fluid at B aB

Q: The top width and the depth of flow in a triangular channel were measured as 4 m and 1 m,…

A: Given data- Top width T=4 mDepth D=1 mvelocities at depth of 0.2 m & 0.8 m depth are-0.6 m/s…

Q: the required backwash velocity is

A: Given data: Determine the required backwash velocity? Where, data as follows:  diameter,d= 0.4 mm…

Q: SOLVE for each reactions and kindly DRAW the shear and moment diagram

A: