Find the value of speed of stator
Q: A silicon diode has a saturation current of 5nA at 27˚C. Estimate the IS at 100˚C
A:
Q: For a particular n-channel MOS technology, in which the minimum channel length is 0.2 μm, the associ...
A:
Q: *44. For the network of Fig. 2.188, determine the range of V; that will maintain V at 8 V and not ex...
A:
Q: Calculate the magnitude of the total impedance (rounded to two significant digits) in the following ...
A: In this question we have to find the value of total impedance
Q: R1 L1 C1 2.50 2mH 30µF The voltage applied across 3-branched circuit (shown below) is given by v=100...
A:
Q: dr +7x: dt 5 cos 2t
A:
Q: 2. (A) In a 440 V, 3-phase balanced AC-system, a wattmeter is connected as follows: curren- coil(CC)...
A: The solution is given below
Q: Given zener voltage at 9V, input voltage at 12Vdc to 15Vdc and ILmax at 40mA. What is Rsmax? Choices...
A:
Q: vt v8 4 U8. 3-2
A:
Q: Q11/A 3-phase, 400 V wound rotor motor has a delta-connected stator winding alid Star connected roto...
A:
Q: 100L R. C. way of a fully labelled graph with explanations and any accompanying calculations. Determ...
A:
Q: transmission model interaction model transtion model ? which one of these takes place in our mind wh...
A: The transition model of communication describes communication as a process in which communicators ge...
Q: z² X(z) = (z-0.5)(z-1)²
A:
Q: A 230 kV transmission line has an impedance of 50 cis 78 ohms and a capacitive reactance of 1,200 oh...
A:
Q: Three unequal single-phase loads are connected across the lines of a balanced, 3- phase, 230 volts ...
A:
Q: A capacitor of 3.23µF has an area of 6.35mm^2. Determine the separation distance between the two pla...
A:
Q: Let xịn] be an input of a discrete time linear shift invariant system while its impulse response and...
A: h(n) = ∑K=-∞∞δn-khn = .............δn+5+δn+4............δn+δn-1..........δn-5.....hn = 1 when n is i...
Q: Calculate the currents through and voltages over C1,C2,L1,R1 and R2
A:
Q: 2) What is the simplified signal? [u(t + 2) – u(t – 1)][u(-t + 4) – u(-2t – 2)] a) u(t + 2) – u(t – ...
A:
Q: The characteristic equation of a control system is given as1+ KG (s) H (s) = s + 8s2 + 10s + K = 0, ...
A:
Q: 1. Draw the block diagram of the following circuit, following the state variables X1=iL; X2=Vc
A: The given circuit is shown below:
Q: Problem 1: Calculate the values of Vo1 and Vo2 in volts. 12V 500 N 1 kΩ 5V Vo2 5 ΚΩ 500 2 1 kN
A:
Q: 13.10 Find v, in the circuit of Fig. 13.79. %23 ML 0.5 H 24 cos 2t V 2 H 2 H 0.5 F ell ll
A: Given: Circuit diagram
Q: What voltage is boosted at the output of a multiplier. Choices: average, rms, peak, or instantaneous...
A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the se...
Q: Q4/ A 500 h.p., 3-phase , 440 V, 50 Hz induction motor has a speed of 950 r.p.m. on full-load. The m...
A:
Q: I. CONVERT THE FOLLOWING INTO POLAR and EXPONENTIAL FORM AND PLOT IN AN ARGAND DIAGRAM
A:
Q: PROB. # 2: REFER TO THE GIVEN FIGURE: Compute Ct, Qt, Wt, V1 - V8 and Q1 - Q8. TABULATE YOUR ANSWERS...
A:
Q: Cas Auf te G: 3nf G: Buf HE HE : 240 volts
A: Capacitance and inductance are the energy storage elements which store the energy in the form of rea...
Q: 1. A point charge in an electric field has coordinate of (2, -3, -1). Determine its location in cyli...
A:
Q: Assume that an analog signal is given by a) x(t) = 5 cos(4 × 10³nt) + 3 cos(6 x 10 nt),t 2 0 %3D
A:
Q: . When using superposition, what is the ideal internal resistance of a voltage source? The Thevenin ...
A: De activated sources can be replaced by their internal resistances in super position theorem.
Q: 100-volt electromotive is applied to an RC-series circuit in which the resistance is 200 ohms and th...
A: Given circuit is a series RC circuit excited with dc supply. Since supply is present so it is Chargi...
Q: Find Thevenin's Equivalent Circuit Relative to A and Band Max Power Transfer 2 mA 12V 2 k2 8 mA 1 ka...
A: The solution is given below
Q: the circuit includes a 48-volt power supply and three resistors r1-250 ohms r2= 250 ohms r3=375 ohms...
A:
Q: Given the zener voltage at 9V and the zener power at 1W, what is the range of allowable values of Iz...
A:
Q: A Y All NOR GATES Simplify the following circuit using Boolean Algebra and draw the simplified circu...
A: Kindly see the attached documents for the answer
Q: A magnetic circuit consist of silicon having a cross section of 1.5 sq. m and 0.1 m length and an ai...
A:
Q: The diode (blue line) should be at -10V not -8V
A: The Diode-based circuit can be designed in LTspice by selecting the general diode and changing the m...
Q: A three-phase, 10-hp, 60-Hz, 1600-V, 500 r/min, salient-pole synchronous motor has direct-axis and q...
A:
Q: L1 R1 C1 V1 V2 R2.
A:
Q: Calculate the resistance measured from terminal T to ground in each of the resistance networks of Fi...
A:
Q: 8. Refer to the appendix C. What is the Thevenin equivalent resistance? 16 kOhm 12 kOhm 19 kOhm 2.5 ...
A:
Q: Design astable multivibrator using the following parameters RA= 10kQ, RB= 47kQ and C = 0.01 µF. Calc...
A:
Q: A 4-pole, 50 hz, 3-phase induction motor has a slip-ring rotor with resistance and standstill reacta...
A: Given,f=50HzR2=0.04 ohm/phaseX2=0.2 ohm/phasesfl=0.03TstTmax=2.smTsmT2+1 ......1TfLTmax=smT.sfLsmT2+...
Q: A. If the change in the input voltage of a power supply is around 2V and the change in the output vo...
A: Given that, change in input voltage of a supply = 2V change in output voltage is 50% of that = 50% o...
Q: Rs 220 2 Vz = 10 V = 400 mW 20 V RL FIG. 2.186 Problem 42. *43. a. Design the network of Fig. 2.187 ...
A:
Q: A three-phase, 30-hp, 60-Hz, 1900-V, 500 r/min, salient-pole synchronous motor has direct-axis and q...
A:
Q: 3. If all initial conditions of the networks of Figure P1.3 are zero, find v(t), t 2 0. 12 8 10 (a) ...
A:
Q: Icany, 1). t = 0 4Ω ic E24 V 2 F 2 H
A:
Q: Find Vou(1) given Vin(t) in the op amp circuit that follows. ll Vin@) O Vout(?)
A:
Step by step
Solved in 2 steps with 2 images
- What are the advantages and disadvantages of using the following types of motors? shaded-pole motor PSC motor split-phase motor capacitor-start–capacitor-run motorA three-phase induction motor is supplied with power from a 60-Hz source. At full load the motor speedis 1728 rpm, and at no load the speed is nearly 1800 rpm. At full-load conditions, determine thefollowing:a) Number of polesb) Slipc) Frequency of the rotor voltagesThe synchronous speed of a 3-phase and 6-pole induction motor is 1200 rpm. By keeping the frequency constant, the number of poles of the motor is reduced to 4. Accordingly, which of the following is the rotor speed at 5% slip of the motor?a) 1180rpmb) 1750rpmc) 1690rpmd) 1140rpme) 1710rpm
- A three phase induction motor with supply frequency of 60 Hz , 6 poles. If the slip is 5 % at a certain load, determine (a) the synchronous speed, (b) the speed of the rotor (c) the frequency of the induced e.m.f in the rotor and (d) speed of the induction motor if the slip changes to 6.75 %In In Star-Delta Starting of 3-Phase Induction Motor Why we do not have the motor continue running in its star connection.Sketch the V curve for a synchronous motor. Label the axes. Indicate where the power factor is lagging and where it is leading. Draw the phasor diagram corresponding to the minimum point on the V curve.
- E-a). Which of the following is/are a type of single-phase multi-speed motor? a) consequent-pole motor b) shaded-pole induction motor c) both "a" and "b" d) neither "a" nor "b" E-b). The lower the speed setting, the_________ the impedance of run winding in a single-phase multi-speed motor. a) lower b) higher c) either "a" or "b" d) neither "a" nor "b" E-c)The rotor of a single-phase repulsion motor gets its voltage a) by induction b) direct wired from an external AC source c) direct wired from an external DC source d) all of the above5) A-In general, which of the following is/are a factor that will determine the sync5hronous speed of a 3-phase motor? a) frequency b) number of stator poles per phase c) both "a" and "b" d) neither "a" nor "b" B-Which of the following is the correct formula used to determine the synchronous speed of a 3-phase motor? a) speed = [(120 ÷ frequency)] number of polesb) speed = [(120)( number of poles)] frequencyc) speed = [(120)(frequency)] ÷ number of polesd) none of the above C- How may the direction of rotation of a 3-phase motor be reversed? a) by interchanging any two of the three supply lines b) by interchanging all three of the supply lines c) only by swopping line-1 with line-3 d) none of the aboveSpeed analysis in induction motor
- The voltage applied to the stator of a three phase, 4 pole induction motor has a frequency of 50 Hz. The frequency of the emf induced in the rotor is 1.5 Hz. Determine the speed at which motor is running. (a). 1450 rpm (b). 1455 rpm (c). 1460 rpm (d). 1465 rpmFor a power system having induction motor loads, a normal excited synchronous motor is also attached. The induction motor will now operate at ________ a. leading b. lagging c. reduced power factor d. No change in power factorA 3-phase induction motor runs at almost 3000 rpm at no load and 2960 rpm at full load when supplied with power from a 50 Hz, 3-phase supply. What is the corresponding speed of the rotor field with respect to the rotor? Select one: a. 60 revolution per minute b. 30 revolution per minute c. 50 revolution per minute d. 40 revolution per minute