Find V1, V2 & V3 in the given circuit below using KVL. V. 24v(土 V3 V1 = V2 V2 = V3 = 12V

Q: Write atleast 3 application of PLC in industries.

A: solve ques..

Q: Given the circuit below. i, (t) = v210 cos(377t). Give your answer in four decimal places if it is n...

A: Belief description: For an AC circuit we have 3 types of powers such as real power, reactive and com...

Q: How do you identify the anode of an unmarked diode? When the forward current of a diode increases, i...

A: How do you identify the anode of an unmarked diode? When the forward current of a diode increases, i...

Q: Q2/ Calculate the effective resistance of the following combination of resistances (Req) and the vol...

A: Effective Resistance Effective resistance in series is equal to the sum of the resistance. The recip...

Q: Why is the circuit critically damped? Explain.

A:

Q: Calculate the value of total current for the circuit. Please

A: In this question we will find current flowing through capacitor....

Q: Given: three phase alternator P= 12 poles conductor of each phase in series Wye Connected coil span ...

A:

Q: 2 A signal consists of a fundamental frequency of 500 Hz, and the lowest five harmonics: 1000 Hz, 15...

A: A signal consists of a fundamental frequency of 500 Hz and the lowest five harmonics: 1000 Hz, 1500 ...

Q: Consider the circuit shown in below Figure, Find values of the resistances R1 and R2 that cause the ...

A:

Q: The value of T0 in the following circuit equals: 1kn 3 k2 8 mA 'Io a. 8 mA b. 2 mA

A:

Q: A DC shunt motor develops 15 Hp at 120 Volts. The armature efficiency is 95%. What is the armature e...

A:

Q: In Module 3, you have learned about Op-Amps like Inverting and Non-Inverting Amplifier and many more...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: Explain why Silicon and Germanium are the most common semiconductor materials used in Electronics De...

A:

Q: FIND THE FOLLOWING: e. time constant f. rise time g. settling time

A:

Q: R

A:

Q: The following vectors are given: M=-10ax+4ay-8az and N=8ax+7ay-2az. Find the unit vector in the dire...

A:

Q: Calculate the area of the surface using the differential surface a r = 10, a/4 < o < 2a/3, 0 < ¢ < 2...

A:

Q: Given the following Resistances in Series and Voltage Source: R1 = 8 ohms R2 = 5 ohms R3 = 8 ohms...

A: If the resistors are connected in series then the total resistance is sum of all the resistance. By ...

Q: why low attenuation and are the disadvantages of a conductive cable

A:

Q: A 50 and 100 micro-farad capacitors are connected in series and across a 100 sin (wt + 30 deg) volta...

A:

Q: Find the total Capacitance in the circuit. A 4 µF 6 pF 5 µF * 8 uF :2 pF Ст — *6 µF B 3 uF 10 uF 6uF

A:

Q: Q9. Determine the voltmeter reading in Figure 2, if the 4.7 k (R3) resistor is open. What is the rea...

A: We will replace the voltmeters with the symbols for voltmeter. So, the simplified circuit will look ...

Q: What is the Voltage per Phase? O 4340 Volts O 4430 Volts O 4530 Volts O 4360 Volts

A:

Q: 1.Find I, in the circuit of Figure 1. 4 A 21, 1,4 2Ω 4Ω 8Ω ww

A:

Q: A multiple choice examinations has 200 questions each with 4 possible answers of which only one is c...

A:

Q: IT = P1 = R1 = P2 = R2 = P3 = VI = PT =

A: NOTE: As per Bartleby guidelines for multiple questions , I supposed to do only first one... Thanku ...

Q: resistor of 0.5 ohms is connected in parallel with a 10 millihenry inductor. If the source voltage a...

A:

Q: 4. The silicon whose length is 20 cm is subjected to an electric field of 25 volts. The velocity of ...

A:

Q: U zz (E) (1) 10 2 (4) 28 Q U 91 (2) US USI wwwww ww wwwv 45. Find the equivalent resistance of the c...

A: Given circuit:

Q: In an ideal pn junction with an ideality factor of 1 at T = 300 K, the magnitude of the reverse-bias...

A: Given data, Temperature T = 300 K I=-0.75I0 Ideality factor η=1  Equation of diode current is given ...

Q: FIND THE FOLLOWING: a. impulse response b. step response c. ramp response

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly re...

Q: Q4/ Use Source Conversion technique to find the load current IL in the circuit below. IL R1 R2 R3 V1...

A: The given circuit is shown below:  The 12 volts voltage source with the series resistance of 6 Ohms...

Q: A simple network of RLC circuit is depicted in Figure 1. (i) Derive the differential equations of th...

A: Solve the problem

Q: Given the following find: The reactive power dissipated by the source is (in Vars) The apparent pow...

A:

Q: Why is the circuit under damped? Explain.

A:

Q: M K K GND (a) 田田 山山 CLK J 山 山出 K M (b)

A:

Q: A generating station has a maximum capacity of 100 kW and costs $300,000. The annual fixed charges a...

A: This question belongs to electrical power system. It is about units generated for different load fac...

Q: electric field intensity

A: The electric field intensity Force experienced by a charge having positive unit value at a point is ...

Q: 6 2 in IL R1 R2 R3 V1 12 R4 12 6. 11 RL 6.

A: Source Transformation: By using Ohm’s law a network consists of voltage sources in series with resis...

Q: Laplace transform

A: Laplace transform- Let g(t) be a function and this function is a continuous function with time t the...

Q: How do you identify the anode of an unmarked diode? When the forward current of a diode increases, i...

A: When reading the voltage of the diode, the DMM's negative lead will be linked to the cathode. The di...

Q: A 25-volt electromotive force is applied to an LR series circuit in which the inductance is 0.5 henr...

A: For First order RL circuit with source enabled The calculations are straight forward The response of...

Q: Q3/ Using nodal analysis, find the branch currents in circuit below. V3 12 8 R1 R3 R5 10 V1 12 R2 R4...

A:  Given circuit shown      

Q: In a step-down converter, consider all components to be ideal. Let v, V, be held constant at 5 V by ...

A:

Q: Calculate the Q-point values (IC and VCE) for this circuit *

A: To above question is based on DC analysis of BJT. DC analysis of transistor is done by finding the f...

Q: 2. Apply Ohm's law to the following problems: a. A current of 0.0021 A flows to a resistor having a ...

A:

Q: PROBLEM SOLVING: Solve for what is being asked given the circuit below. Show complete, neat and orde...

A: KIRCHHOFF’S VOLTAGE LAW: Kirchhoff’s voltage law (KVL) states that the algebraic sum of all branc...

Q: A pacemaker has an RC circuit that control the time of voltage giving out. A suitable time constant...

A:

Q: What is the value of a C103 ceramic disk capacitor? (circle all that apply) 10 nF O 10 mF 10,000 pF ...

A: Here, the number of the capacitor is C103

Q: Given: Battery = 3v LED Light = 3v Asked: Measure the voltage of the battery. Measure the voltage ac...

A: LED- Light Emitting Diode. It is a semiconductor device which gives light as output when the current...

Current Division Method

The generalized current divider formula is given by the following relation below,