Find Vca, Vad

Q: 8. Refer to the graphic B. Answer the following question. What is the voltage at point A? 22.5 Volts...

A:

Q: uniform line charge and a uniform sheet charge, both infinite in extent, are located in free space a...

A: We need to find out electric field at given point due to line charge density and surface charge dens...

Q: An infinitely long uniform line charge lies along the x-axis. If the line charge has a density of 12...

A: Use electric field intensity due to infinity line charge to find electric field intensity at point (...

Q: Find the force on a conductor 90 cm long, carrying a current of 2 A and is situated perpendicular to...

A: We know that whenever a current carrying conductor placed in a magnetic field some force exerts on i...

Q: 12. A copper wire of diameter 1 cm had a resistance of 0.15 Q. It was drawn under pressure so that i...

A: Resistance: It is a material that resists the flow of current and its unit is the ohm.

Q: 10Ω 0.05 Η : 10 Ω 5Ω V 400 μF 0.02 Η

A:

Q: resistor

A: Note- “Since you have asked multiple questions, we will solve the first question for you. If you wan...

Q: alaulated m 91 you

A: Diode- Ideally diode is short circuited when forward biased. Ideally diode open circuited when rever...

Q: A coil of resistance 5 ohms and inductance 120 mH in series with a 100 μF capacitor, is connected to...

A:

Q: ) The rading of and 1 kW, 3 " Calculate the active pouer, wattmeters W, ond W are 5kW respectively d...

A:

Q: R3 1k Ohm R4 470 Ohm R2 500 Ohm R1 -10 V 1k Ohm

A:

Q: 3. Four resistances R1, R2, R3, and R4 are connected in shunt against 220 V supply. The resistance a...

A: This is a simple problem based on ohm's law. In shunt connection voltage will constant across all re...

Q: A transformer has a turns ratio of 2.5:1. The primary voltage is 208V the secondary current is 18A w...

A:

Q: 4.87 O Consider the circuit of Fig. P4.39 with R1 = 10k2. The diodes have turn-on voltages of Vf = R...

A: According to the question, for the given as shown below We need to find (a) Smallest value of V1 an...

Q: On a three phase system with voltages greater than 600V the typical color used to designate phase Z(...

A: ORANGE COLOR

Q: A point charge, Q = 40 nC, is located at the origin in cartesian coordinates. Find the electric flux...

A: In this question,  Find the electric flux density D at the point P(-4, 5, -4)  We are solving this p...

Q: 1. What is the nominal resistance of a resistor with the following color rings: Blue, Grey, Orange, ...

A: To find the value of resistance with color coding as Blue, Grey , orange , silver   

Q: 30 R2 9V 20 R3 10

A:

Q: Develop a table showing the speed of magnetic field rotation in ac machine of 2, 4, 6, 8, 10, 12, an...

A:

Q: 9. For the circuit shown, when the switch is open (R, and R. disconnected), V = 15 V. When the switc...

A: In this question,  We need to determine the value of resistance R2 and R4.  If voltage across R2 is ...

Q: What is capacitive touch, and how does it work?

A: Capacitive touch sensing is way of human touch sensing, that required little or no force to activate...

Q: In Ve= ||

A:

Q: Two bulbs of 250W, 230V each are connected across a 200V supply. Calculate the total power drawn fro...

A:

Q: 6.If D= (10/r2)ar nC/m2 find ρv at r=2m

A: D= (10/r2)ar nC/m2  ρv = ?  

Q: Find out the Laplace Transform of the following function: z(1) = e'u(1) -551

A: Using definition of laplace  transform , find the laplace transform of given function.

Q: 2. Total current in a semiconductor is constant and is composed of electron drift current and hole d...

A:

Q: A coil having a resistance of 30 ohms and an inductance L is connected in parallel with a resistor h...

A: This question belongs to circuit theory . It is based on the concept of power consumption in the cir...

Q: Let P be the solution of the Lyapunov equation ATP+ PA = -Q, where A, P,Q E R"X". Show that if = P" ...

A: GIVEN: Lyapunov equation              ATP+PA=-Q SHOW: all eigenvalues of A have negative real parts

Q: 13. Refer to the graphic D. What is the resistance seen by the power supply?

A: The given circuit is shown below:

Q: design a circuit that would be able to shift bits but also store them for a duration of time. explai...

A: A shift register is a form of digital circuit that employs a cascade of flip-flops, with each flip-o...

Q: Problem 184: EE The total inductance of two coils, A and B when connected in series aiding is 0,5 H ...

A: Inductance:-The structure of the electrical circuit in which the electromotive energy is fed into th...

Q: If A = 3a, – ay – az B = –2ar + 4ay – 3az C = ar + 2ay – az find %3D - Match each item to a choice: ...

A: Unit vector parallel to 3A-2B+4C =0.9831ax-0.1735ay-0.0578az IA+B+Cl =7.3485 2A-B+3C = 11ax-2az I3A-...

Q: 2. Generating station at Musandam has the following load cycle. (Refer the data sheet below). Determ...

A: In this question,  We need to determine the maximum load,  Unit generated by per day We know 1kWH= 1...

Q: What is the the value of a resistor without considering its tolerance value percentage?

A: Resistors resist the  electrical flow. Each has a value that tells it to withstand the current flow....

Q: Explain how a revolving field is set up in a 3-phase induction motor.

A:

Q: 2-The function of the impact sign given in the s(t) = rect(t/7) find the power spectral density of t...

A: Given function st=rectT  

Q: (2/2 + i) – i (1+vZi)

A:

Q: Compute the absolute error and relative error  For a number Xa, the number of significant digits is...

A: The solution is given below 

Q: Using 1st approximation what is the value of ID and VD.?

A:

Q: Find its absolute error and relative error in three items 1.1) XT = 2/7 and XA = 0.222 1.2) XT = π...

A: I am giving answer of all 4 parts. 1.1 Absolute error= XA- XT= (.222-(2/7))= -0.06371 Relative error...

Q: Show how to minimize the following logic function using switching algebra. F= AB + ABCD' + ABDE' +A'...

A: In this question,  We need to simply the given logic function.  We know A+1= 1 AA'=0 A+A'=1  

Q: b) With a neat diagram, explain the working of the Geothermal Power Plant

A: Geothermal power station uses the earth's hydrothermal energy to heat and generate electricity. So i...

Q: 5. For the CB amplifier circuit as shown below, calculate the output voltage vout with an input of 2...

A: The solution is given below

Q: For the follower circuit, let transistor Q1 have β = 50 and transistor Q2 have β = 100, and neglect ...

A: Given the circuit, as shown below: For the follower circuit, let transistor Q1 have β = 50 and tran...

Q: 4. (a) IIR filters offer the possibility to achieve magnitude response specifications with a smaller...

A: IIR filter- Infinite Impulse Response filter is called as recursive filter. In this filter the outpu...

Q: Q3.1) In which phase the current ioil (c) the mattmeter is to bel cometed so that the watmetr uill b...

A:

Q: Use the Fourier integral to show that sin 2 dis da

A: We need to use the Fourier integral to show that: ∫0∞sin 2ωωdω=∫0∞sinωω2dω

Q: ri = 2a, + 4ay 5az r2 = ax + 2ay + 3a, Find the unit vector parallel to the resultant of vectors and...

A: We need to find out unit vector of resultant vector .

Q: 5. Given the Ri is (5002, 10002, 1500KO, 20002). i. Solve the voltage V, and current I, flow through...

A:

Q: All diodes are silicon

A: Approximations in diodes-  First approximation Second approximation Third approximation    

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.