Find Vth and Zth ?

Q: A three-phase, 50Hz transmission line with a length of "240" is given. It has values of “27” MVA,…

A: Length of transmission line  l = 240km, Operating frequency f = 50 Hz, MVA Rating S = 27 MVA,…

Q: For a balanced 3-phase system, and under the condition: Z₁ = Z₂=Z3-Zy Z2 prove that: ao bo n Z₁ =…

A: impedances are  Z1 =Z2=Z3 =ZY     and       Za= Zb =Zc =Z∆

Q: Question 1. Please find the equivalent resistance R and the power delivered by the source in the…

A:

Q: A pn junction diode is connected as shown, with V₁ = 10 V, R₁ = 1.3 kN, and R₂ = 3.3 kN. R₁ V₁ R₂ D₁…

A:

Q: (7) Determine Is,Ic,IE, VB,and Vc in the following figure, where Bpc is 48. ww Rc >1.2KQ Vac 14.

A: Circuit diagram is given as,

Q: 4. VLO ORAjX R+jx show that as R changes from zeso to infinity the tip of I traces Circle. What are…

A:

Q: Series and Parallel AC Circuits Exercise 14: Find the total impedance (Z). xoon R60 Xc2001

A: Circuit diagram is given as,

Q: 4. In the following figure, 4-bit asynchronous UP-COUNTER is given. a) Determine total propagation…

A: a) Proportional delay of each flip-flop is 120ns  , The number flipflops =4. then the total…

Q: A square-wave inverter has an RL load with R = 15 Ohms and L= 10 mH. The inverter output frequency…

A: R=15 Ohm L=10 mH f=400 Hz   full wave inverter is a  square wave inverter   Vs = DC source…

Q: A = 1,3 â, + 6,4 à ise over C2 A • l =? (a=3,5) Given Å = 1,3 à, + 6,4 & Finda A • dl=? over C2…

A:

Q: 1. Determine the equivalent resistance between terminals a and b. 1012 M 512 bo W 2012 www 802

A:

Q: Find the output Voltage Vo if diodes are silicon, Is, R1 & R2 are given as: Is 1K m|1 I R1 R2…

A: We need to find out the output voltage for given circuit.

Q: (a) When the switch is closed, the transistor must be driven into saturation, thus applying nearly…

A:

Q: Question 5. The approximate equivalent circuit of a three-phase ∆ /∆ connected 60 Hz, 4000/1000 V…

A: For a 3-phase, delta-delta connected, 60 Hz, 4000/1000 V transformer, the following specifications…

Q: Find the voltage across capacitor Vc(t) for time t>=0 Additionally, find the voltage across the…

A:

Q: (7) Determine IB, IC,IE, VB, and Vc in the following figure, where B DC is 48. 3V N Re 12KQ Rc 1.2K…

A:

Q: For uncontrolled half wave rectifier, R=80ohm, L=0.15H, f=50Hz and Vm=311V. Find the point when the…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: D) Find Break-Out points on Real Axis? E) Find Angle of Departure? F) Find cross Imaginary Axis?

A: For the given system we have to find the break-out point, Angle of departure and point at which the…

Q: (a) Find i, (t) in the circuit below if (t) 50 cos 100t V.

A: For the given circuit the value of io(t) needs to be calculated and the same can be calculated by…

Q: Question A2 15 V ( 8 Ω WITH 200 pF 95 mH Fig A2 2 k

A: Circuit diagram is given as,

Q: 2.641 Ω 289.665 μF m 80 V 60 Hz 6Ω 19.9 mH 221.05 μF 352 10.61 mH Figure #2 a. Determine the…

A: In this question we need to find the following  Determine the apparent power delivered by the 80V…

Q: (d) z4 = j2 *(e) z5 = (2 + j)² (f) z6 = (3 − j2)³

A: As per guidelines i have done three

Q: 1. ⒸbV €2Kr 213.22 Vout LUF a) Find the Thevenin Guivalent circuit of the village source and 2…

A: We need to find out the a) Thevenin equivalent across 2 kohm resistor and capacitor as a load . b)…

Q: (b) Is R1 R2 R3 Is=0.5 A, R1 = 1202, R2 = 189 Figure 1.2 For the circuit shown in Figure 1.2, a…

A: We need to find out the value of unknown resistance for given circuit and power dissipation in the…

Q: 25. A benchmark program is run on a 200 MHz processor. The executed program consists of 1 million…

A: 200 MHz processor, 1 million instruction executions-

Q: The circuit you should use to find the short circuit current, fac, is shown here. Note that the load…

A: The circuit you should use to find the short circuit current, isc , is given in the diagram. Note…

Q: 2. Determine the voltage, VAB. R₁

A: The voltage across the terminal A and B need to be calculated and the same can be calculated by…

Q: Question 6): The PMOS transistor has the following parameters: VTP = -1 V, KP = 1 mA/V², λ=0. Find…

A: We need to find out drain current for given circuit .

Q: A planar optical waveguide of length = 5 cm is fabricated in an epitaxial layer of GaAs that has an…

A: A planar optical waveguide of length =5 cm is fabricated in an epitaxial layer of GaAs that has an…

Q: 10Ω 2 A 452 201 822 ww 3 A Figure #2 20 V- 302 10 V Given the node voltage assignments shown in…

A: Consider the given circuit with branch currents as, To Find: a. Voltage across current sources b.…

Q: Given A = 3,3 ây+8,3 az Find A dl=? over C1 (a=8,8) X a a Z r C1 C2 a y

A:

Q: 2 A Yri 102 Me 552 B (↑)3A a) Selve for VA and VB using nodal analysis. b) Solve for VA and Ve by…

A:

Q: For the following Signal: To1 Toz ◆ Sec. To The ratio between To1 and To2 is Sec. ◆ Sec. x(n) = cos²…

A:

Q: Design op-amp ciran't each produce Even odd to of following outputs. 026=0-42₂ - 10%/₁ ev = 8v₁ - 3…

A:

Q: Assuming an uncharged capacitor in the figure below, use Laplace tranform to find an expression for…

A:

Q: I1 20A ++ Q 8 S1 t=0 R3 20 R2 10 ohms R1 60 ohms C1 40μF

A:

Q: Draw the sign given below. NOTE : Drawings will be made using Matlab

A: Given: A discrete time signal,  x[n]=n[u(n)-u(n-10)]+10e-0.3(n-10)[u(n-10)-u(n-20)], 0≤n≤20; To do:…

Q: Suggest and explain how to improve the electric iron so that it can function effectively and…

A: An electric iron uses a heating element that heats up as electric current passes through it. The…

Q: Plot the root locus for the C.E. of system as 0<K<∞.. K S3 + 3s² + 2s 1+ 0 A) Find the number of…

A:

Q: A power system consists of 10 buses, one Slack, three P.V. buses, and six load buses. Number of…

A: Total number of buses, n = 10 Total number of slack bus = 1 Total number of P.V. buses = 3 Total…

Q: Draw the root-locus graph for the closed loop system given below. Using this graph, maxi-

A:

Q: For controlled half wave rectifier, R=80ohm, f=50Hz and Vm=280V and a=0,2 rad. Calculate the rms…

A: We need to find out the RMS current current for given rectifier.

Q: How do I state and prove the divergence theorem?

A: The divergence theorem, also known as Gauss's theorem or Ostrogradsky's theorem, relates the flow of…

Q: order hold Assume that an input signal is applied to a sample/hold circuit. Draw the outputs of zero…

A:

Q: What are the typical deviations that occur between the most common error signals, and what do these…

A: We need to tell about deviations that occur between the most common error signals, and we also need…

Q: Given a three bit counter implemented with toggle flip flops choose the correct state transition…

A: Write the state transition table for the T flip-flop. Present state Flip-flop input Next…

Q: Q7. Refering to Figure Q7, by using circuit reduction method and basic law's, determine I, V and I₁…

A:

Q: In figure 3, the supply voltage V is_ a. 500V b. 100V c. 200V d. 400V The voltage across LC…

A: In these questions.  We need to choose the correct options As per ohms law, Voltage across the…

Q: Question 4 Figure Q4 shows a message signal m(t) to be angle modulated. If mp = 20v, T = 5 sec, kp =…

A: The given diagram shows a message signal m(t) to be angle modulated. If mp=20v ,T=5sec , kp=2πradv​,…

Q: According to the circuit given in the figure, VT=25mV, |VBE|=0.7V, R1=1487.51Kohm, R2= 7.42Kohm, R3=…

A: According to the given circuit , VT=25mV,  |VBE|=0.7V,  R1=1487.51Kohm,  R2= 7.42Kohm, R3= 6.71Kohm…

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).