Find Z in below figure

Q: Calculate: 22°21'34" + 17.8604 grads+ 0.34645 rad (answer in degrees minutes seconds) a.…

A: Calculate: 22°21'34"+ 17.8604 grads + 0.34645 rad (answer in degrees minutes seconds)O a.…

Q: Problem 2 - Determine the time function corresponding to the following phasors. a) I = 6ej60° A at f…

A: If given the exponential form,Using the Eulers formulaand

Q: Consider Ď = (10xây – 4yây + kzâz ) Hand B = 2ây mT. To satisfy the - Maxwell's equation for region…

A: In this questionWe need to determine the value of K. We know Maxwell equation∇.D= ρv

Q: In the circuit below, Vs = -1 Volts, R₁ = 60, R₂ = 90. Find the Voltage v₁ across R₁. Give you…

A: Circuit diagram is given as,

Q: 1. Solve for Vo in the circuit shown using Thevenin's theorem. Note: make terminals a and bacross…

A:

Q: Exercises: Delta -Wye Conversion Determine I, Vand V₂ + 24V B 100 R1 C 100 R3 100 R2 R5 ww 100Ω D…

A: Given circuit:To determine:Current IVoltage at Node CVoltage at Node D

Q: Example 2.1 A resistor of 1210 N is fed by an AC voltage source with frequency 50 Hz and voltage 220…

A: Given data:Supply voltage Resistance R = 1210 OhmsFrequency f = 50HzTo determine:Active power…

Q: Current and voltage for each resistor

A: we are not allowed to provide handwritten solution.It is given that:

Q: Draw Vout versus Vin for the given values below. Vin · 5 ΚΩ 대 V1 V V www Vout Student numbers from…

A: A comparator is an open loop OP-AMP with two inputs and one output.It compares a signal voltage…

Q: Explain the phase locked loop and its sub components. Also explain where it is used in real life…

A: Explain the phase-locked loop and its sub-components. Also, explain where it is used in real-life…

Q: 4K2 ww IA ↑ IB з кл ← + 15V 2K-1 m 14V Ich

A: From the given circuit, Mesh analysis applies both  KVL and ohms low

Q: A transmission system using a TE10 mode waveguide of dimensions a=5cm,b=3cm,a=5cm,b=3cm is operating…

A: The operating frequency, The dimensions,

Q: 18. The amplifier in Figure 6-54 has a variable gain control, using a 100 2 potentiometer for Re…

A: Potentiometer for  with the wipe ac-ground,The total remain constant to dc,the bias is fixed.To…

Q: it is Rth of the circuit below given that Vocis ss the 2 ohm resistor? = remove the 20 resistance…

A:

Q: A 381 V, 50 Hz, Y-connected, eight poles synchronous generator has the OCC given in tabular form…

A: Terminal voltage, .Supply frequency, .Synchronous reactance, .Armature resistance, .Armature…

Q: A coil having an area 2m² is placed in a magnetic field which changes from 1Wb/m² to 4Wb/m² in an…

A: Cross sectional area of wire Magnetic field is changes from Change in magnetic field Time t = 2 sec.

Q: The amplifier shown below has a variable gain control, using a potentiometer for RE with the wiper…

A: Solution:Given Data:Find :here Find value of

Q: total resistance?

A: It is given that:

Q: The modulating index of an AM-signal is reduced from 0.8 to 0.5. The ratio of the total power in the…

A: It is given that:The modulation index of AM signal is reduced from 0.8 to 0.5 i.e.,

Q: LC H(s) filter. If R=2500 2, C=0,5 μF, L=1 H and input is x(t) = sin(2n425t), find the output y(t).…

A: In this question, We need to choose the correct optionWhat is output of the given function if input…

Q: Z ΧΩ jan O a. Z=120,71-j0,82 ohm O b. Z=125,88 + j0,82 ohm O c. Z=124,71 +0,71 ohm O d. Z=120,71…

A:

Q: Consider the 2nd order system with unity feedback shown below, and determine the value of damping…

A:

Q: 4) A balanced delta connected load of ...+j18 ohm per phase is connected at the end of a three phase…

A: It is given that a balanced delta connected load of  per phase is connected at the end of a…

Q: R(3) E(s) Ks -Rf-K Ki Ra(Js+B)| |Gp=" Kb=5 Y(s)

A: Given Data:Applying the constant values, the block diagram will be,Here To Find:The value of K for…

Q: To $²+8+10 H(s) filter. If R=2500 2, C=0,5 μF, L=1 H and input is x(t) = sin(27425t), find the…

A: In this questionWe need to choose the correct optionWhat is output of the given function if input is…

Q: Ignore the box below. Upload your handwritten question and solution to the Microsoft Teams…

A: Given Data:A second-order LPF with,The transfer function of,Input of,Circuit elements of,Resistor…

Q: A B 0.505 D 6.5n5 (0.15h5 ats Susio ins ins And 2.ons 0.505 0.1sns 0.515 OR 2.015 0.5n5 susir Susio

A:

Q: Problem 9.3 Determine the (a) direction of maximum radiation, (b) directivity, (c) beam solid angle,…

A:

Q: Motor driven by PWM using full-bridge operation provides finer resolution than half-bridge operation

A: Given statement:Motor-driven by PWM using full-bridge operation provides finer resolution than…

Q: The mathematical model of a system is 1y" (t) + 2y' (t) + 1y (t) = 1x' (t) + 2x (t) and the initial…

A: Transfer Function:It is a mathematical representation of the relationship between the input and…

Q: ic 8² +84+C and input is x (t) = sin(275t), find the output y(t). H(s) = = is the transfer function…

A: In this question,  We need to choose the correct option. A transfer function and input signal is…

Q: :C₂ I 03181101 RFIDTS 51011010 031811018 031811018 031211012 031811012 031811018 3191101 931811 0 OA…

A:

Q: Showing its components and drawing equivalent circuit, design your own original 1000 W stand-alone…

A:

Q: 2KR ME IA ч кл m VB+ 4V 5k VA 3K-22 wn Eredinun erous112169d orb 912sq bris Jago 2152 mn 991dT DIGA

A: from the given circuit it is asked to apply the nodal analysis and to find the current IA, voltages…

Q: (a) The per unit value of any electrical quantity is essential in any power system analysis. (1)…

A: (a) The per unit value of any electrical quantity is essential in any power system analysis.Here we…

Q: Problem (1): Section 5.3 Ideal Op Amp 5.8 Obtain v, for each of the op amp circuits in Fig. 5.47. 1…

A:

Q: Activity 2: The amplifier circuit below has a single ac input and one ac output. Assuming 2N2222…

A: 2(a) DC analysis of the amplifier:

Q: 17-11 The thinnest copper wire normally manu- factured has a radius of 4 x 10-5 m. Find the…

A:

Q: 4. For the circuit below: a. Find the total resistance, current, and unknown voltage drops. b.…

A:

Q: Consider the 2nd order system with unity feedback shown below, and determine the value of damping…

A: Open loop transfer function is given as,x= 4, y = 27.

Q: For the circuit given below determine the Thevenin equivalent circuit seen from output terminal and…

A: Given circuit:To determine:Thevenin's equivalent circuit seen from the outputThe maximum power that…

Q: Consider the 2nd order system with unity feedback shown below, and determine the value of damping…

A: Given data:Forward path gain G(s) = Unity feedback systemTo determine:The damping ratio of the…

Q: X(w) r[S(w-14) + 8(w+14)] Find a(t). O a. cos(14t) O b. cos(2pi14t) O c. sin(14t) O d. sin(2pi14t)

A:

Q: Find  Vfb and Vcf

A: In this questionWe need to determine the voltage Vfb  and Vcf  as shown the circuit. We are solving…

Q: ΧΩ M Ζ— j2Ω 1Ω 2Ω Η ΤΩ 202 Soru 1) X=57 olduğuna eşdeğer empedans Z değerini hesaplayınız. Question…

A:

Q: For the 6-variable Layered K-map, write the minimal SOP form for the function F: U,V = 0,1 01 11 WX…

A:

Q: QUESTION 12 An 6.6 kV. three-phase star-connected synchronous motor is working at full load and…

A:

Q: R(S)+ K (S-1) (s+1)(s² + 4) ETT Y(s)

A:

Q: Find Vo.

A: For the given circuit the value of output voltage Vo needs to be calculated and the same can be…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.