Fi'w A stone of weight 62 N is tied to a scale and lowered completely into water. The reading of the scale is 47.9 N. Calculate the volume of the stone. (Pwater = 1000 kg m-³) O 11.20 × 10-3 m³ O 1.44 x 10-3 m³ O 4.88 × 10-3 m³ O 14.10 x 10-3 m3

Fi'w A stone of weight 62 N is tied to a scale and lowered completely into water. The reading of the scale is 47.9 N. Calculate the volume of the stone. (Pwater = 1000 kg m-³) O 11.20 × 10-3 m³ O 1.44 x 10-3 m³ O 4.88 × 10-3 m³ O 14.10 x 10-3 m3

Name: WA stone of weight 62 N is tied to a scale and lowered completely int
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: WA stone of weight 62 N is tied to a scale and lowered completely into water. The reading of the scale is 47.9 N. Calculate the volume of the stone.(Pwater = 1000 kg m-3)O 11.20 x 10-3 m³O 1.44 x 10-3 m³4.88 x 10-3 m³O 14.10 x 10-3 m3

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 74P: A 75.0-kg floats in freshwater 3.00% of his volume above water when his are empty, and 5.00% of his...

See similar textbooks

Similar questions

A table-tennis ball has a diameter of 3.80 cm and average density of 0.084 0 g/cm3. What force is required to hold it completely submerged under water?
What force must exerted on the master cylinder of a hydraulic lift to support the weight of a 2000-kg car (a large car) resting on a second cylinder? The master cylinder has a 2.00-cm diameter and second cylinder has 24.0-cm diameter.
A man has a mass of 80 kg and a density of 955kg/m3 (excluding the air in his lungs). (a) Calculate his volume. (b) Find the buoyant force air exerts on him. (c) What the ratio of the buoyant force to his weight?
What fraction of ice is submerged when it floats in freshwater, given the density of water 0°C is very close to 1000 kg/m3?
A 75.0-kg floats in freshwater 3.00% of his volume above water when his are empty, and 5.00% of his volume above water when his lungs are full. Calculate the volume of air inhales—called his lung capacity—in liters. (b) Does lung volume seem reasonable?
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate be new flow rate for following changes with all other factors remaining the same as in original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid wit 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube used with a 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half length, and pressure difference is increased by factor of 1.50.
Oil having a density of 930 kg/m3 floats on water. A rectangular block of wood 4.00 cm high and with a density of 960 kg/m3 floats partly in the oil and partly in the water. The oil completely covers the block. How far below the interface between the two liquids is the bottom of the block?
A horizontal pipe 10.0 cm in diameter has a smooth reduction to a pipe 5.00 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, at what rate does water flow through the pipes?
What is density of a woman floats in fresh water with 4.00% of her volume above the surface? (This could be measured by placing her in a Wii marks on the side to measure how much water she displaces when floating and when held under water.) (b) What percent of her volume is above surface when she floats in seawater?
A trash compactor can compress its contents to 0.350 times their original volume. Neglecting mass of air expelled, by what factor is the density of be rubbish increased?
Verify that the flow of oil is laminar (barely) for an oil gusher that shoots crude oil 25.0 m into the air through a pipe with a 0.100-m diameter. The vertical pipe is 50 m long. Take the density of the oil to be 900 kg/m3 and its viscosity to be 1.00(N/m2) s (or 1.00Pa s).
The small piston of a hydraulic lift (Fig. P15.6) has a cross-sectional area of 3.00 cm2, and its large piston has a cross-sectional area of 200 cm2. What downward force of magnitude F1 must be applied to the small piston for the lift to raise a load whose weight is Fg = 15.0 kN? Figure P15.6