For a boost converter operating in continuous conduction mode, when the dc input voltage is 10 volts, the load resistance is 1000 ohms, and the duty cycle is 0.5, the average inductor current is approximately equal to ___" 10 miliampere 20 miliampere 40 miliampere 35 miliampere

Q: The functions of Network Layer are: O Logical Addressing, Routing, Path Determination Translation,…

A: This is a problem of data communication and networking. The detailed solution is given in the next…

Q: X 4-10 S/px 06=m H50%=7 W CK=? quality Factor Soukce angulav Fregency w H

A:

Q: Port Determine lo using source transformation and resistance combination. 120V + 2452 102 400 10 €…

A: We will find out current for given circuit by using of source transformation.

Q: If a resistor is dissipating 1/4 W, it can supply 1/4 W to the load. True False

A: Given: A resistor is dissipating 1/4 W

Q: TCP stands for: * Transfer Control Protocol Transmission Control Protocol Transmission Carrier Point…

A:

Q: О N в 9 р.су, О) -> Y

A:

Q: 2.34 The input-output pair shown in Figure P2.34-1 is given for a stable LTI system. LE -1 0 1 xo[n]…

A:

Q: 39 Consider a system with input x[n] and output y[n]. The input-output relation for the system is…

A:

Q: Prior to the formation of the depletion region, electrons were injected to the P type silicon from…

A:

Q: 7. The bode plot of a certain transfer function is given below. From the plot determine; Magnitude…

A: Phase cross frequency is the frequency at which the phase of the system becomes -180°. From the bode…

Q: 2. Minimize the following Boolean functions into product-of-sums form using a K-map a) F(a, b, c) =…

A: We need to find out the simplified product of sum expression for given Boolean function

Q: For the s-domain circuit in figure 1, (a) Compute the admittance Y(s) = I₁(s)/V₁(s). (b) Compute the…

A:

Q: Q1] for the following circuit choose the correct answer Assume that the circuit operates at w= 50…

A: We need to find out the impedance for capacitor .

Q: A 1602 resistor, an 830 inductive reactance, and a 20 capacitive reactance are in series. A 120V…

A: Given data, Resistance R=16 Ω. Inductive reactance, XL=93 Ω Capacitive reactance XC=20 Ω Supply…

Q: Construct a gate circuit using AND, OR, and NOT gates that corresponds one to one with the following…

A: Given expression is F = (WX'+Y)[(W+Z)'+(XYZ')] Logic circuit using AND ,OR & NOT gates =?

Q: Given the equation for current, i (t) = at + b A, calculate the total value of charge in Coulomb…

A:

Q: A 1.2-kW toaster takes roughly 4 minutes to heat four slices of bread. Find the cost of operating…

A:

Q: The current through a 30-k is measured to be 0.5 mA. The conductance is O 30000 S O 15 S O 3.33 x…

A: SOLUTION GIVEN-->                  Resistor R = 30k ohms…

Q: or a uise litude modulated (PAM) transmission of voice signal having maximum frequency equal to fm =…

A:

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

A:

Q: Simplify the following expression to a minimum sum of products. (c) ((A + B')C)'(A + B)(C+ A)'

A: Given Boolean expression F = ((A+B')C)'(A+B)(C+A)' Asked to represent in minimum sum of products

Q: Complete a total table for this capacitor circuit.. (to 3 decimal places) Label all JUNCTIONS 12.0…

A:

Q: 1. Design a clamper to perform the function indicated. Determine the proper value of VDC Calculate…

A: We need to find out DC voltage and swing for given input and output voltage , we need to design the…

Q: 3. Solve for the voltage across R3 and current passing thru R4 using any method. Holl V2 -110V Ra…

A:

Q: Compute for the resistance value. Show your solution

A: Color coding is a method used to identify the value of resistors. The number of the color bands may…

Q: Given the discrete signal below, determine the value of x(-3) x(n) = n-0.5, -3 <n≤ 4 0, otherwise…

A: We need to find out the value of given signal at given value of n

Q: Write a function using the block diagram shown below: X у x' N D f

A:

Q: If we have Const Pie = 3.14, what is the value of this expression: Pie = Pie +1 Pie = 3.14 Pie =…

A:

Q: A transformer supplies power to a feeder that has five customers. Daily maximum demands for these…

A: Given:  Daily Maximum demands: 150kW, 70kW, 120kW, 60kW, 200kW   The maximum demand is150kW…

Q: n a 4*4 Y bus matrix the number of non zero elements are 12. Find the sparsity of the system?

A: Given a 4×4 Y bus matrix. Total number of elements = 4×4=16. Total number of non zero elements = 12.…

Q: ADM system is designed to operate at 3 times the Nyquist rate for a signal with a 3 kHz bandwidth.…

A: Given,The system is designed to operate at 3 times the Nyquist rate.Bandwisth , BW=3 kHzStep-size,…

Q: a: e C D f

A: given are the two AND gates.

Q: Use the Laplace transform to solve the initial value problem. Obtain Y (s) and y (t) 1.-y + 4y = e…

A:

Q: 1) A dc-dc buck converter has a 48 V input. This converter is connected to a dc motor that spins at…

A: Given Buck converter input voltage Vin=48 V   Buck converter output voltage =24 V @ 2000 rpm…

Q: Write Matlab program to calculate the summation, S = [(2x + 5)² x=0 Stop the summation operation…

A: Given: S=∑x=0∞(2x+5)2 stop the operation when S≥100 To do: We have to write the MATLAB program for…

Q: Find the rank of the followng matrix For z1, find the rank of matrix A. A = 1 2 1 1 00 Find z such…

A:

Q: 2. Find Ix.

A: Given- Source current= IS1 = 2A IS2 = 4A Voltage source- V1 = 4 V To find- Current Ix =?

Q: Question 6 Determine 11 in mA.

A: We need to find out the current for given circuit , first we will find out voltage then we will find…

Q: Q4: (answer in phasor form) V = 10 cos 4t b) i=....... Your answer i 592 www 0.1 F +41

A: We need to find out the current for given circuit

Q: 4.27 A 10-kVA, 4160/240-V, single-phase transformer has a per-unit resistance of 0.01 and a per-unit…

A:

Q: 6. The open loop transfer function of a unity feedback system is given by K (s+3)(s+6) Calculate the…

A: We need to find out the phase and magnitude of given transfer function at given frequency

Q: A music signal has frequency components from 15 Hz to 30 kHz. If this signal could be used to…

A: In modulation the characteristics of carrier signal varies according to message signal. The low…

Q: a) The reactance X of inductance L =j/wL O True O False

A:

Q: Q1] for the following circuit choose the correct answer Assume that the circuit operates at @= 50…

A: Given: A network with various elements. To find:  Input impedance, Zin    Note: We'll use series and…

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

A: We need to find out modulation index for given AM signal .

Q: H AAA Source angular Frequency quality Factor скач 101 L=7005 H W = 20 rad 15 4 =10 recelts W

A:

Q: 5. Minimize the following Boolean functions into sum-of products and product-of-sums forms using a…

A:

Q: 2. Design a clamper circuit to perform the function indicated. Vin + t1 Vin -10 V 10 V DESIGN Si…

A: We need to design the given clamper circuit for given input and output voltage. We will design it…

Q: Describe each of the following expressions as SOP, POS, both or neither. Discuss the number of…

A:

Q: What is the function of the one-bit half adder? Exactly how many inputs and outputs are there…

A: One-bit half adder:- A form of combinational logic circuit known as the Half Adder adds two 1-bit…