For a given circuit, A 25-ohm resistor is in series with five resistors in parallel rated at 10, 20, 30, 40 and 50 ohms respectively. The circuit is supplied with 50 VDC. a) Draw the circuit diagram. b) Find the total resistance c) Find the total current d) Find the current and voltage across the resistors.

For a given circuit, A 25-ohm resistor is in series with five resistors in parallel rated at 10, 20, 30, 40 and 50 ohms respectively. The circuit is supplied with 50 VDC. a) Draw the circuit diagram. b) Find the total resistance c) Find the total current d) Find the current and voltage across the resistors.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 11PP: In an R-L parallel circuit, ET=208 volts, R=2.4k, and XL=1.8k. Find IT.

See similar textbooks

Similar questions

In the circuit shown, a 6-Ohm resistor connected in series to a parallel combination of two resistors, one is 30-Ohm and the other is R being unknown. Determine the value of R maximum power transfer. Hint: To maximize power in R, use differentiation
3. Given the network below, find the current through a 12-ohm resistor, power at a 4-ohm resistor, the voltage at a 5-ohm resistor, and current through of 5- ohm resistor.
The circuit diagram shows a system in which 2 sources deliver currents to two load resistors. Determine the nodal equations at nodes 1 and 2 and calculate the voltages across the resistors as well as the branch currents. Itemize your answers on the space provided.
Using mesh analysis, find the voltage and current flowing through each of the resistive elements.And check the results by simplifying the circuit.
Perform the mesh analysis of the following circuit Obtain the currents of each mesh and the resistance power of 200 omhs
Consider the resistive circuit shown below. Find the minimum power/wattage ratings of the resistors if the given circuit is to be constructed.
How many nodes are present in the circuit given below? Mark all the nodes, and identify theessential nodes and the non-essential nodes. Using only Ohm’s Law, KVL, and/or KCL (you cannot use theconcept of equivalent resistance) find the current through all elements in the circuit, find the voltage drops acrossall elements in the circuit, assign polarities to voltage drops across all circuit elements. Find all node voltages.Show that KVL holds true for the loop.
Determine the total resistance and the current flow for the circuit shown in the accompanying figure
Using mesh analysis (format approach), calculate the current and voltage drop through each resistor in the circuit. Label the polarity of the resistors.
Given the circuits below, express the KCL and KVL equations, and solve for the current along and voltage across each resistor using the Branch Current Method and Mesh Current Method.
A 30-volt source battery is connected in series with the 6-load resistors namely 1 ohm, 2 ohms, 3 ohms, R ohms, 5 ohms, and 6 ohms respectively. If the total power is 30 watts, find the value of R in resistance and its current drawn as well as the total resistance (a) provide solution (b) provide circuit diagram
Find the total resistance for the resistor circuit shown below.