Vs 8i

Q: Q2. For the system shown in figure beside; Given that: g:(t) 91(t) = 10 * I () G2) = 1 x(t) y(t) H:(...

A:

Q: Q-4: By using mathimatical approach, find lpg. Vešq and Vsp for the circuit of the figure shown, whe...

A: Using the mathematically approach,  Find the IDQ , VGSQ , VSD   Given data IDSS = 8mA & Vp = -8V...

Q: Practice Problem 2. Find vy and oy in the circuit shown in Fig. 243. Also calculate s and iz and the...

A:

Q: Given R1=1k and R2=10k, what is C so that |Vout/Vin|=0.1 when the frequency of Vin is 3322 Hz? R2 Vi...

A: This is Inverted Op amplifier , Resistance R1=1K, R2= 10K then value of capacitance C if frequency f...

Q: Using Noda analysis method, calculate the current la and 13 for the circuit shown. * أجب على السؤال ...

A: Nodal analysis uses Kirchhoff's current law and ohm's law. The detailed solution is attached with.

Q: 2- Use mesh analysis, determine the current of figure below. R3 92 -12V 4 A E 20 V Ans. I1=3.33A, I,...

A:

Q: For amplifier Circuit #2 above, the input voltage V i n =  0.051  V .

A: For an ideal opamp voltage at inverting terminal is same as voltage at non inverting terminal. So fo...

Q: Q2: For the system shown in figure (2) with derivative feedback. (1) Determine the value of (K, and ...

A:

Q: Q1. The following data refer to the O.C.C of a D.C separately excited generator at 1000 rpm. Field c...

A: Occ graph of given data at 1000rpm, here Rsh line is Rsh=200ohms. From this graph we are find the no...

Q: Design an inverting amplifier to provide a closed-loop voltage gain of Ay = -22 V/V. The maximum inp...

A:

Q: an expression for y*(s). R(s) E(s)_ E•(s) U(s) U(s) C(s) Y (s) Ys) G(s) T. H(s)

A: C(S) H(S) G(S)

Q: Find output voltage from the difference amplifier circuit shown in the figure given the two known in...

A: For an ideal op amp voltage at two terminals is same , current entering the terminals of op amp is z...

Q: 035 The electric field of finite line charge is defined as E = [sin 0,-sin 0,\P Απε,ρ as in the figu...

A:

Q: Practice Problem 2.12 Find v, and v, in the circuit shown in Fig. 2.43. Also calculate and iz and th...

A:

Q: , find (a) i,, (b) v, For the circuit shown in Fig.2 (c) iz, and (d) the power supplied by the volta...

A:

Q: QI) 1- Charge is flowing through a conductor at the rate of 180 C/min. If 450J of clectrical energy ...

A: Dear, as per company guidelines we can answer only one question at a time, kindly post other questio...

Q: g() Q1: For the signal g(t), shown in figure beside. 1 i) Find Fourier Transform G(w) ii) Sketch amp...

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,...

Q: Q For the combinational circuit given in the figure: () Determine the output expression Y. (i) Simpl...

A: A circuit is combinational of OR, AND and NOT gate.  Find the output expression of y?  Using the Boo...

Q: Q1: A 400 kV 3-phase bundled conductor line with two sub-conductors per phase has a horizontal confi...

A:

Q: A unit vector along a particular vector is a vector whose magnitude is: a. -1 O b. 0 O c. the magnit...

A: A unit vector along a particular vector is the have magnitude 1 because  If ax is the unit vector al...

Q: D4 A dipole of moment p = 6a, nC • m is located at the origin in free space. (a) Find V at P(r = 4,0...

A: We will use expression for voltage to find voltage. Electric field E= nagative gradient if voltage.

Q: obtain Z-trans form Por the followings XCS) SCS+1)

A:

Q: Find the equivalent resistance Rab in the circuit shown below. 3302 a m క Slou2 4002 2322 6OUL in 20...

A:

Q: Q1: For the signal x(t), shown in figure beside. I (t) i) Find Fourier Transform X(w) A ii) Sketch a...

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question s...

Q: Electrical power

A: given  n=3 n is no. of discs η=85% V1+V2+V3=33kV V2=6.08kV η=V1+V2+V3n×V3×100%  

Q: A 3-phase, 60 Hz, 45 km long overhead line supplies 500 kW at 11 kV, 0.6 p.f. lagging. The line resi...

A:

Q: Q. For the combinational circuit given in the figure: (i) Determine the output expression Y. (ii) Si...

A: This circuit is combinational of OR, NOT and AND gate.  Find the expression of y?  Some boolean Alge...

Q: Electrical Engineering Question

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question s...

Q: Solution needed

A: This ac network is combination of RLC.  Supply frequency 50Hz Find the current io  , i1  and i2   He...

Q: 1-Determine Ver and VCB. 2- What happens to the voltage Ve if the resistor Rp is open? 3- What might...

A: Dear student as per our guidelines we are supposed to solve only one question in which it should con...

Q: ,find (a) i,, (b) v, For the circuit shown in Fig.2 (c) iz, and (d) the power supplied by the voltag...

A:

Q: The following voltages are measured: va = 1.002 V, v, = 1.000 V. Find voltages versus circuit ground...

A:

Q: btain rise time, peak time, and settling time. nd the steady state error when the input ( r(t) =1+0....

A: In this question , we have to find out k..Rise time, peak time,  settling time..And steady state err...

Q: Q2: For BCD code perform the following, with and without compleme 1. 1000010110 is subtracted from 1...

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Ql: find the value of different voltages that can be obtained from a 12-V battery (Vaa. Vac. Ven Vac...

A: The solution can be achieved as follows.

Q: state if it is zero or infinite  An ideal op amp has common-mode gain that is: An ideal op amp has...

A: Here ideal op-amp statements are given and we have to find if it is zero or infinite

Q: 1. In a 3-phase overhead system, each line is suspended by a string of 3 insulators. The voltage acr...

A: The solution can be achieved as follows.

Q: The magnetization curve of a D.C generator has the following points, all taken at (1200) r.p.m: Ir (...

A: For the given magnetization curve data following are determined 

Q: Q1: For the signal g(t), shown in figure beside. st) i) Find Fourier Transform G(w) ii) Sketch ampli...

A: First present the above signal :-  x(t) = 4.u(t) - 2.u(t-1) -2.u(t-1)  Now find the Fourier transfor...

Q: Q1 Determine the moment of the force about point O. 600 lb 0.5 ft 20 Answer/ 2489 lb.ft 5 ft 30

A: length 5ft breadth 0.5 ft 600 lb is force applied

Q: Q2 / In circuit switching network, mention the available paths to go from node A to node B, then cho...

A: Given circuit switching network is as shown :  

Q: Q. For the combinational circuit given in the figure: (i) Determine the output expression Y. (ii) Si...

A:

Q: For the circuit shown in Fig. 245, find: (a) b and os, (b) the power dissipated in the 3-kfl and 20-...

A: We will apply kcl to v2 then by voltage divider rule to get v1.

Q: 7) The flux per pole of a four-pole generator is 0.05 wb. It driven at speed of 1500 rpm. In order t...

A: The solution can be achieved as follows.

Q: The following data refer to the O.C.C of a D.C separately excited generator at 1000 rpm. Field curre...

A: A separately excited DC generator while running at 1000 rpm its open-circuit test is performed with ...

Q: 3) y[n]=2y(n-1)+x(n+2)H.W.

A:

Q: Problem 11 Given the forward-path transfer function of a unity feedback control systems, K(s+4)(s+ 2...

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,...

Q: Q2. For the system shown below; Given that: 91(t) = 8(t) 92(t) = 5 [I () H2(f) = II 10- 40000, i. Sk...

A:

Q: An RLC parallel circuit has an applied voltage of 208 V. R = 68 Ω, XL = 87 Ω, and XC = 81 Ω. What is...

A:

Q: Practice: 5.2 Find the voltages at the three nonreference 3C 10 A

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.